RF SAW Filter Part Number Package Application Last Modified 803-RF1003.0M-A 3.0 x 3.0 SMD Wireless Jan. 01, 2007 . TYPE : Wireless, RF SAW Filter PART NUMBER : 803-RF1003.0M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Condition Minimum Typical Maximum Units - - 1003.0 - MHz 988.0~ 1018.0 MHz - 3.5 4.5 dB D.C.~ 942.0 MHz 50 60 - 942.0~ 964.0 MHz 40 50 - 964.0~ 967.0MHz 40 50 - 1039.0~ 1040.0 MHz 13 23 - 1040.0~ 1084.0 MHz 15 25 - 1084.0~ 1559.0 MHz 35 50 - 1559.0~ 3000.0 MHz 20 28 - 988.0~ 1018.0 MHz- - 1.5 2.5 dBmp-p Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm 988.0~ 1018.0 MHz - 2.3 2.7 - Maximum DC Voltage - - - 10 V Maximum Input Power - - - 10 dBm Operating Temperature - -30 - +85 ºC Stop Band Attenuation: Amplitude Ripple VSWR * No Matching Network . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B In C Ground D Ground E Out F Ground dB Source/ Load Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 803-RF1003.0M-A