INFRARED EMITTING DIODE LINEUP / INFRARED EMITTING DIODES OPTO Emitting Diode Lineup Type Single-end lead (Side view type) Surface mount type Package Half intensity angle Features Epoxy resin with lens Epoxy resin with lens/ leadless General purpose/Narrow beam angle ±13° GL480E00000F Compact and thin ±30° GL4800E0000F Compact/Narrow beam angle ±10° GL100MN0MP ±10° GL100MN1MP ±80° GL100MD1MP1 (Mountable for Top view/ Side view type) High output type Compact/Wide beam angle ■ Model No. Infrared Emitting Diodes Model No. Package, features GL480E00000F (Ta = 25°C) Absolute maximum ratings VR P Topr IF (mA) (V) (mW) (°C) Radiant flux Φe (mW) IF MIN. TYP. (mA) VF (V) TYP. MAX. IF (mA) ∆θ (°) TYP. λp (nm) TYP. 50 6 75 –25 to +85 0.7 – 20 1.2 1.4 20 ±13 950 50 6 75 –25 to +85 0.7 1.6 20 1.2 1.4 20 ±30 950 50 6 75 –30 to +85 1.0 3.0 (MAX.) 20 1.2 1.4 20 ±10 940 50 6 75 –30 to +85 2.0 6.0 (MAX.) 20 1.2 1.5 20 ±10 940 50 6 75 –30 to +85 – 6.0 (MAX.) 20 – 1.5 20 ±80 940 Epoxy resin with lens GL4800E0000F GL100MN0MP GL100MN1MP GL100MD1MP1 Surface mounting leadless type, epoxy resin board with lens Surface mounting leadless type, epoxy resin board with lens, high output type Surface mounting leadless type, epoxy resin board with lens, wide beam angle GL480E00000F GL4800E0000F Optoelectronics ■ Infrared GL100MN0MP (GL100MN1MP, GL100MD1MP1) Notice In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP devices shown in catalogs, data books, etc. Except where specially indicated, models listed on this page comply with the RoHS Directive*. For details, please contact SHARP. *RoHS Directive: Prohibits use of lead, cadmium, hexavalent chromium, mercury and specific brominated flame retardants (PBBs and PBDEs), with certain exceptions. Contact SHARP in order to obtain the latest device specification sheets before using any SHARP device. 57