MCC Features • • • • • FR1Q THRU FR1ZZ omponents 21201 Itasca Street Chatsworth !"# $ % !"# For Surface Mount Applications Extremely Low Thermal Resistance High Temp Soldering: 250°C for 10 Seconds At Terminals Fast Recovery Times For High Efficiency Perfect For Ballast, Television And Monitor Applications 1 Amp Fast Recovery Silicon Rectifier 1200 to 2000 Volts Maximum Ratings • • • DO-214AA (SMBJ) (Round Lead) Operating Temperature: -50°C to +150°C Storage Temperature: -50°C to +150°C Maximum Thermal Resistance; 15°C/W Junction To Lead MCC Part Number Device Marking FR1Q FR1V FR1Y FR1Z FR1ZZ FR1Q FR1V FR1Y FR1Z FR1ZZ Maximum Recurrent Peak Reverse Voltage 1200V 1400V 1600V 1800V 2000V Maximum RMS Voltage 840V 980V 1120V 1260V 1400V H Cathode Band Maximum DC Blocking Voltage 1200V 1400V 1600V 1800V 2000V J A E Average Forward IF(AV) 1.0A TJ = 55°C Current Peak Forward Surge IFSM 30A 8.3ms, half sine Current Maximum Instantaneous Forward Voltage 1.50V IFM = 1.0A; VF FR1Q-FR1Y 1.70V TJ = 25°C* FR1Z-FR1ZZ Maximum DC IR Reverse Current At 5µA TJ = 25°C Rated DC Blocking 30µA TJ = 125°C Voltage Maximum Reverse Recovery Time IF=0.5A, IR=1.0A, Trr 300ns FR1Q-FR1Y 500ns FR1Z-FR1ZZ Irr=0.25A Typical Junction CJ 45pF Measured at Capacitance 1.0MHz, VR=4.0V *Pulse test: Pulse width 200 µsec, Duty cycle 2% D F lectrical Characteristics @ 25°C Unless Otherwise Specified C B G DIMENSIONS DIM A B C D E F G H J INCHES MIN .078 .075 .002 ----.035 .065 .205 .160 .130 MM MIN 1.98 1.90 .05 ----.90 1.65 5.21 4.06 3.30 MAX .116 .089 .008 .02 .055 .091 .224 .180 .155 MAX 2.95 2.25 .20 .51 1.40 2.32 5.69 4.57 3.94 SUGGESTED SOLDER PAD LAYOUT 0.090" 0.085” www.mccsemi.com 0.070” NOTE MCC FR1Q thru FR1ZZ Figure 1 Typical Forward Characteristics 20 Figure 2 Forward Derating Curve 10 1.2 6 4 1.0 2 25°C Amps .8 1 .6 .6 Amps .4 .4 FR1Q-FR1Y .2 .2 .1 .06 FR1Z -FR1ZZ 0 .04 0 50 75 100 125 150 175 °C .02 .01 Single Phase, Half Wave 60Hz Resistive or Inductive Load .5 .7 Average Forward Rectified Current - Amperes versus Ambient Temperature - °C 1.5 1.1 1.3 Volts Instantaneous Forward Current - Amperes versus Instantaneous Forward Voltage - Volts .9 Figure 3 Junction Capacitance 100 60 40 20 pF TJ =25°C 10 6 4 2 1 .1 .2 .4 1 Volts 2 4 10 20 40 100 200 400 Junction Capacitance - pF versus Reverse Voltage - Volts www.mccsemi.com 1000 MCC FR1Q thru FR1ZZ Figure 4 Peak Forward Surge Current 60 50 40 30 Amps 20 10 0 1 2 4 6 8 10 20 40 60 80 100 Cycles Peak Forward Surge Current - Amperes versus Number Of Cycles At 60Hz - Cycles Figure 5 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω trr +0.5A 0 Pulse Generator Note 2 25Vdc 1Ω Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive Oscilloscope Note 1 -0.25 -1.0 1cm Set Time Base for 20/100ns/cm www.mccsemi.com