SUBMINIATURE SOLID STATE LAMP AM2520SYC03 SUPER BRIGHT YELLOW Features Description !SUBMINIATURE PACKAGE. The Super Bright Yellow source color devices are made !WIDE VIEWING ANGLE. with DH InGaAlP on GaAs substrate Light Emitting !GULL WING. Diode. !LONG LIFE - SOLID STATE RELIABILITY. !LOW PACKAGE PROFILE. !PACKAGE : 1000PCS / REEL. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the lead emerge package. 4. Specifications are subject to change without notice. SPEC NO: CDA0455 APPROVED:J.LU REV NO: V.1 CHECKED: DATE: OCT/27/2001 DRAWN:M.F.CAI PAGE: 1 OF 4 Selection Guide Par t No . Dic e AM2520SY C03 Iv (mc d ) @ 20 mA L en s Ty p e SUPER BRIGHT Y ELLOW (InGaAlP) WATER CLEAR Viewin g An g le Mi n . Ty p . 2θ1/2 110 500 20° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°°C Sy m b o l P ar am et er D ev i c e λpeak Peak Wavelength Super Bright Yellow λD Dominate Wavelength ∆λ1/2 Ty p . Max . Un its Tes t Co n d it io n s 590 nm IF=20mA Super Bright Yellow 588 nm IF=20mA Spectral Line Halfwidth Super Bright Yellow 28 nm IF=20mA C Capacitance Super Bright Yellow 25 pF VF=0V;f=1MHz VF Forward Voltage Super Bright Yellow 2.0 2.5 V IF=20mA IR Reverse Current Super Bright Yellow 10 uA V R = 5V Absolute Maximum Ratings at TA=25°°C P ar am et er Su p er B r ig h t Yello w Un its Power dissipation 125 mW DC Forward Current 30 mA Peak Forward Current [1] 175 mA Reverse Voltage 5 V Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: CDA0455 APPROVED:J.LU REV NO: V.1 CHECKED: DATE: OCT/27/2001 DRAWN:M.F.CAI PAGE: 2 OF 4 Super Bright Yellow AM2520SYC03 SPEC NO: CDA0455 APPROVED:J.LU REV NO: V.1 CHECKED: DATE: OCT/27/2001 DRAWN:M.F.CAI PAGE: 3 OF 4 AM2520SYC03 SMT Reflow Soldering Instructions Number of reflow process shall be less than 2 times and cooling process to normal temperature is required between first and second soldering process. Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) SPEC NO: CDA0455 APPROVED:J.LU REV NO: V.1 CHECKED: DATE: OCT/27/2001 DRAWN:M.F.CAI PAGE: 4 OF 4