P30WG_4:1

P30WG-xxxxE/Z/D4:1LF
PMTW-SERIES
Rev.11-2009
30 Watt
4:1 Ultra Wide Input
2” x 1” Metal Case
1.6 kV DC I/O Isolation
Regulated Output
Single, Dual and Triple Output
Continuous Short Circuit Prot.
Mainzer Straße 151–153
D-55299 Nackenheim
Tel. +49 6135 7026-0
Fax: +49 6135 931070
www.peak-electronics.de
[email protected]
The PMTW series P30WG-xxxxE/Z/D4:1LF is a family of cost effective
30W, single, dual and triple output DC-DC converters with an ultra wide
input range of 4:1. These converters are encapsulated in nickel coated
brass 2”x1” case with high performance features: 1600VDC input/output
isolation voltage, continuous short circuit protection with automatic restart
and tight line / load regulation, over current protection, over voltage
protection, over temperature protection, high efficiency operation and soft
start.
All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified
Input Specifications
Voltage Range
Input Filter
Input Reflected Ripple Current¹
Start up Time (Nom. Vin and constant resistive load)
4:1 Ultra Wide Input (see table)
PI Type
20 mA pk-pk
30mS, typ.
Output Specifications
Voltage Accuracy
Voltage Adjustability (only Single Output)
Short Circuit Protection
Over Load Protection
Line Regulation
Load Regulation (0% - 100%) / Triple (10% - 100%)
Cross Regulation³
Ripple&Noise (20Mhz bandwidth / 1.0uF – pk-pk)
Temperature Coefficient
Transient Recovery Time4
Transient Response Deviation4
± 1% (main out) ± 5% (AUX - for triple output)
± 10%, max.
Indefinite (hiccup, automatic recovery)
150% of FL, typ.
± 0.5% (single&dual) ±1% / ±5% (triple main / aux)
± 0.5% (single) ±1% / ±5% (dual & triple main / aux)
± 5% (dual & triple)
100 mV (single&dual) 50 / 75mV (triple: main / aux)
± 0.02% / °C
250us, typ.
± 3%, max.
General Specifications
I/O Isolation Voltage (3 sec.)
I/O Isolation Capacitance
I/O Isolation Resistance
Switching Frequency
Humidity
Reliability Calculated MTBF (MIL-HDBK-217F)
1600 VDC
1500 pF, typ.
1000 M Ohm, min.
330 kHz, typ.
95% rel H
>435 khrs (single&dual out) >320 khrs (triple out)
Physical Specifications
Case Material
Potting / Base Material
Weight
Nickel Coated Copper
Epoxy / Plastic (UL94V-0 rated)
~ 31g, typ.
Environment Specifications
Operating Temperature
Maximum Case Temperature
Storage Temperature
Cooling
RoHS Conform
-40 to +50°C (for 100% - ambient)
105°C
-40 to +125°C
Free Air Convection (10mm distance required)
Soldering 260°C, max. (1.5mm from case 10s.)
PMTW-Series – P30WG-xxxxE/Z/D 4:1LF – Single, Dual and Triple Output – 2”x1” - Metal Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 1/4
Selection Guide
Single, Dual and Triple Output
A)
A)
)
)
d (m
mA ad (mA
d (m
(
a
a
)
o
)
d
o
C
L
L
C
)
)²
.
oa
Lo
(uF
(VD ary (VD nt Min
Full
VDC t No L t Full
t
d
(
e
n
)
a
g
i
e
e
l
e
o
i
r
r
%
ta
rren
rren
ltag
or L
Aux ut Cur
Cur
Vol
cy (
t Vo put Cu put Cu
acit
p
put
put
put
cien
Inpu
In
In
Out
Out
Out
Out
Effi
Cap
Order #
SINGLE OUTPUT
P30WG-243R3E4:1LF
P30WG-2405E4:1LF
P30WG-245R1E4:1LF
P30WG-2412E4:1LF
P30WG-2415E4:1LF
P30WG-483R3E4:1LF
P30WG-4805E4:1LF
P30WG-485R1E4:1LF
P30WG-4812E4:1LF
P30WG-4815E4:1LF
9-36
60
9-36 100
9-36
90
9-36
30
9-36
30
18-72 50
18-72 60
18-72 60
18-72 30
18-72 30
1185
1420
1448
1436
1420
593
702
724
718
710
3.3
5
5.1
12
15
3.3
5
5.1
12
15
-
0
0
0
0
0
0
0
0
0
0
7500
6000
6000
2500
2000
7500
6000
6000
2500
2000
89
91
91
90
91
89
91
91
90
90
20000
14000
14000
2000
2000
20000
14000
14000
2000
2000
DUAL OUTPUT
P30WG-2405Z4:1LF
P30WG-2412Z4:1LF
P30WG-2415Z4:1LF
P30WG-4805Z4:1LF
P30WG-4812Z4:1LF
P30WG-4815Z4:1LF
9-36 120
9-36
30
9-36
40
18-72 70
18-72 30
18-72 40
1437
1453
1437
710
718
718
±5
± 12
± 15
±5
± 12
± 15
-
0
0
0
0
0
0
± 3000
± 1250
± 1000
± 3000
± 1250
± 1000
90
89
89
91
90
90
3000
1300
1300
3000
1300
1300
TRIPLE OUTPUT
P30WG-243R312D4:1LF
P30WG-243R315D4:1LF
P30WG-240512D4:1LF
P30WG-240515D4:1LF
P30WG-483R312D4:1LF
P30WG-483R315D4:1LF
P30WG-480512D4:1LF
P30WG-480515D4:1LF
9-36
80
9-36
90
9-36 100
9-36 110
18-72 50
18-72 50
18-72 60
18-72 60
1287
1279
1440
1431
636
640
712
707
3.3
3.3
5
5
3.3
3.3
5
5
±12
±15
±12
±15
±12
±15
±12
±15
5000 / ±420
5000 / ±330
4000 / ±420
4000 / ±330
5000 / ±420
5000 / ±330
4000 / ±420
4000 / ±330
89
89
89
90
89
89
91
90
15000 / ±220
15000 / ±220
8000 / ±220
8000 / ±220
15000 / ±220
15000 / ±220
8000 / ±220
8000 / ±220
500 / ±42
500 / ±33
400 / ±42
400 / ±33
500 / ±42
500 / ±33
400 / ±42
400 / ±33
If you need other specifications, please enquire.
Notes:
PMTW-Series – P30WG-xxxxE/Z/D 4:1LF – Single, Dual and Triple Output – 2”x1” - Metal Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 2/4
Package / Pinning / Derating
2.54
(0.10)
10.16 10.16 2.54
(0.40) (0.40) (0.10)
4
5
2.54 5.08 7.62 7.62 2.54
(0.10)(0.20)(0.30)(0.30)(0.10)
4
6
45.72
(1.80)
ONLY
AND
DIA.
1.00
(0.04)
7
6
Bottom View
Bottom View
45.72
(1.80)
5
10.16
(0.40)
ONLY
OUTPUT MODELS
OUTPUT MODELS
2
3
5.08 5.08 10.16 5.08
(0.20) (0.20) (0.40) (0.20)
1
2.54
(0.10)
2.54
(0.10)
1
2
3
10.16 5.08 7.62 2.54
(0.40) (0.20) (0.30)(0.10)
All dimensions are typical in millimeters (inches).
- Pin diameter: 1.0 +/-0.05 (0.04 +/-0.002)
- Pin pitch tolerance: +/-0.35 (+/-0.014)
2"
- Case tolerance +/-0.5 (+/-0.02)
Specification may change without notice.
5.08
(0.20)
min.
x 1" – METAL CASE
#
1
2
3
4
5
6
7
PIN CONNECTIONS
SINGLE
DUAL
TRIPLE
+Vin
+Vin
+Vin
- Vin
- Vin
- Vin
CTRL
CTRL
CTRL
+Vout
+Vout
+Aux
- Vout
COM
- Aux
TRIM
- Vout
COM
+Vout
Notes:
PMTW-Series – P30WG-xxxxE/Z/D 4:1LF – Single, Dual and Triple Output – 2”x1” - Metal Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 3/4
App Notes
1 = Measured Input reflected ripple current with a simulated source inductance of 12uH.
2 = Tested by minimal Vin and constant resistive load.
3 = Dual: One load is 25% to 100% load, the other load is 100% load, the output voltage variable rate is within ±5%.
Triple: Main output 100% load, auxiliary 100%, other auxiliary 25% to 100%.
Auxiliary outputs ( + Aux and - Aux ) : main output 100% load, auxiliary 100%, other auxiliary 25% to 100%
or main output 25%, auxiliary 25%, other auxiliary 25% to100%.
4 = Tested by nominal Vin and 25% load step change (75% - 50% - 25% of Io)
5 = The PMTW series can meet EN55022 Class A With an external filter in parallel with the input pins.
6 = An external filter capacitor is required if the module has to meet EN61000-4-4 and EN61000-4-5
7 = The remote on/off control pin is referenced to –Vin (Pin2).
EMI Filter:
Input filter components (C1, C3, L) are used to help meet conducted emissions requirement. These
components should be mounted as close as possible to the module; all leads should be minimized to
decrease radiated noise.
Single&Dual Models
Triple Models
C1: 100uF, 100V
L: 12uH
C3: 1206, 470PF, 2kV
C1: 100uF, 100V
L: 12uH
C3: 1206, 470PF, 2kV
EMC SPECIFICATIONS
Radiated
Emissions
Conducted
5
Emissions
ESD
RS
6
EFT
6
Surge
CS
PFMF
EN 55022
CLASS A
EN 55022
CLASS A
EN 61000-4-2
EN 61000-4-3
EN 61000-4-4
EN 61000-4-5
EN 61000-4-6
EN 61000-4-8
Perf. Criteria A
Perf. Criteria A
Perf. Criteria A
Perf. Criteria A
Perf. Criteria A
Perf. Criteria A
Over Voltage Protection (Zender diode clamp)
External Output Trimming
Output can be externally trimmed.
(Single output models only!)
Rtrim-up
Rtrim-down
6
6
5
4
Under Input Voltage Lockout (typ.)
3.3 Vout:
3.9 V
24 Vin Models
Module ON/OFF 8.6V / 7.9V
5 Vout
6.2 V
48 Vin Models
Module ON/OFF 17.8V / 16V
5.1 Vout
6.2 V
12 Vout
15 V
15 Vout
18 V
± 5 Vout
± 6.2 V
ON:
± 12 Vout
± 15 V
OFF:
± 15 Vout
± 18 V
Remote ON/OFF Control
OFF idle current:
7
3 -12 VDC or open circuit
0 – 1.2 VDC or short circuit
PIN2 and PIN3
5mA, typ.
PMTW-Series – P30WG-xxxxE/Z/D 4:1LF – Single, Dual and Triple Output – 2”x1” - Metal Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 4/4