Pluggables OP 10 Gbps Multirate XFP Transceivers 9.95 Gbps - 11.1 Gbps Features 120 km with Electronic Dispersion Compensation (EDC), 80 km, and 40 km reach models XFI high-speed electrical interface 9.95 Gbps, 10.31 Gbps, 10.52 Gbps, 10.7 Gbps, and 11.1 Gbps support Digital Diagnostics Cooled EML with isolator APD receiver (120 km and 80 km) and PIN receiver (40 km) Power consumption under 3.5 watts -5° to 70° C operating temperature range XFP MSA Rev 4.5 compliance RoHS and China RoHS compliance Class 1 Laser, 21CFR 1040.10/1040.11 compliance EN 60825-1/A1:2002 compliance USA and Canada UL listing External reference clock synchronization Absolute Maximum Rating Parameter Symbol Min. Typical Max. Unit Maximum Supply Voltage (3.3V) Vcc3 -0.3 - 3.6 V Maximum Supply Voltage (5.0V) Vcc5 -0.3 - 5.5 V Maximum Supply Voltage (1.8V) Vcc2 -0.3 - 2 V Tst -40 - 85 °C Storage Temperature General Operations Parameter Symbol Min Typical Max Unit Supply Voltage (1.8V) Vcc2 1.71 1.8 1.89 V Supply Voltage (3.3V) Vcc3 3.14 3.3 3.47 V Supply Voltage (5V) Vcc5 4.75 5 5.25 V Icc - - 500 mA Total Current on Any Pin Inrush Current (1.8V) Iinrush2 - - 1 A Inrush Current (3.3V) Iinrush3 - - 0.75 A Inrush Current (5V) Iinrush5 - - 0.5 A Module Current Ramp Rate - - - 100 mA/µS Power on 1.8V Rail P2rail - - 1.8 W Power on 3.3V Rail P3rail - - 2.5 W Power on 5V Rail P5rail - - 2.5 W Pt - - 3.5 W Power Consumption-P_Down Mode Pp_d - - 1.5 W Power Supply Noise Rejection PSNR Module Total Power Consumption Compliant to Section 2.7.2 of XFP MSA Bit Rate BR 9.95 Operating Temperature (case) Top -5 - 70 °C Storage Temperature Tst -40 - 85 °C [email protected] - 11.1 Gbps Pluggables Transmitter Specifications (Electical) Parameter Symbol Min Typical Max Unit Input Differential Impedence Rin - 100 - Ω Differential Data Input Swing Vin,p-p 120 - 820 mV TxDisable_Disable Vd 2 - Vcc3 V TxDisable_Enable Ven GND - GND+0.8 V Transmitter Specifications (Optical) Parameter Output Power: Symbol Min Typical Max Unit XFP-10GD-LR12P PO -2 0 2 dBm XFP-10GD-LR08P PO 0 2 4 dBm PO -1 0.5 2 dBm Average Launch Power Tx_Off Poff - - -30 nm Extinction Ratio: XFP-10GD-LR12P ER 8.2 - - dB XFP-10GD-LR08P ER 9 - - dB XFP-10GD-IR04P ER 8.2 - - dB XFP-10GD-IR04P Eye Mask Side Mode Suppression Ratio Wavelength ITU-T G.691, Telecordia GR-253-CORE, IEEE802.3 10GBASE-ZR Compliant SMSR 30 - - dB λ 1530 - 1565 nm nm Δλ20 - - 1 Jitter Generation (peak-to-peak) Jgen(pk-pk) - - 0.1 UI Jitter Generation (RMS) Jgen(RMS) - - 0.01 UI Dispersion Penalty at 2400 ps/nma DP - - 2 dB Relative Intensity Noise RIN - - -130 dB/Hz Reflectance Tolerance ref T - - -27 dB Symbol Min Typical Max Unit Spectral Width Receiver Specifications (Electrical) Parameter Reference Differential Output Impedence Differential Data Output Swing Output Rise Time, 20-80% Output Fall Time, 20-80% LOS Fault LOS Normal Zd - 100 - Ω Vout,p-p 340 - 850 mV tr 24 - - ps tf 24 - - ps VLOS_fault host_Vcc3 - 0.5 - host_Vcc3 V VLOS_normal GND - GND + 0.4 V [email protected] 2 Pluggables Receiver Specifications (Optical) Parameter Symbol Min Typical Max Unit XFP-10GD-LR12Pa Rxsens995 - - -24 dBm XFP-10GD-LR08Pb Rxsens995 - - -24 dBm XFP-10GD-IR04Pa Rxsens995 -16 dBm Sensitivity (10.7 Gb/s): XFP-10GD-LR12Pa Rxsens1070 - - -23 dBm XFP-10GD-LR08Pb Rxsens1070 - - -23 dBm XFP-10GD-IR04Pa Rxsens1070 - - -15 dBm XFP-10GD-LR12Pa Rx OL -7 - - dBm XFP-10GD-LR08Pb Rx OL -7 - - dBm XFP-10GD-IR04Pa Rx OL 0 - - dBm λ 1528 - 1561 nm ORL - - -27 dB Sensitivity (9.95 Gb/s): Overload: Wavelengthc Optical Return Loss LOS Assert: LOS De-assert: XFP-10GD-LR12P - -34 - - dBm XFP-10GD-LR08P - -34 - - dBm XFP-10GD-IR04P - -24 - - dBm XFP-10GD-LR12P - - - -24 dBm XFP-10GD-LR08P - - - -24 dBm XFP-10GD-IR04P - - - -16 dBm - 0.5 - - dB LOS Hysteresis a) At 8.2dB ER, 1e-12 BER, 231-1 PRBS, back to back b) At 9dB ER, 1e-12 BER, 231-1 PRBS, back to back c) Operational over 1200 - 1625 nm range Reference Clock Parameter Clock Differential Input Impedance Differential Input Clock Amplitude (p-p) Reference Clock Duty Cycle Reference Clock Rise/Fall Time (20%-80%) Reference Clock Frequency Symbol Min Typical Max Zd 80 100 120 Unit Ω - 640 - 1600 mV - 40 - 60 % Tr/Tf 200 - 1250 ps f0 - Baud/64 - MHz [email protected] 3 Pluggables Pin Out Definition Pin Logic Symbol Name/Description Note 1 1 GND Module Ground 2 VEE5 Optional -5.2V power supply (not used) 3 LVTTL-I Mod_DeSel Module De-Select; when held low allows module to respond to 2-wire interface interface 4 LVTTL-O Interrupt Interrupt; indicates presence of an important condition which can be read over the 2-wire serial interface 5 LVTTL-I TX_DIS Transmitter Disable; turns off transmitter laser output 6 Vcc5 +5 V Power Supply 7 GND Module Ground 8 Vcc3 +3.3 V Power Supply 9 Vcc3 +3.3 V Power Supply SCL 2-Wire Serial Interface Clock 2 1 10 LVTTL-I/O 11 LVTTL-I/O SDA 2-Wire Serial Interface Data Line 2 12 LVTTL-O Mod_Abs Indicates module is not present. Grounded in the module 2 13 LVTTL-O Mod_NR Module Not Ready; indicating module operational fault 2 14 LVTTL-O RX_LOS Receiver Loss of Signal Indicator 2 15 GND Module Ground 1 16 GND Module Ground 1 17 CML-O RD- Receiver Inverted Data Output 18 CML-O RD+ Receiver Non-Inverted Data Output 19 GND Module Ground 20 Vcc2 +1.8 V Power Supply 21 LVTTL-I P_Down/RST 2 1 Power Down; When high, requires the module to limit power consumption to 1.5 W or below. 2-wire serial interface must be functional in the low power mode. Reset; the falling edge initiates a complete rest of the module including the 2-wire serial interface, equivalent to a power cycle. 22 Vcc2 +1.8 V Power Supply 23 GND Module Ground 1 24 PECL-I RefCLK+ Reference Clock Non-Inverted Input, AC coupled on the host board 25 PECL-I RefCLK- Reference Clock Inverted Input, AC coupled on the host board 26 GND Module Ground 1 27 GND Module Ground 1 28 CML-I TD- Transmitter Inverted Data Input 29 CML-I TD+ Transmitter Non-Inverted Data Input GND Module Ground 30 Note: 1. Module ground pins GND are isolated from the module case and chassis ground within the module. 2. Shall be pulled up with 4.7k-10kohms to a voltage between 3.15 V and 3.45 V on the host board. [email protected] 4 1 Pluggables Data Rate Wavelength (nm) Dispersion Penalty (dB) Dispersion Spec. (ps/nm) Bail Latch Color Distance (km) XFP-10GD-LR12P 10 GbE or 10G FC single-mode XFP tranceiver with Digital Diagnostics. Requires external reference clock. 9.95 - 11.1 Gbps 1550 2 2400 White 120 XFP-10GD-LR08P 10 GbE or 10G FC single-mode XFP tranceiver with Digital Diagnostics. Requires external reference clock. 9.95 - 11.1 Gbps 1550 2 1600 White 80 XFP-10GD-LR04P 10 GbE or 10G FC single-mode XFP tranceiver with Digital Diagnostics. Requires external reference clock. 9.95 - 11.1 Gbps 1550 2 800 White 40 Model Description Ordering Information Mechanical Drawing 6.91 .272 16.15 .636 69.09 2.720 11.47 .451 8.44 .332 3.80 .150 6.02 .237 12.19 .480 6.25 .246 18.29 .720 8.95 .352 77.98 3.070 ISO VIEW 1. MRV'S XFP TRANSCEIVERS ARE COMPLIANT WITH THE DIMENSIONS DEFINED BY XFP MULTISOURCING AGREEMENT (MSA). NOTES: UNLESS OTHERWISE SPECIFIED Warnings Handling Precautions: This device is susceptible to damage as a result of electrostatic descharge (ESD). A static free environment is highly recommended. Follow guidelines according to proper ESD procedures. Laser Safety: Radiation emitted by laser devices can be dangerous to human eyes. Avoid eye exposure to direct or indeirect radiation. MRV has more than 50 offices throughout the world. Addresses, phone numbers, and fax numbers are listed at www.mrv.com. Please e-mail us at [email protected] or call us for assistance. MRV (West Coast USA) 20415 Nordhoff St. Chatsworth, CA 91311 800-338-5316 818-773-0900 MRV (East Coast USA) 295 Foster St. Littleton, MA 01460 800-338-5316 978-952-4700 MRV (International) Business Park Moerfelden Waldeckerstrasse 13 64546 Moerfelden-Walldorf Germany Tel. (49) 6105/2070 Fax. (49) 6105/207-100 All statements, technical information and recommendations related to the products herein are based upon information believed to be reliable or accurate. However, the accuracy or completeness thereof is not guaranteed, and no responsibility is assumed for any inaccuracies. Please contact MRV Communications for more information. MRV Communications and the MRV Communications logo are trademarks of MRV Communications, Inc. Other trademarks are the property of their respective holders. MRV-OP-XFPMR-011508 3020006-001 Rev. A1 Copyright ©2008 MRV Communications, Inc. All Rights Reserved.