FSA880 / FSA881 – USB Port 2:1 Switch with Accessory and Charger Detection Features Description Switch Type 2:1 USB Automatic switching with Available Switch Mechanism Interrupt USB Data Cable Chargers (CDP, DCP, Travel Adapter, Accessory Detection Car Kit-CEA-936-A) Factory-Mode Cables USB FS and HS 2.0 Compliant Battery Charging 1.1 Compliant USB Charging Charger Detect, DCD, OVT (28V) UART RxD and TxD VBAT 3.0 to 4.4V Programmability I2 C ESD 15kV IEC 61000-4-2 Air Gap Operating -40°C to 85°C Temperature 16-Lead UMLP Package 1.8x2.6x0.55mm, 0.4mm Pitch FSA880 – Active LOW JIG Option FSA881 – Active HIGH FSA880UMX Ordering Information FSA881UMX The FSA88x is a high-performance switch featuring automatic switching and accessory detection for a USB port. The FSA88x allows sharing of a common USB port to pass USB data, as well as factory programmability. In addition, the FSA88x integrates accessory detection of devices such as USB chargers and factory data cables. The FSA88x can be programmed for manual switching or automatic switching of data paths. VBUS_IN has 28V over-voltage tolerance. The difference between the FSA880 and the FSA881 is that FSA880 JIG output is an open-drain, active-LOW output, while FSA881 JIG is an active-HIGH, CMOS output. Applications Cellular Phones, Smart Phones MP3 and PMP Related Resources For samples and questions, please contact: [email protected]. FSA880 / FSA881 Demonstration Board Typical Application USB Data USB CHARGING FACTORY TEST OVT PROTECTION FSA88x FSA9280A Figure 1. Mobile Phone Example © 2010 Fairchild Semiconductor Corporation FSA880 / FSA881 • Rev. 1.0.3 www.fairchildsemi.com FSA880 / FSA881 — USB Port 2:1 Switch with Accessory and Charger Detection November 2011 USB Port FSA880 VBAT Phone Power DM_HOST DP_HOST HS USB or UART HS USB Baseband Processor DP_CON ID_CON GND Charger Detect BC1.1 INTB I2C_SCL I2C_SDA I2C DM_CON 2:1 MUX DM_HOST1 DP_HOST1 Interrupt VBUS_IN Detection 28V OVT VDDIO Switch Control and I2C Slave VDDIO 100k W JIG BOOT Float Detect ADC ID Detect Figure 2. Block Diagram Pin Configuration ID_CON DP_CON DM_CON VBUS_IN 16 DM_HOST 15 14 1 13 12 GND DP_HOST 2 11 I2C_SDA DM_HOST1 3 10 I2C_SCL DP_HOST1 4 9 INTB 5 6 7 8 VBAT BOOT JIG VDDIO Figure 3. Pin Assignment (Through View) © 2010 Fairchild Semiconductor Corporation FSA880 / FSA881 • Rev. 1.0.3 www.fairchildsemi.com 2 FSA880 / FSA881 — USB Port 2:1 Switch with Accessory and Charger Detection Block Diagram 1.80 0.10 C A 2.10 B 0.563 (15X) 0.663 2X 1 2.60 PIN#1 IDENT 0.10 C TOP VIEW 0.10 C 2.90 0.40 0.55 MAX. 0.08 C 0.225 (16X) 2X RECOMMENDED LAND PATTERN 0.152 TERMINAL SHAPE VARIANTS SEATING C PLANE 0.05 0.00 0.40 0.60 SIDE VIEW 0.15 0.25 0.45 0.35 15X 0.10 0.10 PIN 1 5 0.30 15X 0.50 0.15 0.25 NON-PIN 1 Supplier 1 9 0.40 0.30 0.50 0.15 0.25 1 0.15 15X 0.25 PIN 1 PIN#1 IDENT Supplier 2 13 16 NON-PIN 1 0.3015X 0.50 0.25 0.15 0.55 0.45 BOTTOM VIEW 0.10 C A B 0.05 C R0.20 PACKAGE EDGE NOTES: A. PACKAGE DOES NOT FULLY CONFORM TO JEDEC STANDARD. B. DIMENSIONS ARE IN MILLIMETERS. C. DIMENSIONS AND TOLERANCES PER ASME Y14.5M, 1994. D. LAND PATTERN RECOMMENDATION IS BASED ON FSC DESIGN ONLY. E. DRAWING FILENAME: MKT-UMLP16Arev4. F. TERMINAL SHAPE MAY VARY ACCORDING TO PACKAGE SUPPLIER, SEE TERMINAL SHAPE VARIANTS. LEAD OPTION 1 SCALE : 2X LEAD OPTION 2 SCALE : 2X Figure 24. 16-Lead Ultrathin Molded Leadless Package (UMLP), 1.8mm x 2.6mm x 0.55mm, 0.4mm Pitch Package drawings are provided as a service to customers considering Fairchild components. Drawings may change in any manner without notice. Please note the revision and/or date on the drawing and contact a Fairchild Semiconductor representative to verify or obtain the most recent revision. Package specifications do not expand the terms of Fairchild’s worldwide terms and conditions, specifically the warranty therein, which covers Fairchild products. Always visit Fairchild Semiconductor’s online packaging area for the most recent package drawings: http://www.fairchildsemi.com/packaging/. Part Number Operating Temperature Range Top Mark FSA880UMX -40 to +85°C KU 16-Lead, Ultrathin Molded Leadless Package (UMLP), 1.8mm x 2.6mm x 0.55mm, 0.4mm Pitch FSA881UMX -40 to +85°C KX 16-Lead, Ultrathin Molded Leadless Package (UMLP), 1.8mm x 2.6mm x 0.55mm, 0.4mm Pitch © 2010 Fairchild Semiconductor Corporation FSA880 / FSA881 • Rev. 1.0.3 Package www.fairchildsemi.com 24 FSA880 / FSA881 — USB Port 2:1 Switch with Accessory and Charger Detection Physical Dimensions FSA880 / FSA881 — USB Port 2:1 Switch with Accessory and Charger Detection © 2010 Fairchild Semiconductor Corporation FSA880 / FSA881 • Rev. 1.0.3 www.fairchildsemi.com 25