Oscilent Corporation RF SAW Filter | 805-RF434.42M-B Page 1 of 2 RF SAW Filter Part Number Package Application Last Modified 805-RF434.42M-B 5.0 x 5.0 SMD Remote Control Jan. 01, 2007 . TYPE : Remote Control, RF SAW Filter PART NUMBER : 805-RF434.42M-B .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Insertion Loss Relative Attenuation: Condition Minimum Typical Maximum Units - - 434.42 - MHz 434.30 ~ 434.54 MHz - 2.0 4.5 dB 10.0 ~ 415.0 MHz 45 50 - 415.0 ~ 429.0 MHz 40 45 - 429.0 ~ 433.42 MHz 15 20 - 435.42 ~ 443.0 MHz 10 15 - dB 443.0 ~ 550.0 MHz 35 40 - 550.0 ~ 1000.0 MHz 45 50 - Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm 434.30 ~ 434.54 MHz - 1.0 2.0 - Maximum DC Voltage - - - 10 V Maximum Input Power - - - 10 dBm Operating Temperature - -40 - +85 ºC Pass Band Ripple * With Matching Network . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B In C Ground D Ground E Out F Ground G Ground H Ground Oscilent Corporation RF SAW Filter | 805-RF434.42M-B Page 2 of 2 FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 805-RF434.42M-B