KBP005G THRU KBP10G SINGLE PHASE GLASS PASSIVATED BRIDGE RECTIFIER Voltage: 50 to 1000V Current:1.5A Features KBP Glass passivated chip junction High case dielectric strength High surge current capability Ideal for printed circuit board Mechanical Data Terminal: Plated leads solderable per MIL-STD 202E, Method 208C Case: UL-94 Class V-0 recognized Flame Retardant Epoxy Polarity: Polarity symbol marked on body Mounting position: any Dimensions in millimeters MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (single-phase, half -wave, 60HZ, resistive or inductive load rating at 25°C, unless otherwise stated, for capacitive load, derate current by 20%) Symbol KBP 005G KBP 01G KBP 02G KBP 04G KBP 06G KBP 08G KBP 10G units Maximum repetitive peak reverse voltage Vrrm 50 100 200 400 600 800 1000 V Maximum RMS voltage Vrms 35 70 140 280 420 560 700 V Maximum DC blocking voltage Vdc 50 100 200 400 600 800 1000 V Maximum average forward rectified output current Ta = 40℃ Peak forward surge current single sine-wave superimposed on rated load (JEDEC Method) Maximum instantaneous forward voltage drop per leg at 2.0A If(av) 1.5 A Ifsm 50 A Vf 1.1 V I2t 10 A2Sec Ir 5.0 500 µA Rth(ja) Rth(jl) Rth(jc) 25 8.0 10.0 ℃/W Typical junction capacitance per leg at 4.0V,1MHz Cj 15 pF Operating junction and storage temperature range Tj, Tstg -55 to +150 ℃ Rating for fusing (t < 8.3ms) Maximum DC reverse current at rated DC blocking voltage per leg Typical Thermal Resistance Note: 1. 2. Ta = 25°C Ta = 125°C (Note 1) (Note 1) (Note 2) Thermal Resistance from Junction to Ambient and from Junction to Lead Mounted on P.C.B. with 0.4″×0.4″(10×10mm)copper pads Thermal Resistance from Junction to Case Mounted on heatsink Rev.A2 www.gulfsemi.com RATINGS AND CHARACTERISTIC CURVES KBP005G THRU KBP10G Rev.A2 www.gulfsemi.com