PRODUCT DATASHEET ET-9RG REAL-TIME-RING™ ETHERNET SWITCH WITH GIGABIT The ET-9RG is a 9 port industrial Ethernet switch including 3 Gigabit ports. It features SIXNET’s RealTime-Ring™ which provides very fast, fault-tolerant network redundancy and prioritized message delivery needed in critical real-time systems. These Rings selfconfigure and just run, without the complex configuration steps required by alternative solutions. This advanced technology delivers reliability and performance, saves you money, and makes your job easier. PRODUCT HIGHLIGHTS 9 ports including 3 gigabit ports Super fast, fault tolerant ring redundancy Pre-configured for plug and play simplicity Truly rugged design with -40 to 85°C operation THREE GIGABIT PORTS One auto-detecting 10/100/1000 RJ45 port Two flexible Gigabit ports for fiber or copper Gigabit fiber connections up to 70+ km IDEAL FOR Real-time control Distributed systems Outdoor / marine use REAL-TIME FAULT-TOLERANT RINGS Recovery time of 30 mS plus 5 mS per hop Ideal for deterministic systems and PLCs Real-time Modbus over Ethernet monitoring REAL-TIME TRAFFIC PRIORITIZATION Assure delivery of real-time data Improve network utilization User settable priority assignments MANAGED SWITCH FEATURES User configurable port settings Port mirroring for traffic diagnostics Message filtering to prevent broadcast storms TROUBLE FREE OPERATION Firmware upgrades are FREE forever Ultra-reliable 1,000,000 hours MTBF -40 to +85 °C operating range Dual power inputs with superior spike protection UL/CSA (CUL), CE, and Hazloc (Zone 2) rated SOLUTIONS FOR YOUR INDUSTRIAL NETWORKING CHALLENGES WWW.SIXNET.COM REAL-TIME-RING™ SWITCH WITH GIGABIT SPECIFICATIONS ETHERNET PERFORMANCE 9 Ethernet ports including Gigabit Ethernet switch type: Intelligent store & forward Ethernet protocols supported: All IEEE 802.3 RJ45 ports 1 – 6 (shielded): 10/100BaseTX RJ45 port 7 (shielded): 10/100/1000BaseTX RJ45 ports 8 and 9: 10/100/1000BaseTX (-1 model) RJ45 port speed: Auto-negotiation RJ45 MDI/MDIX: Auto-crossover RJ45 TD and RD polarity: Auto-polarity SFP ports 8 and 9 (pluggable): Fiber or RJ45 depending on module Fiber optic port speed: 1000 Mbps Fiber optic port wavelength: 850, 1310 or 1550 nm center Fiber multimode (mm): 50-62.5/125 um (LC connector) Fiber singlemode (sm): 9-10/125 um (LC connector) Fiber max. distance (full duplex): 0.5 km (mm), 10 km (sm) or more Typical latency (varies on load and settings) 10 Mbps ports: 16 us + frame time 100 Mbps ports: 5 us + frame time Full or half duplex operation: Configurable MAC addresses supported: 8192 Memory bandwidth: 32 Gbps Ethernet isolation: 1500 VRMS 1 minute STATUS REPORTING Modbus Ethernet over UDP “OK” contact output up to 0.5 Amp REAL-TIME-RING™ FEATURES Maximum switches in ring: 50+ Dual ring support Link loss recovery time: 30mS + 5mS/hop ET-9RG ETHERNET COMPLIANCE IEEE 802.3z (Gigabit 1000 Mbps Ethernet connections) IEEE 802.3u (Fast Ethernet 100 Mbps for newer devices) IEEE 802.3 (10 Mbps Ethernet supports legacy devices) IEEE 802.3x (Full-Duplex with Flow Control) IEEE 802.1p (QoS / CoS – Quality & Class of Service) POWER INPUT Input power: 8.0 W (typical with all ports active) Power input voltage: 10-30 VDC Transient protection: 15,000 watts peak Spike Protection: 5,000 watts (10x for 10 uS) ENVIRONMENTAL Operating temperature range: -40 to +85 °C Storage temperature range: -40 to +85 °C Humidity (non-condensing): 5 to 95% RH Vibration: IEC60068-2-6 STANDARDS COMPLIANCE Electrical safety: UL508/CSA C22.2/14; EN61010-1, CE EMC: FCC Part 15, ICES-003; EN61000-6-2/4, CE Hazardous locations: UL1604/CSA C22.2/213 (Class I, Div. 2); EN60079-15 (Zone 2, Category 3), CE (ATEX) Maritime: Designed for marine & offshore per ABS Eye safety (fiber models) IEC60825-1, Class 1; FDA 21 CFR 1040.10 and 1040.11 PHYSICAL DIN rail or direct panel mounting Case: UL 94V-0 Lexan & rust-free aluminum with IP30 protection Dimensions: see mechanical drawing MECHANICAL DRAWING All specifications are subject to change. Consult factory for latest info. ORDER GUIDE ET-9RG-1-D1 6 10/100; 3 gigabit RJ45 ports ET-9RG-F-D1 6 10/100; 1 10/100/100; 2 SFP ports GMFIBER-SFP-500 Multimode, 850 VCSEL, LC, 550 m GMFIBER-SFP-2K Multimode 1310 FP, LC 2 km * (special) GSFIBER-SFP-10K Singlemode 1310 FP, LC, 10 km GSFIBER-SFP-30K Singlemode 1310 FP, LC, 30 km (special) GSFIBER-SFP-50K Singlemode 1550 DFB, LC 50 km (special) GSFIBER-SFP-80K Singlemode 1550 DFB, LC, 80 km (special) Contact SIXNET for special application transceivers. SIXNET Technology Park 331 Ushers Road • Ballston Lake, NY 12019 • USA 1.518.877.5173 • Fax 1.518.877.8346 • [email protected] SOLUTIONS FOR YOUR INDUSTRIAL NETWORKING CHALLENGES Datasheet ET-9RG Rev. April 15, 2009 WWW.SIXNET.COM