Filename: tfs 140al.doc Version 1.4 VI TELEFILTER 15.07.2005 Filter specification TFS 140AL 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: * Input: Output: 23 0 °C dBm 212 Ω || -11,9 pF 1620 Ω || - 4,0 pF Characteristics Remark: Reference level for the relative attenuation arel of the TFS 140AL is the minimum of the pass band attenuation amin. The minimum of the pass band attenuation amin is defined as the insertion loss ae. The center frequence fc is the arithmetic mean value of the upper and lower frequencies at the 32 dB filter attenuation level relative to the insertion loss ae. The temperature coefficient of frequency Tcf is valid both for the centre frequency fc and the frequency response of the filter in the operating temperature range. Data Insertion loss (Reference level) ae Centre frequency at ambient temperature : fc Pass band at ambient temperature PB typ. value tolerance / limit 30 dB max. MHz 140,0 ± 0,05 MHz fC ... fC ± 4,48 MHz 140,01 35 dB Amplitude ripple in PB (p-p): 0,4 dB max. 0,8 dB Bandwidth at ambient temperature: 0,8 dB 2 dB 3 dB 9,27 9,40 9,47 MHz MHz MHz min. min. min. 8,96 9,29 9,33 MHz MHz MHz 10,01 MHz max. 10,08 MHz dB dB dB max. max. max. 0,8 2 3 32 dB Relative attenuation ... fC ± fC fC ± 4,48 MHz ... fC ± fC ± 4,64 MHz ... fC ± 4,48 4,64 4,66 MHz MHz MHz arel 0,4 1 1,5 dB dB dB fC ± 5,04 MHz ... fC ± 6,00 MHz 34 dB min. 32 8,17 MHz 42 dB min. 39 fC ± 6,00 MHz ... fC ± In the frequency range fc ± 6,00 MHz ... fc ± 8,17 MHz the type of the LIMIT LINE is a SLOPING LINE (SL). MHz 48 dB min. 45 fC ± 8,17 MHz ... fC ± 14,5 MHz ... fC ± 100 MHz 55 dB min. 50 fC ± 14,5 Group delay ( mean value in pass band ): 3,03 µs max. 5,36 dB dB Group delay ripple in pass band (p-p): ns 45 ns - 25 °C ... + 75 °C - Operating temperature range - 40 °C ... + 85 °C - Storage temperature range Temperature coefficient of frequency TCf **) - 0,04 ppm/K Frequency inversion temperature T0 10 °C Input power level max. 120 - dB dB µs 2 max. +10 dBm * ) The terminating impedances depends on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. **) ∆f(Hz) = TCf(ppm/K²) x (T-T0)² x fTo(MHz) generated: checked / approved: Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 140al.doc Version 1.4 VI TELEFILTER 15.07.2005 Filter specification TFS 140AL 2/5 0 3.86 -1 3.77 -14 -2 3.68 -21 -3 3.59 -28 -4 3.5 -5 3.41 -6 3.32 -49 -7 3.23 -56 -8 3.14 -63 -9 3.05 -35 -42 -70 91 100.8 110.6 120.4 130.2 140 149.8 frequency in MHz 159.6 169.4 179.2 189 -10 135 136 137 138 139 140 141 frequency in MHz 142 143 144 delay in µs 0 -7 magnitude in dB magnitude in dB Filter characteristic 2.96 145 Construction and pin connection (All dimensions in mm) TFS 140AL ● T25 Date code 50 Ohm Test circuit 3 Ground Input RF Return Input Ground Ground Ground Output RF Return Output Ground Ground Date code: T U V ... Year + week 2005 2006 2007 15 SAW C1 L1 1 2 3 4 9,10,11,12 13 14 15 16 21,22,23,24 2 C2 14 L2 1, 4, 9, 10, 11, 12, 13, 16, 21, 22, 23, 24 alternative: L1 3 15 L2 SAW C1 2 14 C2 1, 4, 9, 10, 11, 12, 13, 16, 21, 22, 23, 24 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 140al.doc VI TELEFILTER Version 1.4 Filter specification 15.07.2005 TFS 140AL 3/5 Stability characteristics : After the following tests the filter shall meet the whole specification: 1. Shock: 500g, 1 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 2. Vibration: 10 Hz to 500 Hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 3. Change of temperature 4. Resistance to solder heat (reflow): -55 °C to 125°C / 30 min. each / 10 cycles DIN IEC 68 part 2 – 14 Test N reflow possible: twice max.; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 140al.doc Version 1.4 VI TELEFILTER 15.07.2005 Filter specification TFS 140AL 4/5 Air reflow temperature conditions Conditions Average ramp-up rate (30°C to 217°C) > 100°C > 150°C > 217°C Peak temperature Time within 5°C of actual peak temperature Cool-down rate (Peak to 50°C) Time from 30°C to Peak temperature Exposure less than 3°C/second between 300 and 600 seconds between 240 and 500 seconds between 30 and 150 seconds max. 260°C between 10 and 30 seconds less than 6°C/second no greater than 300 seconds Chip-mount air reflow profile Temperature / °C max. 260°C 217°C max. 300 s 10 ... 30 s Time / s 30 ... 150 s Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 140al.doc VI TELEFILTER Version 1.4 Filter specification 15.07.2005 TFS 140AL 5/5 History : Version Reason of changes Name Date 1.0 - generate development specifications. Steiner 02.05.2005 1.1 - limit for relative attenuation modufied Pfeiffer 11.05.2005 1.2 - pinning changed Pfeiffer 13.05.2005 1.3 - terminating impedance, typical values and filter characteristic added Pfeiffer 15.06.2005 1.4 - relative attenuation at fC ± 6 MHz changed to 39 dB Pfeiffer 15.07.2005 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.