Rev A PSSUU100 Series U-Bracket 100 Watt, Single Output AC/DC Power Supply for I.T.E. FEATURES ● Single Output ● Class I Insulation ● Internal EMI Filter ● 3-pin Input Connector ● Power Factor Correction ● Over Voltage Protection (Crowbar Design) ● Output Voltage Available from 3VDC thru 50VDC ● Wide Input Voltage Range: 90~264VAC, 47~63Hz ● Input Surge Current, Over Voltage, and Over Load Protection DESCRIPTION The PSSUU100 series of AC/DC switching mode power supplies provides 100 Watts of continuous output power in a compact, Uframe constructed design. This series has single output supplies with a universal input range of 90~264VAC. These units are ideally suited for use in disc drive systems, microprocessor based systems, portable equipment, and many other applications. All models meet FCC Part-15 class B and CISPR-22 class B emission limits. These supplies also comply with UL/cUL (UL 60950-1), TUV/Bauart (EN 60950-1), and new CE requirements. All units are 100% burn-in tested. SPECIFICATIONS: PSSUU100 Series All specifications are based on 25°C, Nominal Input Voltage, and Maximum Output Current unless otherwise noted. We reserve the right to change specifications based on technological advances. SPECIFICATION INPUT (Vin) Operating Voltage Range Input Frequency Input Current (Low Line) Input Current (High Line) Inrush Current (Low Line) Inrush Current (High Line) Safety Ground Leakage Current Start-Up Time OUTPUT (Vo) Output Voltage Range Load Regulation Line Regulation Output Power Output Current Range *Ripple & Noise (peak to peak) Transient Response Time Hold-Up Time PROTECTION Over Voltage Protection Over Current Protection GENERAL Efficiency Dielectric Withstanding Voltage For Primary to Secondary Dielectric Withstanding Voltage For Primary to Ground Isolation Resistance Power Factor Correction ENVIRONMENTAL Operating Temperature Storage Temperature Relative Humidity Temperature Coefficient MTBF PHYSICAL Weight Dimensions SAFETY EMI Requirements for CISPR-22 EMI Requirements for FCC PART-15 TEST CONDITIONS Min Nom Max Unit 12 26 0.4 1 264 63 2.0 1.0 15 30 0.75 2 VAC Hz A A A A mA s 90 47 Io = Full Load, Vin = 115VAC Io = Full Load, Vin = 230VAC Io = Full Load, 25°C, Cool Start, Vin = 115VAC Io = Full Load, 25°C, Cool Start, Vin = 230VAC Io = Full Load, Vin = 240VAC Io = Full Load, Vin = 100VAC 0.3 See Rating Chart 3 5 0.5 1 100 See Rating Chart 0.5 1 4 Vin = 230VAC Io = Full Load Vin = 90 to 264VAC Full Load, Vin = 90VAC Io = Full Load to Half Load, Vin = 100VAC Io = Full Load, Vin = 110VAC 16 112 110 Io = Full Load, Vin = 230VAC 70 132 150 80 85 % % W % ms ms % % % Primary to Secondary 4242 VDC Primary to Ground 2121 VDC Test Voltage = 500VDC Io = Full Load, Vin = 90~260VAC 50 0.95 Derate linearly from 100% Load at 50°C to 50% load at 70°C 0 -40 5 -0.04 All Outputs MΩ 0.97 1.0 +70 +85 95 +0.04 100,000 hours °C °C % %/°C Approximately 475 grams 5(L) x 3.2(W) x 1.19(H) inches Vin = 220VAC Vin = 110VAC *Note: The Ripple & Noise for output voltages under 3.3VDC is 2% max. Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797 B B Class Class PSSUU100 Series U-Bracket 100 Watt, Single Output AC/DC Power Supply for I.T.E. Rev A MODEL SELECTION TABLE Model Number PSSUU100-101 PSSUU100-102 PSSUU100-103 PSSUU100-104 PSSUU100-105 PSSUU100-106 PSSUU100-107 PSSUU100-108 PSSUU100-109 PSSUU100-110 PSSUU100-111 Preset Voltage 3 VDC 5 VDC 6 VDC 9 VDC 11 VDC 13 VDC 16 VDC 21 VDC 27 VDC 33 VDC 40 VDC Output Voltage Range 3 ~ 5 VDC 5 ~ 6 VDC 6 ~ 9 VDC 9 ~ 11 VDC 11 ~ 13 VDC 13 ~ 16 VDC 16 ~ 21 VDC 21 ~ 27 VDC 27 ~ 33 VDC 33 ~ 40 VDC 40 ~ 50 VDC Output Current Range 18.00 ~ 10.80 14.00 ~ 11.66 13.33 ~ 8.88 11.11 ~ 9.09 9.09 ~ 7.69 7.69 ~ 6.25 6.25 ~ 4.76 4.76 ~ 3.70 3.70 ~ 3.03 3.03 ~ 2.50 2.50 ~ 2.00 Total Regulation Output Power 5% 5% 5% 5% 3% 3% 3% 2% 2% 2% 2% 54W 70W 80W 100W 100W 100W 100W 100W 100W 100W 100W NOTES 1. Input connector mates with Molex housing 09-50-3051 and Molex 2478 series crimp terminal. 2. Output connector mates with Molex housing 09-50-3131 and Molex 2478 series crimp terminal. MECHANICAL DRAWING Unit: inches (mm) PIN CONNECTIONS PIN 1 2 3 4 5 6 7 8 9 10 11 12 OUT OUT OUT OUT OUT OUT RTN RTN RTN RTN RTN RTN Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797 13 N/C