HS103DR Series • 55 amp AC output @ 40°C • Single Channel or 3 Phase output • 3 to 32 VDC input control voltage • DIN Rail mounted • UL, CSA, VDE, CE approved SSRs PRODUCT SELECTION Description 3-32 VDC Control 55 A HS103DR-D53TP50D OUTPUT SPECIFICATIONS (1) Description Operating Voltage (47-63Hz) [Vrms] Transient Overvoltage [Vpk] Maximum Off-State Leakage Current @ Rated Voltage [mArms] Minimum Off-State dv/dt @ Maximum Rated Voltage [V/µsec] (2) Maximum Load Current [Arms] Minimum Load Current [Arms] Maximum Surge Current (16.6ms) [Apk] Maximum On-State Voltage Drop @ Rated Current [Vpk] Maximum I²t for Fusing (8.3 msec) [A² sec] Minimum Power Factor (with Maximum Load) HS103DR-D53TP50D 48-530 1200 10 500 55 0.05 250 1.6 260 0.5 INPUT SPECIFICATIONS (1) Description Control Voltage Range Minimum Turn-On Voltage Minimum Turn-Off Voltage Maximum Reverse Voltage Typical Input Current Nominal Input Impeadance Maximum Turn-On Time [msec] Maximum Turn-Off Time [msec] HS103DR-D53TP50D 3-32 VDC 3.0 VDC 1.0 VDC 32 VDC 10 mA @ 5 VDC 450 Ohms 1/2 Cycle 1/2 Cycle GENERAL SPECIFICATIONS Description Dielectric Strength, Input/Output/Base (50/60Hz) Minimum Insulation Resistance (@ 500 V DC) Maximum Capacitance, Input/Output Ambient Operating Temperature Range Ambient Storage Temperature Range Status Indicator Display Weight (typical) Encapsulation Recommended 6-32 Screw Torque Range: Recommended 8-32 Screw Torque Range: Thermal pad installed GENERAL NOTES 1) All parameters at 25°C unless otherwise specified. 2) Off-State dv/dt test method per EIA/NARM standard RS-443, paragraph 13.11.1 HS103DR-D53TP50D 4000 Vrms 109 Ohms 10 pF -40 to 80˚C -40 to 125°C None 1.84 lb (859g) Themally Conductive Epoxy 8-10 in/lbs. (Screws dry without grease) 15-20 in/lbs. (Screws dry without grease) Yes MECHANICAL SPECIFICATIONS THERMAL DERATE INFORMATION AGENCY APPROVALS Designed in accordance with the requirements of IEC 62314 Agency approvals are for relay only. E116950 LR81689 5941 UG Rev. 110811 ANNEX - ENVIROMENTAL INFORMATION