Model MM9xSMx Model MM9xSMx-14 Double Balanced Mixer Multi-Octave Band Electrical Specifications RF 6.0 to 18.0 GHz (1) : Conditions Parameter SSB Conversion loss:(2) (3) Isolation LO to RF: LO to IF: RF to IF: Input 1-dB Compression Point: Input Third Order Intercept Point: LO Power: (4) RF(GHz) 6.0-18.0 6.0-18.0 LO(GHz) 6.0-18.0 6.0-18.0 IF(MHz) DC-1300 DC-2500 6.0-13.0 13.0-18.0 6.0-18.0 6.0-18.0 6.0-18.0 6.0-18.0 DC-2500 6.0-18.0 6.0-18.0 DC-2500 6.0-18.0 6.0-18.0 DC-2500 Specifications Min Typical 5.7 dB 6.9 dB 28 dB 24 dB 32 dB 28 dB 30 dB 30 dB +1 dBm +4 dBm +8 dBm +11 dBm +14 dBm +18 dBm +7 dBm +10 dBm +13 dBm Max 8.0 dB 9.0 dB LO Power 3 = +7 dBm 4 = +10 dBm 6 = +14 dBm MM93 MM94 MM96 MM93 MM94 MM96 MM93 MM94 MM96 Drop-In Module or With SMA(F) Connectors D = No Cover H = With Cover Mixers Notes: 1. Specifications are guaranteed when tested as a downconverter in a 50 Ohm system at +25˚C with the nominal LO power. Specifications indicated as typical are not guaranteed. 2. Noise figure is typically within ±0.5 dB of conversion loss for IF frequencies greater than 10 MHz. 3. Conversion loss typically degrades less than 0.5 dB at +100˚C and improves less than 0.5 dB at -55˚C. 4. Usable LO drives are up to 2 dB below and 3 dB above nominal. 5. See Application Note M112, for aid in selecting the outline and for mounting and installation information. Outline: SMMC4A: AS SHOWN SMMC4B: RF & LO REVERSED MM9xSMD Typical Performance at 25˚C MHz MM9xSMH MM9xSMx: AS SHOWN MM9xSMx-14: RF & LO REVERSED Outline: SMMT4A: AS SHOWN SMMT4B: RF & LO REVERSED ECTRU MHz MICROWAVE INC. M SP NOTE: See PC board footprint - FP1 on page 3-64 All dimensions are in inches and [mm]. A Spectrum Control Business SPECTRUM MICROWAVE • 2144 Franklin Drive N.E. • Palm Bay, Florida 32905 • Phone: (888) 553-7531 • Fax: (888) 553-7532 www.specwave.com SPECTRUM CONTROL GmbH • Hansastrasse 6 • 91126 Schwabach, Germany • Phone: (49)-9122-795-0 • Fax: (49)-9122-795-58 619