Data Sheet • Electronic 1-phase Switch-mode power supplies c o n n e c t P o w e r I N S TA P O W E R CP SNT 24 W CP SNT 25 W CP SNT 48 W NEW Power supplies for DIN-rail mounting • Output voltage adjustable via potentiometer • Wide-range input: 85…264 VAC / 120…300 VDC (24 W) / 110…370 VDC (25/48W) • LED status indicator (25/48 W) • For TS 35 mounting rails • Option for connecting in parallel • International approvals for use world-wide Canada Mexico United States Weidmuller, Canada 10 Spy Court Markham, Ontario L3R 5H6 Telephone: (800) 268-4080 Facsimile: (905) 475-2798 Email: [email protected] Website: www.weidmuller.ca Weidmuller, Mexico Blvd. Hernamos Serdán 698 Col. San Rafael Oriente Peubla, Puebla C.P. 72029, Mexico Telephone: 01 222 2686227 Facsimile: 01 222 2686219 Weidmuller 821 Southlake Blvd. Richmond, Virginia 23236 Telephone: (800) 849-9343 Facsimile: (804) 379-2593 Email: [email protected] Website: www.weidmuller.com Switch-mode power supplies connectPower 1-phase CP SNT 24 W 28 V 1 A CP SNT 24 W 24 V 1 A CP SNT 24 W 15 V 1.5 A INSTAPOWER L B H L FUSE + L FUSE + N N L FUSE + N Technical data Input Input voltage Input current Frequency Starting current limit Input fuse low fuse Overvoltage Protection Output Output voltage Output current Max. output power Residual ripple Overload protection 85…265 VAC, 120…300 VDC 460 mA @ 115 VAC; 250 mA @ 230 VAC 50 / 60 Hz 2 A slow-blow fuse (internal) Varistor limited by Thermistor 85…265 VAC, 120…300 VDC 460 mA @ 115 VAC; 250 mA @ 230 VAC 50 / 60 Hz 2 A slow-blow fuse (internal) Varistor limited by Thermistor 85…265 VAC, 120…300 VDC 460 mA @ 115 VAC; 250 mA @ 230 VAC 50 / 60 Hz 2 A slow-blow fuse (internal) Varistor limited by Thermistor 28 VDC 1A 28 W < 2% Overvoltage / -thermal switch-off 24 VDC 1A 24 W < 2% Overvoltage / -thermal switch-off 15 VDC 1.5 A 23 W < 2% Overvoltage / -thermal switch-off Max. capacitance at output Mains failure bridge-over time Control at 10…100% load Parallel operation 78% 35 ms @ 115 VAC / 160 ms @ 230 VAC 0.5% 78% 36 ms @ 115 VAC / 160 ms @ 230 VAC 0.5% 78% 37 ms @ 115 VAC / 160 ms @ 230 VAC 0.5% Status display General data Operation temperature Storage temperature Relative humidity Isolation input / output Standards EMC standards No No No –20°C…+50°C –40°C…+85°C –20°C…+50°C –40°C…+85°C –20°C…+50°C –40°C…+85°C EN 50178, EN 60950, IEC950 EN 50081-1, 2; EN 61000-6-2, 3; EN 50082-1 CSA / CE / cULus Horizontal on TS 35 mounting rail EN 50178, EN 60950, IEC950 EN 50081-1, 2; EN 61000-6-2, 3; EN 50082-1 CSA / CE / cULus Horizontal on TS 35 mounting rail EN 50178, EN 60950, IEC950 EN 50081-1, 2; EN 61000-6-2, 3; EN 50082-1 CSA / CE / cULus Horizontal on TS 35 mounting rail Screw connection 2.5/ 0.5 / 4 62.5 x 52 x 90.5 Derating: 33% @ 60°C Screw connection 2.5/ 0.5 / 4 62.5 x 52 x 90.5 Derating: 33% @ 60°C Screw connection 2.5/ 0.5 / 4 62.5 x 52 x 90.5 Derating: 33% @ 60°C Approvals Mounting position Assembly Dimensions Clamping range (rating- / min. / max.) Length x width x height Note Ordering data 2 mm2 mm Type CP SNT 24W 28V 1A Part No. 9928890028 Type CP SNT 24W 24V 1A Part No. 9928890024 Type CP SNT 24W 15V 1.5A Part No. 9928890015 Switch-mode power supplies connectPower 1-phase CP SNT 24 W 12 V 1.5 A CP SNT 24 W 5 V 2 A CP SNT 25 W 5 V 5 A INSTAPOWER L B H L FUSE + N L FUSE + N L FUSE + N Technical data Input Input voltage Input current Frequency Starting current limit Input fuse low fuse Overvoltage Protection Output Output voltage Output current Max. output power Residual ripple Overload protection 85…265 VAC, 120…300 VDC 460 mA @ 115 VAC; 250 mA @ 230 VAC 50 / 60 Hz 2 A slow-blow fuse (internal) Varistor limited by Thermistor 85…265 VAC, 120…300 VDC 460 mA @ 115 VAC; 250 mA @ 230 VAC 50 / 60 Hz 2 A slow-blow fuse (internal) Varistor limited by Thermistor 85…264 VAC, 110…370 VDC 500 mA @ 230 VAC 50 / 60 Hz Fuse 2.5 A (T) / 250 V Varistor limited 12 VDC 1.5 A 18 W < 2% Overvoltage / -thermal switch-off 5 VDC 2A 10 W < 2% Overvoltage / -thermal switch-off Max. capacitance at output Mains failure bridge-over time Control at 10…100% load Parallel operation 78% 37 ms @ 115 VAC / 160 ms @ 230 VAC 0.5% 78% 37 ms @ 115 VAC / 160 ms @ 230 VAC 0.5% Status display General data Operation temperature Storage temperature Relative humidity Isolation input / output Standards EMC standards No No 4…8 VDC (adjustable via potentiometer) 5A 25 W 120 mVss const. from 105%…150% max. rated output power, automatic restart > 70% > 50 ms @ 230 VAC 1% max. 3 devices (nominal voltages must be adjusted to ± 20 mV) LED green –20°C…+50°C –40°C…+85°C –20°C…+50°C –40°C…+85°C EN 50178, EN 60950, IEC950 EN 50081-1, 2; EN 61000-6-2, 3; EN 50082-1 CSA / CE / cULus Horizontal on TS 35 mounting rail EN 50178, EN 60950, IEC950 EN 50081-1, 2; EN 61000-6-2, 3; EN 50082-1 CSA / CE / cULus Horizontal on TS 35 mounting rail Screw connection 2.5/ 0.5 / 4 62.5 x 52 x 90.5 Derating: 33% @ 60°C Screw connection 2.5/ 0.5 / 4 62.5 x 52 x 90.5 Derating: 33% @ 60°C Approvals Mounting position Assembly Dimensions Clamping range (rating- / min. / max.) Length x width x height Note Ordering data mm2 mm Type CP SNT 24W 12V 1.5A Part No. 9928890012 Type CP SNT 24W 5V 2A –10°C…+70°C (derating from 55°C) –20°C…+85°C Up to 95% at 40°C, no condensation 3 kV AC EN 60950 (SELV), EN 50178 (PELV) EN 61000-6-2 /-3 /-4, EN 55011, EN 55022, EN 61000-3-2 /-3 CE / UL 508 / cURus 60950 / GS Horizontal on TS 35 mounting rail Mount side-by-side, clearance above/below > 30 mm Screw connection 2.5/ 0.5 / 4 62.5 x 70 x 90.5 Part No. 9928890005 Type CP SNT 25W 5V 5A Part No. 8754960000 3 Switch-mode power supplies connectPower 1-phase CP SNT 48W 12V 4A CP SNT 48W 24V 2A CP SNT 48W 48V 1A INSTAPOWER L B H L FUSE + N Technical data L FUSE + L N FUSE + N Input Eingang Eingang Input voltage Input current Frequency Starting current limit Input fuse low fuse Overvoltage Protection Output Output voltage Output current Max. output power Residual ripple Overload protection 85…264 VAC; 110…370 VDC 500 mA @ 230 VAC 50/60 Hz Fuse 2.5 A (T) / 250 V Varistor limited Ausgang 9…15 VDC (adjustable via potentiometer) 4A 48 W 120 mVss const. from 105%…150% max. rated output power, automatic restart > 75% > 50 ms @ 230 VAC 1% max. 3 devices (nominal voltages must be adjusted to +/– 20 mv) LED green 85…264 VAC; 110…370 VDC 500 mA @ 230 VAC 50/60 Hz Fuse 2.5 A (T) / 250 V Varistor limited Ausgang 15…28 VDC (adjustable via potentiometer) 2A 48 W 120 mVss const. from 105%…150% max. rated output power, automatic restart > 78% > 50 ms @ 230 VAC 1% max. 3 devices (nominal voltages must be adjusted to +/– 20 mv) LED green 85…264 VAC; 110…370 VDC 500 mA @ 230 VAC 50/60 Hz Fuse 2.5 A (T) / 250 V Varistor limited –10°C…+70°C (derating from 55°C) –20°C…+85°C Up to 95% at 40°C, no condensation 3 kV AC EN 60950 (SELV), EN 50178 (PELV) EN 61000-6-2 /-3 /-4, EN 55011, EN 55022, EN 61000-3-2 /-3 CE / UL 508 / cURus 60950 / GS Horizontal on TS 35 mounting rail Mount side-by-side; clearance above/below > 30 mm ca. 0.2 kg Screw connection 2.5/ 0.5 / 4 62.5 x 70 x 90.5 –10°C…+70°C (derating from 55°C) –20°C…+85°C Up to 95% at 40°C, no condensation 3 kV AC EN 60950 (SELV), EN 50178 (PELV) EN 61000-6-2 /-3 /-4, EN 55011, EN 55022, EN 61000-3-2 /-3 CE / UL 508 / cURus 60950 / GS Horizontal on TS 35 mounting rail Mount side-by-side; clearance above/below > 30 mm ca. 0.2 kg Screw connection 2.5/ 0.5 / 4 62.5 x 70 x 90.5 –10°C…+70°C (derating from 55°C) –20°C…+85°C Up to 95% at 40°C, no condensation 3 kV AC EN 60950 (SELV), EN 50178 (PELV) EN 61000-6-2 /-3 /-4, EN 55011, EN 55022, EN 61000-3-2 /-3 CE / UL 508 / cURus 60950 / GS Horizontal on TS 35 mounting rail Mount side-by-side; clearance above/below > 30 mm ca. 0.2 kg Screw connection 2.5/ 0.5 / 4 62.5 x 70 x 90.5 Type CP SNT 48W 12V 4A Type CP SNT 48W 24V 2A Type CP SNT 48W 48V 1A Max. capacitance at output Mains failure bridge-over time Control at 10…100% load Parallel operation Status display General data Operation temperature Storage temperature Relative humidity Isolation input / output Standards EMC standards Approvals Mounting position Assembly Dimensions Clamping range (rating- / min. / max.) Length x width x height Note Ordering data 4 mm2 mm Part No. 8754970000 46…55 VDC (adjustable via potentiometer) 1A 48 W 120 mVss const. from 105%…150% max. rated output power, automatic restart > 80% > 50 ms @ 230 VAC 1% max. 3 devices (nominal voltages must be adjusted to +/– 20 mv) LED green Part No. 8739140000 Part No. 8879230000 Subject to technical changes • 1/07-LIT0701