, One. ^smi-donciucto'i TELEPHONE: (973) 376-2922 20 STERN AVE. SPRINGFIELD, NEW JERSEY 07081 (212) 227-6005 FAX: (973) 376-8960 U.S.A. 2N5952 N-Channel RF Ampifier • This device is designed primarily for electronic switching applications such as low on resistance analog switching. • Sourced from process 50. Absolute Maximum Ratings * Tc=25 C unless otherwise noted Symbol Parameter Drain-Gate Voltage Gate-Source Voltage VDG VGS IGF Tj, TSTG Forward Gate Current Operating and Storage Junction Temperature Range Value Units 30 -30 10 V V mA 'C -55- +150 • These ratings are limiting values above which the serviceability of any semiconductor device may be impaired. NOTES: 1. These ratings are based on a maximum junction temperature of 150 degrees C. 2. These are steady state limits. The factory should be consulted on applications involving pulsed or low duty cycle operations. Electrical Characteristics T,-=25 C unless otherwise noted Parameter Symbol Off Characteristics Gate-Source Breakdown Voltage V(8R)GSS Gate Reverse Current Gate-Source Cutoff Voltage Vos(off) On Characteristics bss Zero-Gate Voltage Drain Current * IDSS Small Signal Characteristics Forward Transfer Conductance 9fs Output Conductance 9 Input Capacitance c,55 Reverse Transfer Capacitance Crss Noise Figure NF 05 Test Condition VDS = 0, lG=-1.0|iA VGS = -15V,VDS = 0 VDS = 15V, !D = 100nA VDS = 15V,VGS = 0 VDS = 15V,VGS = 0 , f = 1.0kHz VDS = 15V, VGS = 0, f = 100MHz VDS = 15V, VGS = 0, f = 1 ,0MHz VDS = 15V, VGS = 0, f = 1.0MHz VDS = 15V, RG = 1.0kii, f = 1.0kHz Min. Typ. Max. -30 Units V -1.3 -1.0 -3.5 nA V 4.0 | 3.0 mA 6500 ^mhos (imhos 2000 75 6.0 2.0 2.0 PF PF dB • Pulse Test: Pulse Width < 300ms, Duty Cycle < 1.0% Thermal Characteristics T A =25c unless otherwise noted Symbol PD RBJC RflJA Parameter Total Device Dissipation Derate above 25°C Thermal Resistance, Junction to Case Thermal Resistance, Junction to Ambient 125 Units mW mW/'C 'C/W 357 C/W Max. 350 2.8 NJ Semi-Conductors reserves the right to change test conditions, parameters limits and package dimensions without notice information furnished by NJ Semi-Conductors is believed to be both accurate and reliable at the time of going to press. However NJ Semi-Conductors assumes no responsibility for any errors or omissions discovered in its use. NJ Semi-Conductors encourages customers to verify that datasheets are current before placing orders. Quality Semi-Conductors TO-92 . Ka +0.25 4.58-0 15 ~T x' > V ' > s] « o * 1 0.46 ±0,10 § o +1 S •* 1 .27TYP [1 .27 ±0.20] T ' 3.60 ±0 20 1 .27TYP [1 .27 ±0.20]