MCC omponents 21201 Itasca Street Chatsworth !"# $ % !"# Features • • • • • FR3A THRU FR3M For Surface Mount Applications Extremely Low Thermal Resistance Easy Pick And Place High Temp Soldering: 250°C for 10 Seconds At Terminals\ Fast Recovery Times For High Effieciency 3 Amp Fast Recovery Silicon Rectifier 50 to 1000 Volts Maximum Ratings • • • DO-214AB (SMCJ) Operating Temperature: -55°C to +150°C Storage Temperature: -55°C to +150°C Maximum Thermal Resistance; 10 °C/W Junction To Lead MCC Catalog Number Device Marking FR3A FR3B FR3D FR3G FR3J FR3K FR3M FR3A FR3B FR3D FR3G FR3J FR3K FR3M Maximum Recurrent Peak Reverse Voltage 50V 100V 200V 400V 600V 800V 1000V Maximum RMS Voltage 35V 70V 140V 280V 420V 560V 700V H Maximum DC Blocking Voltage 50V 100V 200V 400V 600V 800V 1000V J A E D B F G DIMENSIONS Electrical Characteristics @ 25°C Unless Otherwise Specified Average Forward IF(AV) 3.0A TJ = 120°C Current Peak Forward Surge IFSM 100A 8.3ms, half sine Current Maximum 1.30V IFM = 3.0A; Instantaneous VF Forward Voltage TJ = 25°C* Maximum DC Reverse Current At IR 10µA TJ = 25°C Rated DC Blocking 250µA TJ = 100°C Voltage Maximum Reverse Recovery Time 150ns IF=0.5A, IR=1.0A, FR3A-G Trr 250ns Irr=0.25A FR3J 500ns FR3K-M Typical Junction CJ 80pF Measured at Capacitance 1.0MHz, VR=4.0V *Pulse test: Pulse width 200 µsec, Duty cycle 2% C DIM A B C D E F G H J INCHES MIN .079 .108 .002 MAX .103 .128 .008 MM MIN 2.00 2.75 .051 MAX 2.62 3.25 .203 .030 .050 .76 1.27 .305 .260 .220 .320 .280 .245 7.75 6.60 5.59 8.13 7.11 6.22 SUGGESTED SOLDER PAD LAYOUT 0.190 0.125” www.mccsemi.com 0.070” NOTE MCC FR3A thru FR3M Figure 1 Typical Forward Characteristics 100 60 Figure 2 Forward Derating Curve 40 3.0 20 2.5 10 6 2.0 4 1.5 25°C 2 Amps 1 Amps 1.0 .6 .5 .4 Single Phase, Half Wave 60Hz Resistive or Inductive Load .2 0 60 40 100 80 120 140 160 .1 °C .06 Average Forward Rectified Current - Amperesversus Ambient Temperature - °C .04 .02 .01 .4 .6 .8 1.0 1.2 1.4 Figure 3 Peak Forward Surge Current 150 1.6 Volts 125 Instantaneous Forward Current - Amperesversus Instantaneous Forward Voltage - Volts 100 75 Amps 50 25 0 1 2 4 6 8 10 20 40 60 80 100 Cycles Peak Forward Surge Current - Amperesversus Number Of Cycles At 60Hz - Cycles www.mccsemi.com MCC FR3A thru FR3M Figure 4 Typical Reverse Characteristics 1000 600 400 200 100 60 40 TA=100°C 20 µAmps 10 6 4 2 TA=75°C 1 .6 .4 TA=25°C .2 .1 20 40 60 80 100 120 140 Volts Instantaneous Reverse Leakage Current - MicroAmperesversus Percent Of Rated Peak Reverse Voltage - Volts Figure 5 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω trr +0.5A 0 Pulse Generator Note 2 25Vdc 1Ω Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive Oscilloscope Note 1 -0.25 -1.0 1cm Set Time Base for 20/100ns/cm www.mccsemi.com