BeRex BG14A 5-4000 MHz Cascadeable InGaP HBT Gain Block Device Features 37.5dBm Output IP3 at 9dBm/tone at 900MHz 16.7dB Gain at 900MHz 19.7dBm P1dB at 900MHz Highly Reliable InGaP/GaAs HBT Technology Temperature Compensation Circuit patent SOT-89 Surface Mount Package 50 ohm Cascadeable Lead-free/Green/RoHS compliant Application: commercial, space, military wireless system Electrical Specifications (Ta = 25C, Vs = 5.0V) Parameters Test Conditions Frequency Range Gain S11 S22 OIP3 P1dB Ic Vc dG/dT Rth 70 MHz 900 MHz 1900 MHz 2450 MHz 70 MHz 900 MHz 1900 MHz 2450 MHz 70 MHz 900 MHz 1900 MHz 2450 MHz 70 MHz 900 MHz 1900 MHz 2450 MHz 70 MHz 900 MHz 1900 MHz 2450 MHz Vc = 5.0V Thermal Resistance Min 5 16.0 15,7 15.0 14.4 36.0 35.5 33.5 32.5 18.7 18.7 18.7 18.7 78 Typ 17.0 16.7 16.0 15.4 -17.0 -19.0 -20.0 -23.0 -17.0 -13.0 -15.0 -14.0 38.0 37.5 35.5 34.5 19.7 19.7 19.7 19.7 85 5.0 -0.004 85 Max Unit 4000 18.0 17.7 17.0 16.4 MHz dB dB dB dBm dBm 95 mA V dB/C C/W Test conditions unless otherwise noted. 1. Device performance is measured on BeRex evaluation board at 25C, 50 ohm system 2. OIP3 measured with two tones at an output power of 9dBm/tone separated by 1MHz. http: //www.berex.com BeRex BG14A Absolute Maximum Ratings Parameters Rating Operating Case temperature Storage Temperature Junction Temperature Operating Voltage Supply Current Input RF Power -40 to +85C -55 to +155C +220C +5.5V 150mA 23dBm Operation of this device above any of these parameters may result in permanent damage. [I-V Characteristics] [Generic SOT89 Evaluation Board] Icc [mA] I-V 140 120 100 80 60 40 20 0 BeRex +25C -30C +85C Evaluation Board MMIC Innovator 0 1 2 3 4 5 6 *Dielectric constant is 4.2 *RF pattern width 52mil *31mil thick FR4 PCB Vcc [V] Application Circuit: 5-4000 MHz Schematic Diagram C3 C4 BOM C5 +5V Tolerance *C1 100pF ±5% *C2 100pF ±5% C3 100pF ±5% C4 1000pF ±5% C5 10uF ±20% *L1 39nH 5% L1 RFin C2 C1 RFout BG14A *Note1: Less than 20nH improves RF performance at frequencies over 1.9GHz. 40nH or higher value L1 improves RF performance at frequencies under 500MHz. Optimum value of L1 may vary with board design. *Note2: C1, C2 = 8200pF, L1 = 1200nH for 70 MHz application, Vcc = 5.2V if 1200nH is used to compensate IR drop across L1 http: //www.berex.com BeRex BG14A Typical Device Data S-parameters (Vc=5V, Ic=85mA, T=25C) S-Parameter (Vdevice = 5.0V, Icc = 85mA, T = 25 C, calibrated to device leads) Freq [MHz] S11 Mag S11 Ang 100 500 1000 1500 2000 2500 3000 3500 4000 0.3594 0.2386 0.2243 0.2122 0.2016 0.1934 0.1882 0.1858 0.1861 -114 -174.2 167.2 155.8 147.5 141.3 136.5 132.8 129.9 S21 Mag 7.204 7.588 7.145 6.548 5.923 5.339 4.822 4.376 3.994 S21 Ang -136.6 173.1 153.3 138.2 125.6 114.7 105.2 96.71 89.05 S12 Mag 0.05545 0.06055 0.06298 0.06691 0.07234 0.07908 0.08688 0.09554 0.1049 S12 Ang 48.17 16.48 18.74 23.42 27.88 31.52 34.22 36.05 37.13 S22 Mag 0.3891 0.2227 0.2032 0.1833 0.1623 0.1417 0.1221 0.1038 0.08659 S22 Ang 121.6 18.23 -6.43 -20.22 -30.37 -38.68 -46.12 -53.45 -61.46 http: //www.berex.com BeRex BG14A Typical Performance (Vc = 5V, Ic = 85mA, Ta = 25C) Freq MHz 70 500 900 1900 S21 dB 17.0 17.3 16.7 16.0 S11 dB -20.0 -18.5 -17.5 -27.5 S22 dB -13.0 -14.0 -15.0 -10.5 P1 dBm 20.0 20.0 19.5 19.5 OIP3 dBm 38.0 39.0 37.5 35.5 NF dB 5.4 5.5 5.5 6.0 2140 15.7 -23.0 -11.5 19.5 35.5 6.1 2450 15.4 -19.0 -10.0 19.5 34.5 6.3 3500 15.2 -16.0 -13.0 19.5 33.0 6.6 Typical Performance (Vc = 4.7V, Ic = 79mA, Ta = 25C) Freq MHz 70 500 900 1900 S21 dB 17.1 16.6 16.6 15.6 S11 dB -12.4 -20.6 -19.8 -23.4 S22 dB -8.7 -11.9 -12.8 -10.2 P1 dBm 18.4 19.1 19.2 19.3 OIP3 dBm 37.5 37.5 36.0 35.0 NF dB 5.4 5.5 5.5 6.0 2140 15.3 -22.1 -9.5 19.2 34.0 6.1 2450 15.1 -21.6 -11.2 19.2 33.5 6.3 3500 14.3 -23.2 -16.9 18.3 31.5 6.6 Typical Performance (Vc = 4.5V, Ic = 69mA, Ta = 25C) Freq MHz 70 500 900 1900 S21 dB 16.9 16.9 16.5 15.9 S11 dB -12.6 -21.2 -20.3 -23.5 S22 dB -8.6 -11.8 -12.6 -10.1 P1 dBm 17.9 17.9 17.4 17.5 OIP3 dBm 37.5 37.5 33.5 32.5 NF dB 5.4 5.5 5.5 6.0 2140 15.3 -21.9 -9.4 17.5 32.5 6.1 2450 15.0 -21.7 -11.1 17.3 32.5 6.3 3500 14.3 -23.7 -16.9 16.7 30.5 6.6 Typical Performance (Vc = 4V, Ic = 45mA, Ta = 25C) Freq MHz 70 500 900 1900 S21 dB 16.7 16.2 16.2 15.3 S11 dB -13.5 -24.0 -23.0 -23.2 S22 dB -8.3 -11.1 -11.8 -9.6 P1 dBm 14.5 14.7 14.7 14.3 OIP3 dBm 29.5 27.5 27.5 28.0 NF dB 5.4 5.5 5.5 6.0 2140 15.0 -21.2 -9.0 13.7 27.0 6.1 2450 14.8 -21.8 -10.6 14.4 27.5 6.3 3500 14.1 -27.1 -16.2 14.5 27.0 6.6 http: //www.berex.com BeRex BG14A WCDMA 4FA 2140 -60dBc WCDMA 6FA 2140 -60dBc http: //www.berex.com BeRex BG14A ACLR Device Performance Pin-Pout-Gain 25 35% 30% 20 30% 25% 20 10 15% 20% Po, G 20% PAE Po, G 25% 15 15 15% 10 10% 10% 5 5% 0 0% -15 -10 -5 0 5 Pin [dBm ] 900MHz, 5V/85mA 10 PAE 25 5 5% 0 0% -15 -10 -5 0 5 10 Pin [dBm ] 1900 MHz, 5V/85mA http: //www.berex.com BeRex BG14A OIP3 F1=900, F2=901MHz 40 40 38 38 OIP3 [dBm] OIP3 [dBm] F1=500, F2=501MHz 36 34 36 34 32 32 +25C -30C +25C +85C 8 10 12 14 8 16 10 12 14 16 F1=2140, F2=2141MHz F1=1900, F2=1901MHz 40 40 +25C -30C +25C +85C 38 -30C +85C 38 OIP3 [dBm] OIP3 [dBm] +85C Po,tot [dBm ] Po,tot [dBm ] 36 34 32 36 34 32 30 30 8 10 12 14 16 8 10 Po,tot [dBm ] 12 14 16 Po,tot [dBm ] OIP3 Po=7dBm /tone, D F=1MHz F1=2450, F2=2451MHz 40 40 +25C -30C +85C 38 38 OIP3 [dBm] OIP3 [dBm] -30C 30 30 36 34 36 34 32 32 30 30 500 +25C 8 10 12 Po,tot [dBm ] 14 16 1000 -30C 1500 +85C 2000 2500 Freq [MHz] http: //www.berex.com BeRex BG14A ACPR F=900MHz, IS-95A, 9CH-FWD 885KHz Offset F=500MHz, IS-95A, 9CH-FWD 885KHz Offset 0 0 -30C +85C -10 -10 -20 -20 ACPR [dBc] ACPR [dBc] +25C -30 -40 -50 -30C +85C -30 -40 -50 -60 -60 -70 -70 -80 +25C -80 8 10 12 14 16 8 10 12 Po [dBm ] 14 16 Po [dBm ] F=1900MHz, IS-95A, 9CH-FWD 885KHz Offset IS-95A, 9CH-FWD, 885KHz Offset Po satisfies -45dBc 0 20 +25C -30C +85C +25C -30C +85C -10 18 Po [dBm] -30 -40 -50 16 14 -60 12 -70 -80 8 10 12 14 10 500 16 1000 Po [dBm ] 1500 2000 Freq [MHz] Gain Flatness S21 vs Temperature 18 16 S21 [dB] ACPR [dBc] -20 14 12 +25C -30C +85C 10 0 500 1000 1500 2000 2500 3000 3500 4000 Freq [MHz] http: //www.berex.com BeRex BG14A Package Outline Dimension Suggested PCB Land Pattern and PAD Layout PCB Land Pattern PCB Mounting 0.40 1.30 0.40 Ø0.40 0.40 0.75 1.20 2.00 1.20 0.50 1.20 1.20 2.80 1.50 1.00 0.65 Note : All dimension are in millimeters Visit http://www.berex.com for PCB layout http: //www.berex.com BeRex BG14A Tape & Reel Packaging information: SOT89 Tape Width (mm): 12 Reel Size (inches): 7 Device Cavity Pitch (mm): 8 Devices Per Reel: 1000 Lead plating finish 100% Tin Matte finish. (All BeRex products undergoes a 1 hour, 150 degree C, Anneal bake to eliminate thin whisker growth concerns) MSL / ESD Rating ESD Rating: Value: Test: Standard: Class 1C Passes <2000V Human Body Model (HBM) JEDEC Standard JESD22-A114B MSL Rating: Standard: Level 1 at +265C convection reflow JEDEC Standard J-STD-020 NATO CAGE code: 2 N 9 6 F NOTICE BeRex Corporation reserves the right to make changes of product specification or to discontinue product at any time without notice. http: //www.berex.com