2N5404 2N5405 2N5406 2N5407 MECHANICAL DATA Dimensions in mm SMALL SIGNAL PNP TRANSISTORS IN TO-5 8.89 (0.35) 9.40 (0.37) 7.75 (0.305) 8.51 (0.335) 4.19 (0.165) 4.95 (0.195) 12.70 (0.500) min. 0.89 max. (0.035) APPLICATIONS 0.41 (0.016) 0.53 (0.021) dia. Small signal PNP transistors for relay switching resistor logic circuits and general purpose applications. 5.08 (0.200) typ. 2.54 (0.100) 2 1 3 0.66 (0.026) 1.14 (0.045) 0.71 (0.028) 0.86 (0.034) 45° TO-5 Pin1 - Emitter Pin2 - Base Pin3 - Collector ABSOLUTE MAXIMUM RATINGS (Tcase = 25°C unless otherwise stated) 2N5404 2N5405 2N5406 2N5407 BVCBO Collector – Base Breakdown Voltage – 80V – 100V – 80V – 100V BVCEO Collector – Emitter Breakdown Voltage – 80V – 100V – 80V – 100V BVEBO Emitter – Base Breakdown Voltage – 6V –6V – 6V –6V IC(Max) Collector Current – 5A -5A – 5A -5A IB(Max) Base Current – 2A – 2A – 2A – 2A PTOT Total Power Dissipation (100°C Case) 5W 5W 5W 5W TSTG , TJ Operating and Storage Temperature – 65°C to +200°C Range Semelab Plc reserves the right to change test conditions, parameter limits and package dimensions without notice. Information furnished by Semelab is believed to be both accurate and reliable at the time of going to press. However Semelab assumes no responsibility for any errors or omissions discovered in its use. Semelab encourages customers to verify that datasheets are current before placing orders. Semelab plc. Telephone +44(0)1455 556565. Fax +44(0)1455 552612. E-mail: [email protected] Website: http://www.semelab.co.uk Document Number 3075 Issue 1 2N5404 2N5405 2N5406 2N5407 ELECTRICAL CHARACTERISTICS (Tcase = 25°C unless otherwise stated) Parameter ICEX Collector Cut-Off Current Test Conditions VCE =BVCEO VBE = 1.5V VCE =BVCEO VBE = 1.5V Min. – 10 – 500 TC = 150°C VCEO(SUS) ICEO Collector-Emitter Sustaining Voltage With Base Open Collector Cut-Off Current IEBO Common Emitter, Small-Signal Value hFE IC = –100mA IB = 0 IC = –100mA IB = 0 VCE = – 50V IC = 0 VEB = – 4V IC = 0 IC = – 2A VCE = – 5V of the Short-Circuit Forward Current Typ. Max. Unit 2N5404 2N5406 2N5405 2N5407 –80 V –100 –100 µA –1 2N5404 2N5405 2N5406 µA 20 µA 60 – Transfer Ratio (f = 1KHz) IC = – 2A VCE = – 5V VCE(SAT) Collector-Emitter Saturation Voltage IC = – 2A IB = – 0.2A –0.6 V IC = – 2A IB = – 0.2A –1.2 V 150 pf VBE (SAT) Base-Emitter Saturation Voltage 2N5407 40 120 DYNAMIC CHARACTERISTICS COBO Collector Base Capacitance VCB = – 10V f = 1MHz ft Transistion Frequency VCE = – 5V IC = – 0.2A tr Rise Time ts tf Storage time Fall Time 40 IC = – 2A MHz 0.5 IB1 = – IB2 = 0.2A IC = – 2A 2N5404 IB1 = – IB2 = 0.2A 2N5405 IC = – 2A 2N5406 IB1 = – IB2 = 2A 2N5407 IC = –2A 2N5404 IB1 = – IB2 = 2A 2N5405 IC = –2A 2N5406 IB1 = – IB2 = 2A 2N5407 µ 0.75 µ 1 0.2 µ 0.3 * Pulse test : Pulse Width < 300µs ,Duty Cycle < 2% Semelab Plc reserves the right to change test conditions, parameter limits and package dimensions without notice. Information furnished by Semelab is believed to be both accurate and reliable at the time of going to press. However Semelab assumes no responsibility for any errors or omissions discovered in its use. Semelab encourages customers to verify that datasheets are current before placing orders. Semelab plc. Telephone +44(0)1455 556565. Fax +44(0)1455 552612. E-mail: [email protected] Website: http://www.semelab.co.uk Document Number 3075 Issue 1