NLP25 Series Single, dual and triple output LOW TO MEDIUM POWER AC/DC POWER SUPPLIES • • • • • 20-25W AC/DC Universal Input Switch Mode Power Supplies 1 4.00 x 2.07 x 0.91 inch package Overvoltage protection and short circuit protection 25W with free air convection cooling EN55022, EN55011 conducted emissions level B UL, VDE and CSA safety approvals The NLP25 series is a 25W universal input AC/DC power supply on a 4.00 x 2.07 inch card with a profile of less than 1 inch. The availability of four single output and three multiple output models in an extremely small package size make the NLP25 ideal for use in space critical, low power communication applications requiring an off line power solution. The NLP25 provides 25W of output power with free air convection cooling which can peak at 30W for 60 seconds. Standard features include overvoltage and short circuit protection. The series, with full international safety approvals and the CE mark, meets conducted emissions EN55022 level B and complies to EN61000-4-2,-3,-4, -5 and -6 immunity standards. The NLP25 series is designed for use in off line, low power data networking and computer applications with limited space, such as hubs, routers, POS terminals, external disk storage and cable modems. The availability of 5V outputs in single and multiple configurations provides a solution for a myriad of microprocessor applications. 2 YEAR WARRANTY SPECIFICATIONS All specifications are typical at nominal input, full load at 25°C unless otherwise stated OUTPUT SPECIFICATIONS Total regulation (Line and load) Main output Auxiliary outputs Overshoot/undershoot At turn-on Transient response Main output 50% to 100% full load step Temperature coefficient Overvoltage protection EMC CHARACTERISTICS ±2.0% ±5.0% 2.0% ±5.0% max. dev., 1ms recovery to 1.0% ±0.02%/°C Main output Short circuit protection See table Continuous with autorestart Minimum output current See table Radiated emissions Conducted emissions Electrostatic discharge Electrical fast transients/bursts Surge susceptibility RF field susceptibility RF conducted disturbance Universal input Input frequency range Input current Safety ground leakage current 90 to 264VAC 127 to 375VDC 47Hz to 440Hz 90VAC 230VAC 120VAC, 60Hz 230VAC, 50Hz 0.75A rms max. 0.35A rms max. 0.2mA 0.4mA Level A Level B Level 2 Level 3 EN61000-4-5 EN61000-4-3 EN61000-4-6 Level 3 Level 3 Level 3 GENERAL SPECIFICATIONS Hold-up time 110VAC @ full load Efficiency 110VAC @ full load 70% typ. Isolation voltage Input/output Input/chassis 3000VAC 1500VAC Switching frequency Fixed INPUT SPECIFICATIONS Input voltage range EN55022/11, FCC part 15 EN55022/11, FCC part 15 EN61000-4-2 EN61000-4-4 5ms typ. 60kHz, ±10kHz Approvals and standards (See Notes 4, 8) EN60950, IEC950 VDE0805, UL1950 CSA C22.2 No. 950 Weight MTBF 115g (4oz) MIL-HDBK-217F 150,000 hours min. ENVIRONMENTAL SPECIFICATIONS Thermal performance (See Notes 7, 8) Operating ambient, FL Non-operating 0°C to 50°C, ambient, convection cooled Peak 0°C to +50°C -40°C to +85°C Full load Relative humidity Non-condensing 5% to 95% RH Altitude Operating Non-operating Vibration (See Note 6) 5Hz to 500Hz Shock MIL-STD-810E See Note 1 10,000 feet max. 30,000 feet max. 2.4G rms peak 516.4 Part IV File Name: NLP25.PDF Rev: 01 Jan 2000 NLP25 Series Single, dual and triple output LOW TO MEDIUM POWER AC/DC POWER SUPPLIES 20-25W AC/DC Universal Input Switch Mode Power Supplies 2 For the most current data and application support visit www.artesyn.com/powergroup/products.htm OUTPUT OUTPUT POWER VOLTAGE 20.8W +5V (IA) 20.1W OUTPUT CURRENT (2) RIPPLE MIN (3) (1) THRESHOLD 0.2A 2.0A 2.5A 50mV +12V (IB) 0.1A 0.8A 1.2A 120mV ±5.0% –12V (IC) 0A 0.1A 0.15A 50mV ±5.0% +5V (IA) 0.2A 2.0A 2.5A 50mV +12V (IB) 0.1A 0.8A 1.2A 120mV 3 4 5 6 7 8 5.6V to 6.9V 5.6V to 6.9V REGULATION MODEL (3) ±2.0% ±2.0% NUMBER NLP25-7608 NLP25-7607 ±5.0% –5V (IC) 0A 0.1A 0.15A 50mV 0.2A 2.0A 2.5A 50mV +12V (IB) 0.1A 0.8A 1.2A 120mV 25W +5V 0A 5.0A 6.0A 50mV 5.6V to 6.9V ±2.0% NLP25-7605 25W +12V 0A 2.08A 2.5A 120mV 14V to 16.7V ±2.0% NLP25-7612 25W +24V 0A 1.04A 1.25A 150mV 29V to 34.2V ±2.0% NLP25-7624 25W +48V 0A 0.52A 0.6A 150mV 55V to 60V ±2.0% NLP25-7617 Notes 2 TOTAL (5) PEAK +5V (IA) 19.6W 1 OVP MAX Peak output current lasting less than 60 seconds with duty cycle less than 5.0%. During peak loading, output voltage may exceed total regulation limits. 20MHz bandwidth, peak to peak, measured differentially with a 12 inch twisted pair of number 16 AWG copper wire, terminated with a 47µF capacitor of proper polarity and voltage rating. Total regulation is defined as the static output regulation at 25°C, including initial tolerance, line voltage within stated limit, load current within stated limit, and output voltage adjusted to their factory settings. To achieve specified regulation on multiple output models, minimum loads are required on V(A) and V(B) as outlined in above table. To maintain user-system safety approvals, the input power cable must be appropriately rated and approved. Main output voltage is protected by a Zener diode. Three orthogonal axes, random vibration 10 minutes for each axes, 2.4G rms 5Hz to 500Hz. CAUTION: Allow a minimum of 5 seconds after disconnecting line power when making thermal measurements. This product is only for inclusion by professional installers within other equipment and must not be operated as a stand alone product. J2 ±5.0% 5.6V to 6.9V ±2.0% NLP25-7629 ±5.0% OUTPUT PIN CONNECTIONS SINGLE DUAL TRIPLE Pin 1 V (A) No Connection V (C) Pin 2 Return Return Return Pin 3 V (A) V (A) V (A) Pin 4 Return Return Return Pin 5 V (A) V (B) V (B) INPUT PIN CONNECTIONS J1 Pin 1 AC Ground Pin 3 AC Line Pin 5 AC Neutral www.artesyn.com File Name: NLP25.PDF Rev: 01 Jan 2000 NLP25 Series Single, dual and triple output LOW TO MEDIUM POWER AC/DC POWER SUPPLIES 20-25W AC/DC Universal Input Switch Mode Power Supplies 3 For the most current data and application support visit www.artesyn.com/powergroup/products.htm 4.00 ±0.02 (101.60 ±0.5) 3.730 ±0.02 (94.74 ±0.5) Maximum Component Height 0.91 (23.11) 2.07 ±0.02 (52.58 ±0.5) 1 J2 J1 1.80 ±0.02 (45.72 ±0.5) 5 3 1 If Metallic fastners are used, Max. stand-off dia. should be 0.212 (5.38) and the screw or washer should not protrude beyond the circle. ø0.125 ±0.01 (ø3.18 ±0.25) ALL DIMENSIONS IN INCHES (mm) Input and output connectors Mating connectors AC (J1) connector type Molex 22-23-2051 or equivalent. AC (J1) mating connector type Molex 22-01-2057 with Molex 08-52-0123 crimp terminals or equivalent. DC (J2) connector type Molex 22-23-2051 or equivalent. DC (J2) mating connector type Molex 22-01-2057 with Molex 08-52-0123 crimp terminals or equivalent. International Safety Standard Approvals VDE0805/EN60950/IEC950 File No. 10401-3336-0118 UL1950 File No. E136005 CSA C22.2 No. 950 File No. LR41062 Data Sheet © Artesyn Technologies® 2002 The information and specifications contained in this data sheet are believed to be correct at time of publication. However, Artesyn Technologies accepts no responsibility for consequences arising from printing errors or inaccuracies. Specifications are subject to change without notice. No rights under any patent accompany the sale of any such product(s) or information contained herein. www.artesyn.com File Name: NLP25.PDF Rev: 01 Jan 2000