DTSAWD SERIES 25.5~34 Watts, AC/DC Desktop Power Supplies Rev A Wall Industries, Inc. FEATURES “A” Type Size: 4.57 x 1.87 x 1.30 inches “B” Type RoHS Compliant CEC / Energy Star Level V Compliant 25.5~34 Watts Output Power 100-240VAC Input Voltage Range Dual Outputs Output Voltage, Over Current, & Short Circuit Protection Free Air Convection Cooling IEC-320-C14, IEC-320-C8, & IEC-320-C6 AC Inlets Available MTBF: 50,000 Hours Several Output Connector Options Available Very Low Standby Power UL/cUL, FCC, CE, GS, SAA, C-Tick, CB, & CCC Approvals DESCRIPTION Size: 4.57 x 1.87 x 1.30 inches The DTSAWD series of AC/DC desktop power supplies provides up to 34 Watts of output power in a 4.57” x 1.87” x 1.30” package. This series consists of dual output models with a 100~240VAC input voltage range. These supplies are RoHS compliant and are protected against over voltage, over current, and short circuit conditions. The DTSAWD series is CEC and Energy Star Level V compliant and has UL/cUL, FCC, CE, GS, SAA, C-Tick, CB, and CCC safety approvals. IEC-320-C14, IEC-320-C8, and IEC-320-C6 AC inlet types are available for this series. “C” Type Size: 4.57 x 1.87 x 1.30 inches MODEL SELECTION TABLE Model Number Input Voltage Range DTSAWD25-5/12A 100 ~ 240 VAC DTSAWD34-5/12A 100 ~ 240 VAC DTSAWD25-5/12B 100 ~ 240 VAC DTSAWD34-5/12B 100 ~ 240 VAC DTSAWD25-5/12C 100 ~ 240 VAC DTSAWD34-5/12C 100 ~ 240 VAC Output Voltage 5 VDC 12 VDC 5 VDC 12 VDC 5 VDC 12 VDC 5 VDC 12 VDC 5 VDC 12 VDC 5 VDC 12 VDC Output Current 1.5A 1.5A 2A 2A 1.5A 1.5A 2A 2A 1.5A 1.5A 2A 2A Ripple & Noise (1) 50mVp-p 100mVp-p 50mVp-p 100mVp-p 50mVp-p 100mVp-p 50mVp-p 100mVp-p 50mVp-p 100mVp-p 50mVp-p 100mVp-p Output Power AC Inlet 25.5W IEC-320-C14 34W 25.5W IEC-320-C8 34W 25.5W IEC-320-C6 34W NOTES 1. Ripple and noise is measured at 20MHz limited bandwidth with 0.1μF ceramic and 10μF electrolytic capacitors across the output. 2. Several output connector options available. Please call factory for ordering details. MODEL NUMBER SETUP DTSAW D 34 Series Name Number of Outputs Output Power D: Dual Output 25: 34: 25.5 Watts 34 Watts - 5/12 A Ouptut Voltage AC Inlet Connector 5/12: 5 VDC, 12 VDC A: B: C: IEC-320-C14 IEC-320-C8 IEC-320-C6 Note: Several output connector options are available. Please contact factory for ordering details. 03/22/2013 Wall Industries, Inc. • 5 Watson Brook Road, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] Page 1 of 4 Wall Industries, Inc. DTSAWD SERIES 25.5~34 Watts, AC/DC Desktop Power Supplies Rev A SPECIFICATIONS: DTSAWD SERIES All specifications are based on 25°C, Nominal Input Voltage, and Maximum Output Current unless otherwise noted. We reserve the right to change specifications based on technological advances. SPECIFICATION TEST CONDITIONS Min Typ Max 100 90 47 115/230 115/230 50/60 240 264 63 1.5 30 75 2.5 Unit INPUT SPECIFICATIONS Rated input voltage range Full Range Input Voltage Input Frequency Input Current Inrush Current Stand-by Power OUTPUT SPECIFICATIONS Output Voltage Voltage Tolerance Line Regulation Load Regulation Output Power Output Current Minimum Load Ripple & Noise Hold-Up Time Turn-on Time PROTECTION Over Voltage Protection Over Current Protection Short Circuit Protection GENERAL SPECIFICATIONS Efficiency Switching Frequency Dielectric Withstand Voltage (I/P to O/P) Insulation Resistance (I/P to O/P) ENVIRONMENTAL SPECIFICATIONS Operating Temperature Storage Temperature Operating Humidity Storage Humidity Cooling MTBF PHYSICAL SPECIFICATIONS Dimensions (L x W x H) Weight -5 -1 -5 Output Connector SAFETY & COMPLIANCE Safety Approvals Compliance See Table +5 +1 +5 See Table See Table 0 Hz A A W % % % mA See Table 100VAC/60Hz and full load 100VAC/60Hz and full load 10 5 ms s Output voltage clamped by Zener diode Output shut-down; Automatic recovery Output shut-down; Automatic recovery 90VAC/60Hz and full load 78 70 10mA / 3 sec 500VDC 3000 10 0 -40 20 0 @ 25°C (MIL-HDBK-217F) “A” Suffix “B” Suffix “C” Suffix AC Inlet 03/22/2013 90VAC/60Hz and full load 100VAC/50Hz, full load, cold start 240VAC/50Hz, full load, cold start 90VAC/63Hz ~ 264VAC/47Hz and no load VAC +35 +85 90 90 Free air convection 50,000 hours % KHz VAC MΩ °C °C % RH % RH 4.57 x 1.87 x 1.30 inches (116.0 x 47.5 x 33.0 mm) Approximately 7.41oz (210g) IEC-320-C14 IEC-320-C8 IEC-320-C6 Optional output connectors available UL/cUL, FCC, CE, GS, PSE, SAA, C-Tick, CB, EUP, and CCC RoHS and CEC/Energy Star Level V compliant Wall Industries, Inc. • 5 Watson Brook Road, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] Page 2 of 4 DTSAWD SERIES 25.5~34 Watts, AC/DC Desktop Power Supplies Rev A Wall Industries, Inc. EMI & RADIATION CHARACTERISTICS Conduction Freq (KHz) Peak Amptd (dBuV) QP Amptd (dBuV) Avg Amptd (dBuV) QP Limit (dBuV) Avg Limit (dBuV) QP Margin (dB) Avg Margin (dB) Factor (dB) 1 201.8000 59.92 42.73 64.52 54.52 -4.60 -11.79 2 403.4500 46.87 40.27 58.76 48.76 -11.89 -8.49 13.66 12.22 3 470.0500 43.28 56.86 46.86 -13.57 -3.57 12.07 Radiation Freq (MHz) 03/22/2013 Level (dBuV/m) Margin (dB) Limit (dBuV/m) Reading (dBuV) Factor (dB) Remarks 1 37.5600 33.00 -7.00 40.00 21.83 11.17 2 42.4200 32.89 -7.11 40.00 21.72 11.17 3 71.8500 34.04 -5.96 40.00 25.02 9.02 4 75.6300 34.54 -5.46 40.00 22.80 11.74 Wall Industries, Inc. • 5 Watson Brook Road, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] Page 3 of 4 Wall Industries, Inc. Rev A DTSAWD SERIES 25.5~34 Watts, AC/DC Desktop Power Supplies MECHANICAL DRAWING Unit: inches (mm) “B” Suffix “C” Suffix 1.30 (33.0) 1.30 (33.0) IEC-320-C14 IEC-320-C8 IEC-320-C6 1.87 (47.5) 4.57 (116.0) “A” Suffix 1.30 (33.0) 4.57 (116.0) 1.87 (47.5) NOTES 1. Tolerance: ±0.01 (±0.25) 2. Weight: 7.41oz (210g) 3. Optional output connector available 4. All dimensions are for reference only COMPANY INFORMATION Wall Industries, Inc. has created custom and modified units for over 50 years. Our in-house research and development engineers will provide a solution that exceeds your performance requirements on-time and on budget. Our ISO9001-2008 certification is just one example of our commitment to producing a high quality, well-documented product for our customers. Our past projects demonstrate our commitment to you, our customer. Wall Industries, Inc. has a reputation for working closely with its customers to ensure each solution meets or exceeds form, fit and function requirements. We will continue to provide ongoing support for your project above and beyond the design and production phases. Give us a call today to discuss your future projects. Contact Wall Industries for further information: Phone: Toll Free: Fax: E-mail: Web: Address: 03/22/2013 (603)778-2300 (888)597-9255 (603)778-9797 [email protected] www.wallindustries.com 5 Watson Brook Rd. Exeter, NH 03833 Wall Industries, Inc. • 5 Watson Brook Road, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] Page 4 of 4