Plastic Packages for Integrated Circuits Package Outline Drawing L20.3x4 20 LEAD QUAD FLAT NO-LEAD PLASTIC PACKAGE Rev 1, 3/10 3.00 0.10 M C A B 0.05 M C A B 4 20X 0.25 16X 0.50 +0.05 -0.07 17 A 16 6 PIN 1 INDEX AREA 6 PIN 1 INDEX AREA (C 0.40) 20 1 4.00 2.65 11 +0.10 -0.15 6 0.15 (4X) A 10 7 VIEW "A-A" 1.65 TOP VIEW +0.10 -0.15 20x 0.40±0.10 BOTTOM VIEW SEE DETAIL "X" 0.10 C 0.9± 0.10 C SEATING PLANE 0.08 C SIDE VIEW (16 x 0.50) (2.65) (3.80) (20 x 0.25) C (20 x 0.60) 0.2 REF 5 0.00 MIN. 0.05 MAX. (1.65) (2.80) DETAIL "X" TYPICAL RECOMMENDED LAND PATTERN NOTES: 1. Dimensions are in millimeters. Dimensions in ( ) for Reference Only. 2. Dimensioning and tolerancing conform to AMSE Y14.5m-1994. 3. Unless otherwise specified, tolerance : Decimal ± 0.05 4. Dimension applies to the metallized terminal and is measured between 0.15mm and 0.30mm from the terminal tip. 5. Tiebar shown (if present) is a non-functional feature. 6. The configuration of the pin #1 identifier is optional, but must be located within the zone indicated. The pin #1 indentifier may be either a mold or mark feature. 1