PS800 Series 800 Watt Single Output PFC and Current Sharing AC/DC Switching Power Supply FEATURES ● Remote Sense ● Power Failure Signal ● Remote ON/OFF Control ● 0.98 Typical Power Factor ● Programmable Output Voltage ● Forced Current Sharing at Parallel Operation ● Input Voltage: 90~260VAC (90 ~ 170VAC Reduced Power) ● Short Circuit/ Overload/ Over Voltage/ Over Temperature Protection SPECIFICATIONS: PS800 Series o All specifications are based on 25 C, Nominal Input Voltage, and Maximum Output Current unless otherwise noted. We reserve the right to change specifications based on technological advances. INPUT SPECIFICATIONS Input Voltage Range 90 ~ 260VAC **(90 ~ 170 VAC reduced power - see “Output Power vs Input Voltage” derating curve)** Input Frequency 47 to 63Hz Input Current 4.5A at 230VAC (Typical) Inrush Current RESULT A: 42.0A (Typical) Leakage Current < 3.5mA at 240VAC Remote ON/OFF Control Compatible with a TTL signal to turn ON/OFF OUTPUT SPECIFICATIONS Output Voltage See Table Output Power Range 800 Watts max. Maximum - minimum > 15% Adjustment (Typical adjustment by potentiometer) Output Voltage Adjustability 25% ~ 100% Adjustment by 1 ~ 5VDC external control. Line Regulation Less than 1% Load Regulation Less than 1% Output Current See Table Ripple & Noise (peak to peak) 1% Setup, Rise, Hold-Up Time RESULT A: 12.4ms Temperature Coefficient ±0.04% / °C (0 ~ 50°C) Remote Sense Yes PROTECTION Over Voltage Protection 110% ~ 135% (variable “OVP” follows the adjustable DC output voltage) Over Load Protection Current limiting 3 times (1.5”, 3.0”, 5.0”) then intelligent auto recovery before shutdown. GENERAL SPECIFICATIONS Efficiency See Table Power Factor 0.98 (Typical) Power Failure Signal Open Collector of NPN Transistor Parallel Operation Yes ENVIRONMENTAL SPECIFICATIONS Working Temperature 0°C to +50°C @ 100% Load, +65°C @ 50% Load. Storage Temperature -20°C to +85°C Working Humidity 20% to 90% RH Storage Humidity 10% to 95% RH Vibration 10 ~ 200Hz, 2g 10 min./1cycle, Period of 60 min. for each axes. Cooling Power rating and temperature controlled fan. PHYSICAL SPECIFICATIONS Weight 2.3kg Dimensions 290(L) x 120(W) x 67.5(H) mm SAFETY & EMC Safety Standards UL1950, TUV EN60950 EMC Standards EN55022, EN610000-4-2,3,4,5,6,8,11, EN61000-3-2,3, ENV50204 Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797 PS800 Series 800 Watt Single Output PFC and Current Sharing AC/DC Switching Power Supply OUTPUT VOLTAGE / CURRENT RATING CHART Model Number Output Voltage Output Current Maximum Output Power Ripple & Noise Efficiency PS800S-P009 9 VDC 88.8A 800W 1% 83% PS800S-P012 12 VDC 66.6A 800W 1% 84% PS800S-P015 15 VDC 53.3A 800W 1% 85% PS800S-P018 18 VDC 44.4A 800W 1% 85% PS800S-P024 24 VDC 33.3A 800W 1% 88% PS800S-P036 36 VDC 22.2A 800W 1% 88% PS800S-P048 48 VDC 16.6A 800W 1% 89% PS800S-P060 60 VDC 13.3A 800W 1% 90% NOTES 1. Input voltage is 90 ~ 260VAC however, the unit does not reach full power until >170VAC. See derating curve below. 2. Dimensions of the mechanical drawing are shown in millimeters and inches. 3. Weight of the unit is 2300 grams. DERATING CURVES Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797 PS800 Series 800 Watt Single Output PFC and Current Sharing AC/DC Switching Power Supply CONNECTOR PIN-OUT DRAWINGS Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797 PS800 Series 800 Watt Single Output PFC and Current Sharing AC/DC Switching Power Supply MECHANICAL DRAWING Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797