BeRex BG17C 5-4000 MHz Cascadeable InGaP HBT Gain Block Device Features 31dBm Output IP3 at 2dBm/tone at 900MHz 18dB Gain at 500MHz 17.5dBm P1dB at 900MHz Highly Reliable InGaP/GaAs HBT Technology Temperature Compensation Circuit patent SOT-89 Surface Mount Package 50 ohm Cascadeable Lead-free/Green/RoHS compliant Application: commercial, space, military wireless system Electrical Specifications (Ta = 25C, Vs = 5V) Parameters Test Conditions Frequency Range Gain S11 S22 OIP3 P1dB Ic Vc dG/dT Rth 500 MHz 900 MHz 1900 MHz 2450 MHz 500 MHz 900 MHz 1900 MHz 2450 MHz 500 MHz 900 MHz 1900 MHz 2450 MHz 500 MHz 900 MHz 1900 MHz 2450 MHz 500 MHz 900 MHz 1900 MHz 2450 MHz Vc = 5.0V Thermal Resistance Min 5 17.0 16.8 15.4 14.6 29.0 29.0 28.0 27.0 16.1 16.5 16.0 15.1 45 Typ 18.0 17.8 16.4 15.6 -20.0 -16.0 -35.0 -20.0 -17.0 -17.0 -15.0 -12.0 31.0 31.0 30.0 29.0 17.1 17.5 17.0 16.1 55 5.0 -0.004 50 Max Unit 4000 19.0 18.8 17.4 16.6 MHz dB dB dB dBm dBm 65 mA V dB/C C/W Test conditions unless otherwise noted. 1. Device performance is measured on BeRex evaluation board at 25C, 50 ohm system. 2. OIP3 measured with two tones at an output power of 2dBm/tone separated by 1MHz. http: //www.berex.com BeRex BG17C Absolute Maximum Ratings Parameters Rating Operating Case temperature Storage Temperature Junction Temperature Operating Voltage Supply Current Input RF Power -40 to +85C -55 to +155C +220C 6.5V 150mA 23dBm Operation of this device above any of these parameters may result in permanent damage. [I-V Characteristics] [Generic SOT89 Evaluation Board] 100 +25C -30C +85C Icc [mA] 80 BeRex Evaluation Board 60 40 20 MMIC Innovator 0 0 1 2 3 4 5 6 *Dielectric constant is 4.2 *RF pattern width 52mil *31mil thick FR4 PCB Vcc [V] Application Circuit: 5 - 4000 MHz Schematic Diagram C3 C4 BOM C5 +5V L1 RFin C2 C1 BG17C RFout Tolerance C1 100pF ±5% C2 100pF ±5% C3 100pF ±5% C4 1000pF ±5% C5 10uF ±20% *L1 33nH 5% *Note: Less than 20nH improves RF performance at frequencies over 1.9GHz. 40nH or higher value L1 improves RF performance at frequencies under 500MHz. Optimum value of L1 may vary with board design. http: //www.berex.com BeRex BG17C Typical Device Data S-parameters (Vc=5V, Ic=55mA, T=25C) S-Parameter (Vdevice = 5.0V, Icc = 55mA, T = 25 C) Freq [MHz] 100 500 1000 1500 2000 2500 3000 3500 4000 S11 Mag 0.69 0.18 0.05 0.01 0.09 0.20 0.27 0.25 0.11 S11 Ang -38.43 -118.50 160.30 37.15 -127.10 -163.40 168.40 137.30 108.30 S21 Mag 4.94 7.99 7.76 7.31 6.49 6.07 5.57 5.33 5.18 S21 Ang -122.90 126.10 48.67 -22.00 -91.16 -156.00 142.10 76.86 10.32 S12 Mag 0.04 0.08 0.08 0.08 0.08 0.08 0.08 0.09 0.09 S12 Ang 86.86 -28.03 -90.43 -144.70 162.40 111.90 61.34 9.56 -45.02 S22 Mag 0.77 0.18 0.08 0.16 0.25 0.31 0.35 0.31 0.16 S22 Ang 170.20 39.68 -78.90 -154.80 175.50 156.20 134.50 104.60 47.31 http: //www.berex.com BeRex BG17C Typical Performance (Vc = 5V, Ic = 55mA, Ta = 25C) Freq MHz 500 900 1900 2140 S21 dB 18.0 17.8 16.4 16.0 S11 dB -15.0 -14.0 -24.0 -16.0 S22 dB -14.0 -22.0 -12.0 -11.0 P1 dBm 17.1 17.5 17.0 17.0 OIP3 dBm 31.0 31.0 30.0 30.0 NF dB 3.8 3.9 4.0 4.0 2450 15.6 -14.0 -10.0 16.1 29.0 4.0 3000 15.0 -11.0 -9.0 15.2 28.0 4.2 3500 14.9 -20 -12.1 15 27.5 4.2 Typical Performance (V device = 4.7 V, Ic = 43 mA, Ta = 25 ℃) Freq S21 S11 S22 P1 OIP3 NF MHz dB dB dB dBm dBm dB 70 20.0 -13 -5.9 13.9 28.5 3.8 500 18.0 -20.2 -10.9 14.4 26 3.8 900 17.6 -24 -14.7 14.9 27.5 3.9 1900 16.0 -15.3 -10.4 14.2 27.5 4.0 2140 15.8 -14.6 -10.1 13.9 26.5 4.0 2450 15.5 -16.7 -11.2 14.6 27 4.0 3500 14.7 -18.9 -11.9 14.0 26 4.2 2140 15.7 -14.1 -9.7 13.2 24 4.0 2450 15.3 -16.1 -10.9 12.7 24.0 4.0 3500 14.6 -18 -11.6 12.5 23.5 4.2 Typical Performance (V device = 4.5 V, Ic = 37 mA, Ta = 25 ℃) Freq S21 S11 S22 P1 OIP3 NF MHz dB dB dB dBm dBm dB 70 19.5 -12.5 -5.8 13.6 27.5 3.8 500 17.8 -18.7 -10.5 14.3 27.0 3.8 900 17.4 -21.7 -13.9 14.3 24.5 3.9 1900 15.9 -14.7 -10.1 13.7 24.5 4.0 http: //www.berex.com BeRex BG17C WCDMA 4FA 2140 -60dBc WCDMA 6FA 2140 -60dBc http: //www.berex.com BeRex BG17C ACLR Device Performance Pin-Pout-Gain 35% 30% 20 25 30% 20 25% 10 15% 20% Po/G 20% PAE Po/G 25% 15 15 15% 10 10% 10% 5 0 -15 5% 0% -10 -5 0 5 Pin [dBm ] 900MHz, 5V/55mA PAE 25 5 5% 0 -15 0% -10 -5 0 5 Pin [dBm ] 1900 MHz, 5V/55mA http: //www.berex.com BeRex BG17C OIP3 F1=900, F2=901MHz 35 35 33 33 OIP3 [dBm] OIP3 [dBm] F1=500, F2=501MHz 31 29 31 29 27 27 +25C -30C +25C +85C 4 6 8 10 4 12 6 F1=1900, F2=1901MHz 8 10 12 F1=2140, F2=2141MHz 35 35 +25C -30C +25C +85C 33 -30C +85C 33 OIP3 [dBm] OIP3 [dBm] +85C Po,tot [dBm ] Po,tot [dBm ] 31 29 27 31 29 27 25 25 4 6 8 10 12 4 6 Po,tot [dBm ] 8 10 12 Po,tot [dBm ] F1=2450, F2=2451MHz OIP3 Po=2dBm /tone, D F=1MHz 35 32 +25C -30C +85C 30 33 OIP3 [dBm] OIP3 [dBm] -30C 25 25 28 26 31 29 24 27 22 25 500 +25C 4 6 8 Po,tot [dBm ] 10 12 1000 -30C 1500 +85C 2000 2500 Freq [MHz] http: //www.berex.com BeRex BG17C ACPR F=900MHz, IS-95A, 9CH-FWD 885KHz Offset F=500MHz, IS-95A, 9CH-FWD 885KHz Offset 0 0 +25C -30C +85C ACPR [dBc] -10 ACPR [dBc] +25C -10 -20 -30 -40 -50 -30C +85C -20 -30 -40 -50 -60 -60 -70 -70 -80 4 6 8 10 12 4 6 8 Po [dBm ] 10 12 Po [dBm ] IS-95A, 9CH-FWD, 885KHz Offset Po satisfies -45dBc F=1900MHz, IS-95A, 9CH-FWD 885KHz Offset 10 0 +25C -30C +85C -10 Po [dBm] -30 -40 6 4 -50 2 -60 +25C -70 4 6 8 10 0 500 12 -30C 1000 Po [dBm ] +85C 1500 2000 Freq [MHz] Gain Flatness Gain vs Temperature 20 18 S21 [dB] ACPR [dBc] 8 -20 16 14 12 +25C -30C +85C 10 0 500 1000 1500 2000 2500 3000 3500 4000 Freq [MHz] http: //www.berex.com BeRex BG17C Package Outline Dimension Suggested PCB Land Pattern and PAD Layout PCB Land Pattern PCB Mounting 0.40 1.30 0.40 Ø0.40 0.40 0.75 1.20 2.00 1.20 0.50 1.20 1.20 2.80 1.50 1.00 0.65 Note : All dimension are in millimeters Visit http://www.berex.com for PCB layout http: //www.berex.com BeRex BG17C Tape & Reel Packaging information: SOT89 Tape Width (mm): 12 Reel Size (inches): 7 Device Cavity Pitch (mm): 8 Devices Per Reel: 1000 Lead plating finish 100% Tin Matte finish. (All BeRex products undergoes a 1 hour, 150 degree C, Anneal bake to eliminate thin whisker growth concerns) MSL / ESD Rating ESD Rating: Value: Test: Standard: Class 2 Passes <4000V Human Body Model (HBM) JEDEC Standard JESD22-A114B MSL Rating: Standard: Level 1 at +265C convection reflow JEDEC Standard J-STD-020 NATO CAGE code: 2 N 9 6 F NOTICE BeRex Corporation reserves the right to make changes of product specification or to discontinue product at any time without notice. http: //www.berex.com