Tape Information

Tape Information
www.vishay.com
Vishay Siliconix
MiniQFN-10L Carrier Tape
2.00 ± 0.05
B
A
B
BO
8.00 ± 0.30
+ 0.07
- 0.05
3.50 ± 0.05
0.28
4.00 ± 0.10
4.00 ± 0.10
+ 0.10
- 0.00
1.75 ± 0.10
∅ 1.50
∅ 1.00 ± 0.05
5° max.
A
KO
Section A - A
5° max.
AO
Siliconix proprietary drawing
any disclosure and distribution of
this drawing is strictly prohibited
Section B-B
VERSION
AO
BO
KO
-1
1.70 ± 0.10
2.10 ± 0.10
0.70 ± 0.10
-2
1.60 ± 0.05
2.00 ± 0.05
0.70 ± 0.05
COMMENT
for AMDG2723
ECN: E15-1221-Rev. D, 07-Sep-15
DWG: 93-5254-X
Notes
1. 10 sprocket hole pitch cumulative tolerance ± 0.2.
2. Camber not to exceed 1 mm in 100 mm, also not to exceed 1.5 cm in 1 m actually.
3. Material: black conductive polycarbonate.
4. Pocket position relative to sprocket hole measured as true position of pocket, not pocket hole.
5. All sizes in mm unless specified.
6. Use 7" lok reel with 8.4 mm width (see 93-5211-3).
7. Use seal tape with 5.4 mm width. (see 92-5210-3).
8. Vishay part number must be labeled at all reels of cover and carrier tape.
9. Surface resistivity - 105 max. W/sq.
Document Number: 74493
1
For technical questions, contact: [email protected]
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000
Revision: 07-Sep-15