SUBMINIATURE SOLID STATE LAMP KM2520SURC03 Features HYPER RED Description !SUBMINIA TURE PACKAGE. The Hyper Red source color devices are made !WIDE VIEWING ANGLE. with DH InGaAlP on GaAs substrate Light Emitting ! GULL WING LEAD. Diode. ! LONG ! LOW LIFE - SOLID STATE RELIABILITY. PACKAGE PROFILE. ! PACKAGE : 1000PCS / REEL. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the lead emerge package. 4. Specifications are subject to change without notice. SPEC NO: DSAA7299 APPROVED : J. Lu REV NO: V.2 CHECKED : Allen Liu DATE:FEB/08/2003 DRAWN: F.Y.YUAN PAGE: 1 OF 4 Selection Guide Dic e Par t No . KM2520SURC03 Iv (m c d ) @ 20 m A L en s Ty p e HYPER RED ( InGaAlP ) WATER CLEAR V i ew i n g An g l e Min . Ty p . 2θ1/2 280 66 0 20 ° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at T)=25°°C Sy m b o l Par am et er D ev i c e λpeak Peak Wavelength Hyper Red λD Dominate Wavelength ∆λ1/2 Ty p . Max . Un it s Tes t Co n d it io n s 640 nm I F =20mA Hyper Red 6 28 nm I F =20mA Spectral Line Half-width Hyper Red 27 nm I F =20mA C Capacitance Hyper Red 45 pF VF=0V;f=1MHz VF Forward Voltage Hyper Red 1.9 2.5 V I F =20mA IR Reverse Current Hyper Red 10 uA V R = 5V Absolute Maximum Ratings at T)=25°°C Par am et er H y p e r R ed Un it s Power dissipation 170 mW DC Forward Current 30 mA Peak Forward Current [1] 185 mA Reverse Voltage 5 V Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAA7299 APPROVED : J. Lu REV NO: V.2 CHECKED : Allen Liu DATE:FEB/08/2003 DRAWN: F.Y.YUAN PAGE: 2 OF 4 Hyper Red KM2520SURC03 SPEC NO: DSAA7299 APPROVED : J. Lu REV NO: V.2 CHECKED : Allen Liu DATE:FEB/08/2003 DRAWN: F.Y.YUAN PAGE: 3 OF 4 KM2520SURC03 SMT Reflow Soldering Instructions Number of reflow process shall be less than 2 times and cooling process to normal temperature is required between first and second soldering process. Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) SPEC NO: DSAA7299 APPROVED : J. Lu REV NO: V.2 CHECKED : Allen Liu DATE:FEB/08/2003 DRAWN: F.Y.YUAN PAGE: 4 OF 4