Xeon 1 Power Warm White LED OSM5XNE1E1E VER C.2 ■Features ■Outline ● Highest Luminous Flux ● Super Energy Efficiency ● Long Lifetime Operation ● Superior ESD protection ● Superior UV Resistance Dimension 3.6 BackView ■Applications ● Read lights (car, bus, aircraft) ● Portable (flashlight, bicycle) ● Bollards / Security / Garden ● Traffic signaling / Beacons ● In door / Out door Commercial lights ● Automotive Ext Anode ESD Protection Diode Unit:mm Tolerance:±0.30mm ■Absolute Maximum Rating Item (Ta=25℃) ■Directivity Symbol Value Unit DC Forward Current IF 400 mA Pulse Forward Current* IFP 500 mA Reverse Voltage VR 5 V Power Dissipation PD 1600 mW Operating Temperature Topr -30 ~ +85 ℃ Storage Temperature Tstg -40~ +100 ℃ Lead Soldering Temperature Tsol 260℃/5sec - 0 Duty ratio max 1/10 ■Electrical -Optical Characteristics ■Forward Operating Current (DC) (Ta=25℃) Item Symbol Condition Min. Typ. Max. Unit DC Forward Voltage VF IF=350mA 3.0 3.3 4.0 V DC Reverse Current IR VR=5V - - 10 µA Luminous Flux Φv IF=350mA 100 110 - lm Color Temperature CCT IF=350mA - 3000 - K Chromaticity x IF=350mA - 0.45 - - Coordinates* y IF=350mA - 0.41 - - 2θ1/2 IF=350mA - 140 - deg 50% Power Angle 0 400 Forward Current, IF (mA) *Pulse width Max.10ms Cathode 350 300 250 200 150 100 50 RJ-A=60 /W RJ-A=50 /W RJ-A=40 /W RJ-A=30 /W 0 0 25 50 100 75 Ambient Temperature, TA ( ) Note: Don’t drive at rated current more than 5s without heat sink for Xeon 1 emitter series. LED & Application Technologies http://www.optosupply.com VER C.0 125 Xeon 1 Power Warm White LED OSM5XNE1E1E VER C.2 ■ Soldering Heat Reliability (DIP): Reflow soldering Profile · Reflow soldering should not be done more than two times. · When soldering, do not put stress on the LEDs during heating. · After soldering, do not warp the circuit board. · Repairing should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering iron should be used. It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing. Solder Average ramp-up rate = 3ºC/sec. max. Preheat temperature: 150º~180ºC Preheat time = 120 sec. max. Ramp-down rate = 6ºC/sec. max. Peak temperature = 220ºC max. Time within 3ºC of actual peak temperature = 25 sec. max. Duration above 200ºC is 40 sec. max. LED & Application Technologies http://www.optosupply.com VER C.0