PLL PLL602-00

PLL602-00
Multiplier XO IC Die for 12 to 25MHz Parallel Resonant Crystals
FEATURES
DIE CONFIGURATION
•
•
•
•
VDD
VDD
S0V
S1V
S2V
Integrated crystal oscillator circuitry (XO).
Low phase noise (-135dBc @ 10kHz offset)
selectable frequency multipliers (x1, x2, x4, x8
as bonding options).
3.3V supply voltage.
Uses inexpensive fundamental-mode parallel
resonant crystals (from 12 to 25MHz).
Selectable High Drive (30mA) or Standard Drive
(10mA) output.
Available in DIE (65 mil x 62 mil).
25
23
21
20
19
18
(1550,1475)
Die ID:
A0303-03H
62 mil
•
•
OE^
65 mil
XIN
27
XOUT
29
C502A
DESCRIPTION
13
CLK
10
GND
The PLL602-00 is a monolithic low jitter and low
phase noise (-135dBc @10kHz offset), high
performance CMOS XO IC. This flexible device can
be used as a XO with output frequencies ranging
from F XIN x 1 to F XIN x 8 thanks to selector pads
allowing bonding options (see Divider Selection
Table on this page). This makes the PLL602-00 ideal
for a wide range of applications from 12MHz to
200MHz (including 50MHz, 77.76MHz, 125MHz and
155.52MHz, etc.).
BLOCK DIAGRAM
S[0:2]
XIn
XO
XOut
Selectable
PLL
CLK
GND
7
(0,0)
Y
X
Note:
^ denotes internal pull up
V
denotes internal pull down
MULTIPLIER SELECTION
SELECTION
S2
S1
S0
0
0
0
0
0
1
0
1
0
1
0
0
0
1
1
1
1
0
1
0
1
1
1
1
F XIN
CLK (MHz)
12MHz – 25MHz
F XIN x 2
F XIN x 4
F XIN x 1
F XIN x 8
F XIN x 2*
F XIN x 4*
F XIN x 1*
F XIN x 8*
Note: - Selector pads default to ‘0’, wire bond to VDD to set to ‘1’
- (*) High-drive CMOS output
PAD DESCRIPTION
DIE SPECIFICATIONS
Name
Value
Size
Reverse side
Pad dimensions
Thickness
62 x 65 mil
GND
80 micron x 80 micron
10 mil
Name
Number
Description
XIN
27
Crystal input connection.
XOUT
29
Crystal connection.
GND
7,10
CLK
13
S[0:2]
18,19,20
Frequency selection pad
VDD
21,22,23
OE
25
3.3V Power Supply.
Output Enable: ‘0’ to disable (tristate output), 1’ (default value
when not connected) to enabled
the output.
Ground.
Clock Output.
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/03/04 Page 1
PLL602-00
Multiplier XO IC Die for 12 to 25MHz Parallel Resonant Crystals
ELECTRICAL SPECIFICATIONS
1. Absolute Maximum Ratings
PARAMETERS
SYMBOL
Supply Voltage
Input Voltage, dc
Output Voltage, dc
Storage Temperature
Ambient Operating Temperature*
Junction Temperature
Lead Temperature (soldering, 10s)
ESD Protection, Human Body Model
MIN.
V DD
VI
VO
TS
TA
TJ
-0.5
-0.5
-65
-40
MAX.
UNITS
4.6
V DD +0.5
V DD +0.5
150
85
125
260
2
V
V
V
°C
°C
°C
°C
kV
Exposure of the device under conditions beyond the limits specified by Maximum Ratings for extended periods may cause permanent damage to the
device and affect product reliability. These conditions represent a stress rating only, and functional operations of the device at these or any other
conditions above the operational limits noted in this specification is not implied.
* Note: Operating Temperature is guaranteed by design for all parts (COMMERCIAL and INDUSTRIAL), but tested for COMMERCIAL grade only.
2. DC Electrical Specifications
PARAMETERS
Supply Current, Dynamic, with
Loaded Outputs
Operating Voltage
Output drive current
(High Drive)
Output drive current
(Standard Drive)
SYMBOL
I DD
V DD
I OH
I OL
I OH
I OL
CONDITIONS
MIN.
F XIN = 12 - 25MHz
Output load of 10pF
V OH = V DD -0.4V, V DD =3.3V
V OL = 0.4V, V DD = 3.3V
V OH = V DD -0.4V, V DD =3.3V
V OL = 0.4V, V DD = 3.3V
TYP.
MAX.
UNITS
16
20
mA
3.63
V
mA
mA
mA
mA
mA
MAX.
UNITS
25
MHz
2.97
30
30
10
10
±50
Short Circuit Current
3. AC Electrical Specifications
PARAMETERS
Input Crystal Frequency
Output Clock Rise/Fall Time
(Standard Drive)
Output Clock Rise/Fall Time
(High Drive)
Output Clock Duty Cycle
SYMBOL
CONDITIONS
MIN.
TYP.
12
0.3V ~ 3.0V with 15 pF load
2.4
0.3V ~ 3.0V with 15 pF load
1.2
Measured @ 50% V DD
45
50
ns
55
%
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/03/04 Page 2
PLL602-00
Multiplier XO IC Die for 12 to 25MHz Parallel Resonant Crystals
4. Crystal Specifications
PARAMETERS
Crystal Resonator Frequency
Crystal Loading Rating
Recommended ESR
SYMBOL
CONDITIONS
MIN.
F XIN
C L (xtal)
RE
Parallel Fundamental Mode
12
TYP.
MAX.
UNITS
25
MHz
pF
30
Ω
20
AT cut
5. Jitter and Phase Noise Specification
PARAMETERS
CONDITIONS
MIN.
TYP.
MAX.
UNITS
at 155MHz, with capacitive decoupling
between VDD and GND.
4
at 80MHz, with capacitive decoupling
between VDD and GND.
3
at 44MHz, with capacitive decoupling
between VDD and GND.
2.5
Phase Noise relative to carrier
44MHz @100Hz offset
-80
dBc/Hz
Phase Noise relative to carrier
44MHz @1kHz offset
-110
dBc/Hz
Phase Noise relative to carrier
44MHz @10kHz offset
-135
dBc/Hz
Phase Noise relative to carrier
44MHz @100kHz offset
-130
dBc/Hz
Phase Noise relative to carrier
44MHz @1MHz offset
-132
dBc/Hz
Phase Noise relative to carrier
155MHz @100Hz offset
-80
dBc/Hz
Phase Noise relative to carrier
155MHz @1kHz offset
-110
dBc/Hz
Phase Noise relative to carrier
155MHz @10kHz offset
-125
dBc/Hz
Phase Noise relative to carrier
155MHz @100kHz offset
-120
dBc/Hz
Phase Noise relative to carrier
155MHz @1MHz offset
-125
dBc/Hz
RMS Period Jitter
(1 sigma – 1000 samples)
ps
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/03/04 Page 3
PLL602-00
Multiplier XO IC Die for 12 to 25MHz Parallel Resonant Crystals
PAD ASSIGNMENT
Pad #
Name
X (µm)
Y (µm)
Description
7
GND
1042
109
Ground.
10
GND
1400
259
Ground.
13
CLK
1400
716
CMOS clock output.
18
S2
1232
1365
Used to select multiplication factor and drive level. Internal pull
down.
19
S1
1042
1365
Used to select multiplication factor and drive level. Internal pull
down.
20
S0
854
1365
Used to select multiplication factor and drive level. Internal pull
down.
21
VDD
659
1365
3.3V power supply.
23
VDD
459
1365
3.3V power supply.
25
OE
194
1365
Used to enable/disable the output(s). Internal pull up.
27
XIN
109
1017
Crystal input. See crystal specification page 3.
29
XOUT
109
646
Crystal output. See crystal specification page 3.
ORDERING INFORMATION
For part ordering, please contact our Sales Department:
47745 Fremont Blvd., Fremont, CA 94538, USA
Tel: (510) 492-0990 Fax: (510) 492-0991
PART NUMBER
The order number for this device is a combination of the following:
Device number, Package type and Operating temperature range
PLL602-00 D C
TEMPERATURE
C=COMMERCIAL
I=INDUSTRAL
PART NUMBER
PACKAGE TYPE
D=DIE
Order Number
Marking
Package Option
PLL602-00DC
P602-00DC
Die – Waffle Pack
PhaseLink Corporation, reserves the right to make changes in its products or specifications, or both at any time without notice. The information
furnished by Phaselink is believed to be accurate and reliable. However, PhaseLink makes no guarantee or warranty concerning the accuracy of said
information and shall not be responsible for any loss or damage of whatever nature resulting from the use of, or reliance upon this product.
LIFE SUPPORT POLICY: PhaseLink’s products are not authorized for use as critical components in life support devices or systems
without the express written approval of the President of PhaseLink Corporation.
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/03/04 Page 4