NEW PRODUCT NEW PRODUCT NEW PRODUCT G2SBA20 AND G2SBA60 GLASS PASSIVATED SINGLE-PHASE BRIDGE RECTIFIER Reverse Voltage - 200 and 600 Volts Forward Current - 1.5 Amperes Case Type GBL FEATURES 0.825 (20.9) 0.815 (20.7) 0.125 (3.17) x 45 degrees Chamfer 0.421 (10.7) 0.411 (10.4) 0.080 (2.03) 0.060 (1.50) 0.098 (2.5) 0.075 (1.9) 0.095 (2.41) 0.080 (2.03) 0.718 (18.2) 0.682 (17.3) 0.098 (2.5) 0.075 (1.9) Lead Depth 0.022 (0.56) 0.050 (1.27) 0.018 (0.46) 0.040 (1.02) ¨ Plastic package has Underwriters Laboratory Flammability Classification 94V-0 ¨ This series is UL listed under the Recognized Component Index, file number E54214 ¨ High case dielectric strength of 1500 VRMS ¨ Ideal for printed circuit boards ¨ Glass passivated chip junction ¨ High surge current capability ¨ High temperature soldering guaranteed: 260¡C/10 seconds, 0.375 (9.5mm) lead length, 5lbs. (2.3kg) tension 0.210 (5.3) 0.190 (4.8) MECHANICAL DATA 0.040 (1.02) 0.030 (0.76) 0.140 (3.56) 0.128 (3.25) 0.022 (0.56) 0.018 (0.46) Polarity shown on front side of case: positive lead by beveled corner Polarity shown on front side of case, positive lead beveled corner. If preferred, marking may be on reverse side of case. Case: Molded plastic body over passivated junctions Terminals: Plated leads solderable per MIL-STD-750, Method 2026 Mounting Position: Any Weight: 0.071 ounce, 2.0 grams Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25¡C ambient temperature unless otherwise specified. SYMBOLS G2SBA20 G2SBA60 UNITS Maximum repetitive peak reverse voltage VRRM 200 600 Volts Maximum RMS voltage VRMS 140 420 Volts Maximum DC blocking voltage VDC 200 600 Volts Maximum average forward rectified TA=25¡C output current at I(AV) 1.5 Amps Peak forward surge current single sine-wave superimposed on rated load (JEDEC Method) IFSM 60 Amps Rating for fusing (t<8.3ms) I2t 16 A2sec Maximum instantaneous forward voltage drop per leg at 0.75A VF 1.05 Volts Maximum DC reverse current at rated DC blocking voltage per leg IR 5.0 300 mA RQJA RQJL 40 12 ¡C/W TJ, TSTG -55 to +150 ¡C TA=25¡C TA=125¡C Typical thermal resistance per leg Operating junction and storage temperature range NOTE: (1) Units mounted on P.C.B. with 0.5 x 0.5" (12 x 12mm) copper pads and 0.375" (9.5mm) lead length 2/24/99 RATINGS AND CHARACTERISTICS CURVES G2SBA20 THRU G2SBA60 FIG. 2 - MAXIMUM NON-REPETITIVE PEAK FORWARD SURGE CURRENT PER LEG 2 60 PEAK FORWARD SURGE CURRENT, AMPERES AVERAGE FORWARD OUTPUT FIG. 1 - DERATING CURVE OUTPUT RECTIFIED CURRENT 1.5 1 0.5 0 25 40 30 20 10 1.0 CYCLE P.C.B. MOUNTING, TA 0 50 0 50 75 100 125 150 1 100 NUMBER OF CYCLES AT 60 Hz TEMPERATURE, ¡C FIG. 3 - TYPICAL FORWARD CHARACTERISTICS PER LEG FIG. 4 - TYPICAL REVERSE CHARACTERISTICS PER LEG INSTANTANEOUS REVERSE CURRENT, MICROAMPERES 10 1 0.1 0.01 0.6 100 JUNCTION CAPACITANCE, pF 100 1 1.4 1.8 2.2 2.6 3 3.4 1 0.1 TA=25¡C 0 20 40 60 80 INSTANTANEOUS FORWARD VOLTAGE, VOLTS PERCENT OF RATED PEAK REVERSE VOLTAGE, % FIG. 5 - TYPICAL JUNCTION CAPACITANCE PER LEG FIG. 6 - TYPICAL TRANSIENT THERMAL IMPEDANCE 100 100 10 1 0.1 TA=125¡C 10 0.01 3.8 4 TRANSIENT THERMAL IMPEDANCE, ¡C/W INSTANTANEOUS FORWARD CURRENT, AMPERES 100 1 10 REVERSE VOLTAGE, VOLTS 100 10 1 0.1 0.01 0.01 0.1 1 t, HEATING TIME, sec. 10 100