RSG RSG Electronic Components GmbH Sprendlinger Landstr. 115 D-63069 Offenbach/Germany Tel. +49 69 984047-0 Fax +49 69 984047-77 [email protected] www.rsg-electronic.de ■ ■ ELECTRONIC COMPONENTS ■ ■ ■ ■ Änderungen vorbehalten / subject to change without notice SCP-2K4 2400W Parallel Type With PFC Function series Features : AC input 180~260VAC, 3 3 wire AC 220V, 1 or 380V, 3 4 wire(option) PF> 0.98@ 230VAC Protections: Short circuit/ Overload/ Over voltage/ Over temperature Built-in remote sense function, remote ON-OFF control Power good signal With parallel function(N+1) Can adjust from 20~100% output voltage by external control 1-5V Forced air cooling by built-in DC fan Case coating with paint 3 years warranty SPECIFICATION ORDER NO. OUTPUT SCP-2K4-09 SCP-2K4-12 SCP-2K4-15 SCP-2K4-18 SCP-2K4-24 SCP-2K4-36 SCP-2K4-48 SCP-2K4-60 SAFETY MODEL NO. 2K4S-P009 2K4S-P012 2K4S-P015 2K4S-P018 2K4S-P024 2K4S-P036 2K4S-P048 2K4S-P060 DC VOLTAGE 9V 12V 15V 18V 24V 36V 48V 60V RATED CURRENT 266A 200A 160A 133.3A 100A 66.6A 50A 40A CURRENT RANGE 0 ~ 266A 0 ~ 200A 0 ~ 160A 0 ~ 133.3A 0 ~ 100A 0 ~ 66.6A 0 ~ 50A 0 ~ 40A RATED POWER 2400W 2400W 2400W 2400W 2400W 2400W 2400W 2400W 120mVp-p 150mVp-p 150mVp-p 150mVp-p 200mVp-p 200mVp-p 200mVp-p RIPPLE & NOISE (max.) Note.2 90mVp-p VOLTAGE ADJ. RANGE 3.0% Typical adjustment by potentiometer VOLTAGE TOLERANCE Note.3 2.0% 1.0% 1.0% INPUT 20% ~ 100% adjustment by 1 ~ 5VDC external control 1.0% 1.0% 1.0% 1.0% 1.0% LINE REGULATION 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% LOAD REGULATION 1.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% SETUP, RISE, HOLD TIME 800ms, 400ms, 12ms at full load VOLTAGE RANGE 180 ~ 260VAC FREQUENCY RANGE 47 ~ 63Hz POWER FACTOR >0.98 / 230VAC 3 3 wire (other system available) 84% EFFICIENCY (Typ.) 83% AC CURRENT INRUSH CURRENT (max.) 15A / 230VAC 60A / 230VAC LEAKAGE CURRENT(max.) 3.5mA / 240VAC 110 ~ 140% rated output power OVER LOAD Note. 4 PROTECTION OVER VOLTAGE OVER TEMPERATURE 85% 86% 88% 88% Protection type : Current limiting, delay shut down o/p voltage, re-power on to recover Protection type : Shut down o/p voltage, recovers automatically after temperature goes down -20 ~ +65 (Refer to output load derating curve) WORKING HUMIDITY 20 ~ 90% RH non-condensing SAFETY STANDARDS WITHSTAND VOLTAGE 89% 110 ~ 135% Follow to output set up point Protection type : Shut down o/p voltage, re-power on to recover >100 / measure by heat sink, near transformer WORKING TEMP. ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION 89% -20 ~ +85 , 10 ~ 95% RH 0.04% / (0 ~ 50 ) 10 ~ 200Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes UL60950, TUV EN60950-1 Approved I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC SAFETY & ISOLATION RESISTANCE I/P-O/P, I/P-FG, OP/FG:100M Ohms / 500VDC EMI CONDUCTION & RADIATION Compliance to EN55022 (CISPR22) class A EMC (Note. 5) Compliance to EN61000-3-2,3 HARMONIC CURRENT EMS IMMUNITY POWER GOOD SIGNAL SPECIAL FUNCTION OTHERS COOLING Open collector of NPN transistor DC Voltage Adj., Remote sensing, remote control, parallel operation(refer to control terminal instruction manual) By fan, >20% load or >50 fan on MTBF 24.9K hrs min. MIL-HDBK-217F(25 DIMENSION 350*212*124mm (L*W*H) 9.0kg ; 1pcs / 10kg / CARTON PACKING NOTE Compliance to EN61000-4-2,3,4,5,6,8,11, Light industry level, criteria A ) 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Current limiting 3 times(1.5s,3.0s,5.0s)Then intelligent auto recovery before shut down 5. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. File Name:SCP-2K4-SPEC 2006-03-28 SCP-2K4 2400W Parallel Type With PFC Function Mechanical Specification series 212[8.35] Unit:mm 332 [13.07] 1 2 3 4 5 6 7 8 123.9 [4.88] 5-M4X0.7 Terminal block For AC Input 8-M3X0.5 Terminal Block For Control Signal V-ADJ 1 2 3 4 5 6-M6 SCREW FOR DC OUTPUT Air flow direction POS(+) LED 320 [12.60] 30 [1.18] 180[7.09] 6 [0.24] TYP NEG(-) 4-M4X0.7 MOUNTING HOLE FOR USER 24 [0.94] 290 [11.42] AC Input Terminal Pin. No. Assignment Control Terminal Pin. No. Assignment : Pin No. 1 2 Assignment VS+ VSVCI VCO 3 4 Pin No. 5 6 7 8 Assignment PG PAR GND INH Pin No. 1 2 3 Assignment FG N T Pin No. 4 5 Assignment S R Derating Curve Ta=25 OUTPUT POWER (W) 100 LOAD (%) 80 60 40 20 -20 2400 2000 1200 900 -10 10 20 30 40 50 AMBIENT TEMPERATURE ( 60 70 90 110 ) 150 170 260 INPUT VOLTAGE (VAC) 60Hz File Name:SCP-2K4-SPEC 2006-03-28 RSG RSG Electronic Components GmbH Sprendlinger Landstr. 115 D-63069 Offenbach/Germany Tel. +49 69 984047-0 Fax +49 69 984047-77 [email protected] www.rsg-electronic.de ■ ■ ELECTRONIC COMPONENTS ■ Änderungen vorbehalten / subject to change without notice ■ ■ ■ SC P-2K4 2400W Parallel Type With PFC Function series . . LOAD t LOAD LOAD LOAD HON L.0FF USING INTERNALWLTAW CONTROL ON(OFFCONTR0LBY SWITCH RWOTESENSINQ 0NX)FF CONTROL BY TRANSISTOR Mut h 120 - 0.VP I r n ( T y p ) - I I I I 1 POWER O(MO S1O)IW. 2 3 4 5 8 >v EXTERNALVOLTAGE @C) LOAD Flb Name:SCP-ZK4SPEC 200643-28 RSG RSG Electronic Components GmbH Sprendlinger Landstr. 115 D-63069 Offenbach/Germany Tel. +49 69 984047-0 Fax +49 69 984047-77 [email protected] www.rsg-electronic.de ■ ■ ELECTRONIC COMPONENTS ■ Änderungen vorbehalten / subject to change without notice ■ ■ ■ SCP-2K4 2400W Parallel Type With PFC Function FIG. A: 3 series 3W 220VAC SYSTEM (STANDARD MODEL FOR STOCK) R R L1 N1 220V S L2 N2 T L3 N3 S FG1 FG2 FG3 220V N (NC) FG T FIG. B: 1 220VAC SYSTEM L R L1 N1 220V S L2 N2 T L3 N3 N FG1 FG2 FG3 N FG FIG. C: 3 4W 220/380VAC SYSTEM R R L1 N1 220V S L2 N2 T N L3 N3 FG1 FG2 FG3 N S 380V FG T FIG. D: 3 4W 190/110VAC SYSTEM R 110V R L1 N1 S N L2 N2 (N.C.) T L3 N3 S FG1 FG2 FG3 190V N (NC) FG T File Name: SCP-2K4-SPEC 2006-03-28 RSG RSG Electronic Components GmbH Sprendlinger Landstr. 115 D-63069 Offenbach/Germany Tel. +49 69 984047-0 Fax +49 69 984047-77 [email protected] www.rsg-electronic.de ■ ■ ELECTRONIC COMPONENTS ■ Änderungen vorbehalten / subject to change without notice ■ ■ ■