WMNA1105-U 10.5 Watts AC/DC US Mini Charger Rev E FEATURES • Class II • 90-264VAC Input Voltage Range • US Type AC Plug • 0°C to +40° Operating Temperature Range • USB Type Outlet Connector • Over Voltage, Over Current, & Short Circuit • RoHS Compliant Several other Pantone® colors available Size: 1.93 x 1.79 x 0.87 inches 49.0 x 45.5 x 22.0 mm Applications: • iPads & iPhones • Mobile Internet Devices (MID) • Mobile Phones • Mini Players Protection • 10.5 Watts Output Power • MTBF: 50,000 Hours • 5 VDC Single Outputs • UL60950 FCC Part 15 Safety Approvals • Very Low Standby Power • Several Pantone® Case Colors Available DESCRIPTION The WMNA10 series of Class II wall mount AC/DC power supplies delivers up to 10.5 Watts of output power in a 1.93” x 1.79” x 0.87” package. This series has single output models with an input voltage range of 90-264VAC. These supplies are protected against over voltage, over current, and short circuit conditions. The WMNA10 series is RoHS, CEC, and has UL 60950 FCC Part 15 safety approvals. These supplies are also available in a variety of Pantone® colors. MODEL SELECTION TABLE Model Number WMNA1105-Ux (1) Input Voltage Range Output Voltage Output Current Ripple & Noise (2) Output Power 90~264VAC 5 VDC 2100mA 50mVp-p 10.5W NOTES 1. The “x” in the model number represents the Pantone® case color. We offer several Pantone® case colors so please call factory if desired color is not shown. 2. Ripple and noise is measured at 20MHz limited bandwidth with 0.1µF ceramic and 10µF electrolytic capacitors across the output MODEL NUMBER SETUP WMNA 11 05 Series Name Output Power Ouptut Voltage 11: 10.5 Watts 05: 5 VDC - U W C AC Plug Type Case Color Cable None: Black C: USB Type, 3.0 Micro B U: United States W: White We offer several other Pantone® colors. If the desired color is not shown above please call factory for ordering details. 11/12/2014 Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-7789797 website: www.wallindustries.com • e-mail: [email protected] Page 1 of 3 WMNA1105-U 10.5 Watts AC/DC US Mini Charger Rev E TECHNICAL SPECIFICATIONS: WMNA10 SERIES All specifications are based on 25°C, Nominal Input Voltage, and Maximum Output Current unless otherwise noted. We reserve the right to change specifications based on technological advances. SPECIFICATION TEST CONDITIONS Min Typ Max 100 90 47 115/230 115/230 50/60 240 264 63 0.5 30 75 0.3 Unit INPUT SPECIFICATIONS Rated input voltage range Full Range Input Voltage Input Frequency Input Current Inrush Current Stand-by Power OUTPUT SPECIFICATIONS Output Voltage Voltage Tolerance Line Regulation Load Regulation Output Power Output Current Minimum Load Ripple & Noise Hold-Up Time Turn-on Delay Time PROTECTION At 90VAC/60Hz and full load At 100VAC and full load At 240VAC and full load At 230VAC/50Hz and no load 5 -5 -1 -5 0 Measured at 20MHz limited bandwidth with 0.1µF ceramic and 10µF electrolytic capacitors across the output At 100VAC/60Hz and full load At 100VAC/60Hz and full load Over Voltage Protection Over Current Protection Short Circuit Protection GENERAL SPECIFICATIONS Switching Frequency Dielectric Withstand Voltage (I/P 10mA/60 sec to O/P) Insulation (I/P to O/P) 500VDC ENVIRONMENTAL SPECIFICATIONS Operating Temperature Storage Temperature Humidity Non-condensing Cooling MTBF 0.5% annual field failure rate at 25°C PHYSICAL SPECIFICATIONS Weight Dimensions (L x W x H) AC Inlet Output Connector Case Color SAFETY Safety Approvals 11/12/2014 +5 +1 +5 See Table See Table UL (USA) FCC (USA) VAC Hz A A W VDC % % % mA 50 mVp-p 10 3 ms s Voltage clamped by internal protection Zener Output shut-down; Auto restart Output shut-down; Auto restart 65 KHz 3000 VAC 10 MΩ 0 -10 5 +40 +70 95 Free air convection 50,000 °C °C % RH hours 1.76oz (50g) 1.93” x 1.79” x 0.87” (49.0 x 45.5 x 22.0 mm) US type USB Several Pantone® color options available UL 60950 FCC PART 15 Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-7789797 website: www.wallindustries.com • e-mail: [email protected] Page 2 of 3 Rev E WMNA1105-U 10.5 Watts AC/DC US Mini Charger MECHANICAL DRAWING COMPANY INFORMATION Wall Industries, Inc. has created custom and modified units for over 50 years. Our in-house research and development engineers will provide a solution that exceeds your performance requirements on-time and on budget. Our ISO9001-2008 certification is just one example of our commitment to producing a high quality, well-documented product for our customers. Our past projects demonstrate our commitment to you, our customer. Wall Industries, Inc. has a reputation for working closely with its customers to ensure each solution meets or exceeds form, fit and function requirements. We will continue to provide ongoing support for your project above and beyond the design and production phases. Give us a call today to discuss your future projects. Contact Wall Industries for further information: Phone: Toll Free: Fax: E-mail: Web: Address: 11/12/2014 (603)778-2300 (888)597-9255 (603)778-9797 [email protected] www.wallindustries.com 37 Industrial Drive Exeter, NH 03833 Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-7789797 website: www.wallindustries.com • e-mail: [email protected] Page 3 of 3