DTA100A-H SERIES Class I, With Active PFC 100 Watt, Single Output AC/DC Desktop Switching Adaptor Rev D FEATURES • • • • • • • • • • Class I Single Output RoHS Compliant Active PFC Function AC Inlet: IEC-320-C14 Inlet 100% Hi-Pot and Burn-In Tested 90~264VAC Input Voltage Range Safety Approvals, EMC Compliance CEC/ Energy Star Level VI Compliant Over Voltage, Over Load, and Short Circuit Protected DESCRIPTION Size: 6.69in x 3.35in x 1.73in (170mm x 85mm x 44mm) The DTA100A-H series consists of 100W, grounded, single phase, switching adapters with active PFC function. These supplies have a single output, an input voltage range of 90~264VAC, and an IEC-320-C14 AC inlet connector. These supplies are also protected against over load, over voltage, and short circuit conditions. In addition, the DTA100A-H series complies with worldwide safety requirements and electromagnetic compatibility requirements and meets EMC, CEC/ Energy Star Level VI, and RoHS requirements for desktop switching adapters. This series has been 100% burn-in and hi-pot tested. MODEL SELECTION TABLE Model Number DTA-100A-1Y120H DTA-100A-1Y160H DTA-100A-1Y190H DTA-100A-1Y240H DTA-100A-1Y360H DTA-100A-1Y480H Input Voltage Range 90~264VAC Output Voltage(1) 12VDC 16VDC 19VDC 24VDC 36VDC 48VDC Output Current 8.34A 6.25A 5.27A 4.17A 2.78A 2.09A Ripple & Noise(2) 240mVp-p 320mVp-p 380mVp-p 480mVp-p 480mVp-p 480mVp-p Output Power 100W 100W 100W 100W 100W 100W Efficiency Level VI VI VI VI VI VI SPECIFICATIONS All specifications are based on 25°C, Nominal Input Voltage, and Maximum Output Current unless otherwise noted. We reserve the right to change specifications based on technological advances. SPECIFICATION TEST CONDITIONS INPUT SPECIFICATIONS Input Voltage Range Input Frequency Min 90 47 @90VAC @264VAC max. @115VAC @230VAC cold start @25ºC Input Current (rms) Inrush Current Output Power Output Current Ripple & Noise (20MHz bandwidth)(2) Hold-Up Time PROTECTION Short Circuit Protection Over Load Protection Over Voltage Protection ENVIRONMENTAL SPECIFICATIONS Operating Temperature Storage Temperature Humidity MTBF GENERAL SPECIFICATIONS Efficiency Unit 264 63 VAC Hz A 75 150 See Table ±5 ±3 See Table See Table See Table >16 DTA-100A-1Y120H, DTA100A-1Y160H, DTA100A-1Y190H DTA-100A-1Y240H, DTA100A-1Y360H, DTA100A-1Y480H @Full Load, 115VAC A % ms Auto-Recovery Auto-Recovery Shutdown and Latch Off, AC Recycle Non-condensing @FL and 25ºC ambient temperature 0 -10 20 For 4 Seconds Isolation Resistance 500VDC Power Factor @115VAC @230VAC @Full Load Primary to Secondary Primary to Frame Ground Primary to Secondary Primary to Frame Ground 40 85 90 ºC ºC % hrs 89 % >80,000 @Average Load, 115/230VAC Dielectric Withstand Voltage 4242 2121 20 20 0.95 0.90 No Load Power Consumption 2/5/2016 Max 2.5 1.25 OUTPUT SPECIFICATIONS Output Voltage Output Voltage Regulation Typ Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] VDC MΩ 150 mW Page 1 of 3 DTA100A-H SERIES Class I, With Active PFC 100 Watt, Single Output AC/DC Desktop Switching Adaptor Rev D SPECIFICATIONS All specifications are based on 25°C, Nominal Input Voltage, and Maximum Output Current unless otherwise noted. We reserve the right to change specifications based on technological advances. SPECIFICATION TEST CONDITIONS Min PHYSICAL SPECIFICATIONS Weight Typ Max Unit 1.72 lbs (0.78kg) 6.69 x 3.35 x 1.73 in (170 x 85 x 44mm) IEC-320-C14 Plastic Dimensions (L x W x H) AC Inlet Case Material SAFETY & EMC CHARACTERISTICS UL 60950-1 CSA C22-2-No. 60950-1 TUV EN60950-1 CB IEC 60950-11 FCC CISPR22 EN55022 CE Safety Standards EMI Standards Class B Class B Class B NOTES (1) (2) (3) Other output voltages are available: 100W for 12~26VDC, 33~39VDC, and 44~52VDC. Please call factory for ordering details. Ripple and noise are measured at oscilloscope 20MHz bandwidth by a 10uF electrolytic capacitor and a 0.1uF ceramic capacitor in parallel at output connector. Due to advances in technology, specifications subject to change without notice. MECHANICAL DRAWINGS Drawing Note: 1. AC Inlet: IEC320-C14 2. Plastic Case Color: Black 3. Tolerance: ±0.5mm 4. Unit: mm STANDARD OUTPUT CABLE 1. 2. 3. 2/5/2016 AWM 1571 #14 AWG/1C + SHIELDING, UL 80ºC 30V VW-1, 1050 mm. (12-24V) AWM 1185 #16 AWG/1C + SHIELDING, UL 80ºC 300V VW-1, 1050 mm. (36-48V) Depends on customers requirements. Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] Page 2 of 3 Rev D DTA100A-H SERIES Class I, With Active PFC 100 Watt, Single Output AC/DC Desktop Switching Adaptor COMPANY INFORMATION Wall Industries, Inc. has created custom and modified units for over 50 years. Our in-house research and development engineers will provide a solution that exceeds your performance requirements on-time and on budget. Our ISO9001-2008 certification is just one example of our commitment to producing a high quality, well-documented product for our customers. Our past projects demonstrate our commitment to you, our customer. Wall Industries, Inc. has a reputation for working closely with its customers to ensure each solution meets or exceeds form, fit and function requirements. We will continue to provide ongoing support for your project above and beyond the design and production phases. Give us a call today to discuss your future projects. Contact Wall Industries for further information: Phone: Toll Free: Fax: E-mail: Web: Address: 2/5/2016 (603)778-2300 (888)597-9255 (603)778-9797 [email protected] www.wallindustries.com 37 Industrial Drive Exeter, NH 03833 Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] Page 3 of 3