HV5308 HV5408 32-Channel Serial To Parallel Converter With High Voltage Push-Pull Outputs Ordering Information Package Options Device 44 J-Lead Quad Ceramic Chip Carrier 44 J-Lead Quad Plastic Chip Carrier 44 Lead Quad Plastic Gullwing Die 44 J-Lead Quad Ceramic Chip Carrier (MIL-STD-883 Processed*) HV5308 HV5308DJ HV5308PJ HV5308PG HV5308X RBHV5308DJ HV5408 HV5408DJ HV5408PJ HV5408PG HV5408X RBHV5408DJ * For Hi-Rel process flows, please refer to perfer to page 5-3 in the Databook. Features General Description ❏ Processed with HVCMOS® technology The HV53 and HV54 are low voltage serial to high voltage parallel converters with push-pull outputs. These devices have been designed for use as drivers for AC-electroluminescent displays. They can also be used in any application requiring multiple output high voltage current sourcing and sinking capabilities such as driving plasma panels, vacuum fluorescent, or large matrix LCD displays. ❏ Low power level shifting ❏ Source/sink current minimum 20mA ❏ Shift register speed 8MHz ❏ Latched data outputs ❏ CMOS compatible inputs ❏ Forward and reverse shifting options ❏ Diode to VPP allows efficient power recovery Absolute Maximum Ratings1 Supply voltage, VDD2 -0.5V to +16V Supply voltage, VPP -0.5V to +90V Logic input levels2 -0.5 to VDD + 0.5V 3 Ground current 1.5A Continuous total power dissipation 4 Plastic Ceramic 1200mW 1500mW Operating temperature range Plastic Ceramic -40°C to +85°C -55°C to 125°C Storage temperature range Lead temperature 1.6mm (1/16 inch) from case for 10 seconds These devices consist of a 32-bit shift register, 32 latches, and control logic to enable outputs. Q1 is connected to the first stage of the shift register through the Output Enable logic. Data is shifted through the shift register on the low to high transition of the clock. The HV54 shifts in the counterclockwise direction when viewed from the top of the package and the HV53 shifts in the clockwise direction. A data output buffer is provided for cascading devices. This output reflects the current status of the last bit of the shift register (32). Operation of the shift register is not affected by the LE (latch enable) or the OE (output enable) inputs. Transfer of data from the shift register to the latch occurs when the LE input is high. The data in the latch is retained when LE is low. -65°C to +150°C 260°C Notes: 1. Device will survive (but operation may not be specified or guaranteed) at these extremes. 2. All voltages are referenced to GND. 3. Duty cycle is limited by the total power dissipated in the package. 4. For operation above 25°C ambient derate linearly to maximum operating temperature at 20mW/°C for plastic and at 15mW/°C for ceramic. 12/13/01 Supertex Inc. does not recommend the use of its products in life support applications and will not knowingly sell its products for use in such applications unless it receives an adequate "products liability indemnification insurance agreement." Supertex does not assume responsibility for use of devices described and limits its liability to the replacement of devices determined to be defective due to 1 workmanship. No responsibility is assumed for possible omissions or inaccuracies. Circuitry and specifications are subject to change without notice. For the latest product specifications, refer to the Supertex website: http://www.supertex.com. For complete liability information on all Supertex products, refer to the most current databook or to the Legal/Disclaimer page on the Supertex website. HV5308/HV5408 Electrical Characteristics (VPP = 60V, VDD = 12V, TA =25°C) DC Characteristics Symbol Parameter Min Max Units Conditions IPP VPP Supply Current 0.5 mA HVoutputs HIGH to LOW IDDQ IDD Supply Current (Quiescent) 100 µA All inputs = VDD or GND IDD IDD Supply Current (Operating) 15 mA VDD = VDD max, fCLK = 8 MHz VOH (Data) Shift Register Output Voltage VOL (Data) Shift Register Output Voltage IIH 10.5 V IO = 100µA 1 V IO = 100µA Current Leakage, any input 1 µA VIN = VDD IIL Current Leakage, any input -1 µA VIN = 0 VOC HV Output Clamp Diode Voltage -1.5 V IOL = -100mA VOH HV Output when Sourcing V IOH = -20mA, -40 to 85°C VOL HV Output when Sinking V IOL = 20mA, -40 to 85°C VOH HV Output when Sourcing V IOH = -15mA, -55 to 125°C VOL HV Output when Sinking V IOL = 15mA, -55 to 125°C 52 8 52 8 AC Characteristics Symbol Parameter Min Max Units 8 MHz fCLK Clock Frequency tWL or tWH Clock width, HIGH or LOW 62 ns tSU Setup time before CLK rises 25 ns tH Hold time after CLK rises 10 ns tDLH (Data) Data Output Delay after L to H CLK 110 ns CL = 15pF tDHL (Data) Data Output Delay after H to L CLK 110 ns CL = 15pF tDLE LE Delay after L to H CLK 50 ns tWLE Width of LE Pulse 50 ns tSLE LE Setup Time before L to H CLK 50 ns tON Delay from LE to HVOUT, L to H 500 ns tOFF Delay from LE to HVOUT, H to L 500 ns Recommended Operating Conditions (over -40 to 85°C for plastic and -55°C to 125°C for ceramic) Symbol Parameter Min Max VDD Logic Voltage Supply 10.8 13.2 V VPP High Voltage Supply 8.0 80 V VIH Input HIGH Voltage VDD-2 VDD V VIL Input LOW Voltage 0 2 V fCLK Clock Frequency 0 8 MHz Note: Power-up sequence should be the following: 1. Connect ground. 2. Apply VDD. 3. Set all inputs (Data, CLK, LE, etc.) to a known state. 4. Apply VPP. 5. The VPP should not fall below VDD or float during operation. Power-down sequence should be the reverse of the above. 2 Units Conditions HV5308/HV5408 Input and Output Equivalent Circuits VDD VDD VPP Data Out Input HVOUT GND GND GND Logic Data Output Logic Inputs High Voltage Outputs Switching Waveforms VIH Data Input 50% Data Valid 50% VIL tSU tH VIH Clock 50% 50% 50% tWL 50% VIL tWH VOH 50% VOL tDLH Data Out VOH 50% VOL tDHL Latch Enable VIH 50% 50% VOL tDLE tWLE tSLE 90% 10% Q w/ S/R LOW VOH VOL tOFF Q w/ S/R HIGH 10% tON 3 90% VOH VOL HV5308/HV5408 Functional Block Diagram VPP Output Enable Latch Enable Data Input HVOUT1 Clock 32 Bit Shift Register 32 Latches HVOUT2 • • • 32 Outputs Total • • • HVOUT31 Data Out HVOUT32 Function Tables Data Input CLK* H H L L X * Data Output No No Change = LOW-to-HIGH level transition Data Input LE OE HV Output X X L All HVOUT = LOW X L H Previous Latched Data H H H H L H H L 4 HV5308/HV5408 Pin Configuration Package Outline HV53 44 Pin J-Lead Package Pin 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 Function HVOUT 17 HVOUT 16 HVOUT 15 HVOUT 14 HVOUT 13 HVOUT 12 HVOUT 11 HVOUT 10 HVOUT 9 HVOUT 8 HVOUT 7 HVOUT 6 HVOUT 5 HVOUT 4 HVOUT 3 HVOUT 2 HVOUT 1 Data Out N/C N/C N/C Clock 39 38 37 36 35 34 33 32 31 30 29 Pin 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 Function GND VPP VDD Latch Enable Data In Output Enable N/C HVOUT 32 HVOUT 31 HVOUT 30 HVOUT 29 HVOUT 28 HVOUT 27 HVOUT 26 HVOUT 25 HVOUT 24 HVOUT 23 HVOUT 22 HVOUT 21 HVOUT 20 HVOUT 19 HVOUT 18 Function HVOUT16 HVOUT17 HVOUT18 HVOUT19 HVOUT20 HVOUT21 HVOUT22 HVOUT23 HVOUT24 HVOUT25 HVOUT26 HVOUT27 HVOUT28 HVOUT29 HVOUT30 HVOUT31 HVOUT32 Data Out N/C N/C N/C Clock Pin 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 Function GND VPP VDD Latch Enable Data In Output Enable N/C HVOUT1 HVOUT2 HVOUT3 HVOUT4 HVOUT5 HVOUT6 HVOUT7 HVOUT8 HVOUT9 HVOUT10 HVOUT11 HVOUT12 HVOUT13 HVOUT14 HVOUT15 28 41 27 42 26 43 25 44 24 1 23 2 22 3 21 4 20 5 19 6 18 7 8 9 10 11 12 13 14 15 16 17 top view 44-pin J-Lead Package HV54 44 Pin J-Lead Package Pin 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 40 5 HV5308/HV5408 Pin Configuration Package Outline HV53 44 Pin Quad Plastic Gullwing Package Pin 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 Function HVOUT 22 HVOUT 21 HVOUT 20 HVOUT 19 HVOUT 18 HVOUT 17 HVOUT 16 HVOUT 15 HVOUT 14 HVOUT 13 HVOUT 12 HVOUT 11 HVOUT 10 HVOUT 9 HVOUT 8 HVOUT 7 HVOUT 6 HVOUT 5 HVOUT 4 HVOUT 3 HVOUT 2 HVOUT 1 Pin 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 Function Data Out N/C N/C N/C Clock GND VPP VDD Latch Enable Data In Output Enable N/C HVOUT 32 HVOUT 31 HVOUT 30 HVOUT 29 HVOUT 28 HVOUT 27 HVOUT 26 HVOUT 25 HVOUT 24 HVOUT 23 44 43 42 41 40 39 38 37 36 35 34 1 33 2 32 3 31 4 30 5 29 6 28 7 27 8 26 9 25 10 24 11 23 12 13 14 15 16 17 18 19 20 21 22 top view 44-pin Quad Plastic Gullwing Package HV54 44 Pin Quad Plastic Gullwing Package Pin 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 Function HVOUT11 HVOUT12 HVOUT13 HVOUT14 HVOUT15 HVOUT16 HVOUT17 HVOUT18 HVOUT19 HVOUT20 HVOUT21 HVOUT22 HVOUT23 HVOUT24 HVOUT25 HVOUT26 HVOUT27 HVOUT28 HVOUT29 HVOUT30 HVOUT31 HVOUT32 Pin 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 Function Data Out N/C N/C N/C Clock GND VPP VDD Latch Enable Data In Output Enable N/C HVOUT1 HVOUT2 HVOUT3 HVOUT4 HVOUT5 HVOUT6 HVOUT7 HVOUT8 HVOUT9 HVOUT10 12/13/010 ©2001 Supertex Inc. All rights reserved. Unauthorized use or reproduction prohibited. 6 1235 Bordeaux Drive, Sunnyvale, CA 94089 TEL: (408) 744-0100 • FAX: (408) 222-4895 www.supertex.com