CM30MD3-12H Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 CI Module Single Phase Converter + Three Phase Inverter 30 Amperes/600 Volts A L G L J N NOT CONNECTED H H K K K GB NOT CONNECTED K L K K K (2 PLACES) GV EV GW EW GU EU P P1 N G E G E G GU GV GW E E GB G G G E C Q R "U" (2 PLACES) R B F E Q R S T B U V Description: Powerex CI Modules are designed for use in switching applications. Each module consists of a single phase diode converter section and a three phase IGBT inverter section. All components and interconnects are isolated from the heat sinking baseplate, offering simplified system assembly and thermal management. W "T" THICK S N V M M P P W M M X 45° MAIN TERMINAL CONTROL TERMINAL P Z LABEL Y P1 R GU GV GW EU EV EW GU GV GW S T B E U V W Outline Drawing and Circuit Diagram Dimensions Inches A 4.53 Millimeters 115.0 Dimensions Inches Millimeters N 0.51 13.0 B 2.36 60.0 P 0.59 15.0 C 1.18 30.0 Q 1.14 29.0 D 0.18 4.5 R 2.28 58.0 E 4.13 105.0 S 0.16 4.0 F 0.20 5.0 T 0.02 0.6 G 0.31 8.0 U 0.22 5.5 H 0.59 15.0 V 0.08 2.0 J 0.68 17.2 W 0.02 0.6 K 0.10 2.54 X 0.35 9.0 10.16 Y 0.25 6.3 12.5 Z 0.47 12.0 L M 40 0.49 Features: □ Low Drive Power □ Low VCE(sat) □ Discrete Super-Fast Recovery (70ns) Free-Wheel Diodes □ High Frequency Operation (20-25 kHz) □ Isolated Baseplate for Easy Heat Sinking Applications: □ AC Motor Control □ Motion/Servo Control □ General Purpose Inverters □ Robotics Ordering Information: Example: Select the complete nine digit module part number you desire from the table below - i.e. CM30MD3-12H is a 600V (VCES), 30 Ampere CI Power Module. Type Current Rating Amperes VCES Volts (x 50) CM 30 12 1 Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 CM30MD3-12H CI Module Single Phase Converter + Three Phase Inverter 30 Amperes/600 Volts Absolute Maximum Ratings, Tj = 25°C unless otherwise specified Characteristics Symbol CM30MD3-12H Units Tj -40 to 150 °C Tstg -40 to 125 °C — 13 in-lb Power Device Junction Temperature Storage Temperature Mounting Torque, M4 Mounting Screws Module Weight (Typical) — 100 Grams Isolation Voltage, AC 1 minute, 60Hz VRMS 2500 Volts Converter Part Repetitive Peak Reverse Voltage VRRM 800 Volts Recommended AC Input Voltage Ea 220 Volts DC Output Current Surge (Non-repetitive) Forward Current IO 25 Amperes IFSM 550 Amperes I2t 1.2 x 103 A2s Volts I2t for Fusing IGBT Inverter Part Collector-Emitter Voltage (G-E Short) VCES 600 Gate-Emitter Voltage (C-E Short) VGES ±20 Volts IC 30 Amperes ICM 60 Amperes IE 30 Amperes Emitter Current** (Pulse)* IEM 60 Amperes Maximum Collector Dissipation PC 66 Watts Collector Current Collector Current (Pulse)* Emitter Current** Electrical and Mechanical Characteristics, Tj = 25°C unless otherwise specified Characteristics Symbol Test Conditions Min. Typ. Converter Sector Repetitive Reverse Current IRRM VR = VRRM, Tj = 150°C — — 8 mA Forward Voltage Drop VFM IF = 40A — — 1.6 Volts Rth(j-f) Per Diode — — 1.7 °C/W ICES VCE = VCES, VGE = 0V — — 1 mA VGE(th) VCE = 10V, IC = 3.0mA 4.5 6.0 7.5 Volts IGES VGE = VGES, VCE = 0V — — 0.5 µA VCE(sat) VGE = 15V, IC = 30A, Tj = 25°C — 2.1 2.8 Volts VGE = 15V, IC = 30A, Tj = 150°C — 2.15 — Volts — — 3.0 nF — — 2.4 nF — — 0.6 nF VCC = 300V, IC = 30A, VGE = 15V — 90 — nC td(on) VGE1 = VGE2 = 15V, — — 120 nS tr VCC = 300V, IC = 30A, — — 300 nS td(off) Rg = 21Ω, — — 200 nS tf Resistive Load — — 300 nS Volts Thermal Resistance (Junction-to-Fin) IGBT Inverter Sector Collector Cutoff Current Gate-Emitter Threshold Voltage Gate-Emitter Cutoff Current Collector-Emitter Saturation Voltage Input Capacitance Cies Output Capacitance Coes Reverse Transfer Capacitance Cres Total Gate Charge QG Resistive Turn-on Delay Time Load Rise Time Switching Turn-off Delay Time Times Fall Time Units Emitter-Collector Voltage VEC IE = 30A, VGE = 0V — — 2.8 Reverse Recovery Time trr IE = 30A, VGE = 0V, — — 110 nS Reverse Recovery Charge Qrr diE/dt = -60A/µs — 0.08 — µC Rth(j-f) Per IGBT — — 1.9 °C/W Per FWDi — — 2.4 °C/W Thermal Resistance (Junction-to-Fin) 2 VGE = 0V, VCE = 10V Max. * Pulse width and repetition rate should be such that device junction temperature does not exceed maximum rating. ** Characteristics of the anti-parallel emitter-collector free-wheel diode. Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 CM30MD3-12H CI Module Single Phase Converter + Three Phase Inverter 30 Amperes/600 Volts 60 60 5 VGE = 20V 40 11 30 10 20 9 10 7 50 40 30 20 10 8 0 0 0 2 4 6 8 10 4 3 2 1 0 0 4 8 12 16 0 20 10 20 30 40 50 GATE-EMITTER VOLTAGE, VGE, (VOLTS) COLLECTOR-CURRENT, IC, (AMPERES) COLLECTOR-EMITTER SATURATION VOLTAGE CHARACTERISTICS (TYPICAL) FREE-WHEEL DIODE FORWARD CHARACTERISTICS (TYPICAL) CAPACITANCE VS. VCE (TYPICAL) Tj = 25°C IC = 60A 6 IC = 30A 4 2 CAPACITANCE, Cies, Coes, Cres, (nF) EMITTER CURRENT, IE, (AMPERES) 8 101 Cies 100 Coes 10-1 Cres VGE = 0V f = 1MHz IC = 12A 100 8 12 16 0 20 0.8 1.6 2.4 3.2 HALF-BRIDGE SWITCHING CHARACTERISTICS (TYPICAL) REVERSE RECOVERY CHARACTERISTICS (TYPICAL) 103 103 REVERSE RECOVERY TIME, t rr, (ns) tf 102 td(on) VCC = 300V VGE = ±15V RG = 21Ω Tj = 125°C tr 101 100 101 COLLECTOR CURRENT, IC, (AMPERES) 102 Irr 101 100 t rr 101 EMITTER CURRENT, IE, (AMPERES) 101 102 GATE CHARGE, VGE 101 102 100 COLLECTOR-EMITTER VOLTAGE, VCE, (VOLTS) di/dt = -60A/µsec Tj = 25°C td(off) 10-2 10-1 4.0 EMITTER-COLLECTOR VOLTAGE, VEC, (VOLTS) 100 10-1 102 20 GATE-EMITTER VOLTAGE, VGE, (VOLTS) 4 GATE-EMITTER VOLTAGE, VGE, (VOLTS) REVERSE RECOVERY CURRENT, Irr, (AMPERES) 0 0 60 101 102 Tj = 25°C SWITCHING TIME, (ns) VGE = 15V Tj = 25°C Tj = 125°C COLLECTOR-EMITTER VOLTAGE, VCE, (VOLTS) 10 COLLECTOR-EMITTER SATURATION VOLTAGE, VCE(sat), (VOLTS) COLLECTOR-EMITTER SATURATION VOLTAGE, VCE(sat), (VOLTS) VCE = 10V Tj = 25°C Tj = 125°C 12 15 COLLECTOR CURRENT, IC, (AMPERES) COLLECTOR CURRENT, IC, (AMPERES) Tj = 25oC 50 COLLECTOR-EMITTER SATURATION VOLTAGE CHARACTERISTICS (TYPICAL) TRANSFER CHARACTERISTICS (TYPICAL) OUTPUT CHARACTERISTICS (TYPICAL) 16 VCC = 200V VCC = 300V 12 8 4 0 0 20 40 60 80 100 120 GATE CHARGE, QG, (nC) 3 Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 10-3 101 TRANSIENT THERMAL IMPEDANCE CHARACTERISTICS (IGBT) 10-2 10-1 100 100 10-1 10-1 10-2 10-2 10-3 Zth = Rth • (NORMALIZED VALUE) 10-5 TIME, (s) 4 101 Single Pulse TC = 25°C Per Unit Base = R th(j-f) = 1.9°C/W 10-4 10-3 10-3 NORMALIZED TRANSIENT THERMAL IMPEDANCE, Z th(j-f) NORMALIZED TRANSIENT THERMAL IMPEDANCE, Z th(j-f) CM30MD3-12H CI Module Single Phase Converter + Three Phase Inverter 30 Amperes/600 Volts 10-3 101 TRANSIENT THERMAL IMPEDANCE CHARACTERISTICS (FWDi) 10-2 10-1 100 101 Single Pulse TC = 25°C Per Unit Base = R th(j-f) = 2.4°C/W 100 10-1 10-1 10-2 10-2 10-3 Zth = Rth • (NORMALIZED VALUE) 10-5 TIME, (s) 10-4 10-3 10-3