NLP65-3322 Triple output LOW POWER AC/DC POWER SUPPLIES • • • • • • • 60W AC/DC Universal Input Switch Mode Power Supplies 1 5.0 x 3.0 inch card and 1.26 inch package (1U applications) Smallest industry standard package EN61000-3-2 compliance option (HCC) Overvoltage and short circuit protection 60W with free air convection cooling EN55022, EN55011 conducted emissions level B EN61000-4-2,-3,-4, -5, -6 immunity compliant The NLP65-3322 is a 60W universal input AC/DC power supply on a 5 x 3 inch card with a maximum component height of 1.26 inches for use in 1U applications. This model has the option of input harmonic current correction in the same package size making the series ideal for product designs that will need to comply with EN61000-32 legislation. The NLP65-3322 provides 60W of output power with free air convection cooling which can be boosted to 70W with 20CFM of air. The NLP65, with full international safety approval, meets conducted emissions EN55022 level B and has immunity compliance to EN61000-4-2,-3,-4, -5, -6. The NLP65 series is designed for use in low power data networking, computer and telecom applications such as hubs, routers, POS terminals, internet servers, cable modems and PABX’s. This list is not exclusive as the generic feature set of the NLP65 series with industry standard output configurations provides a solution for most low power applications including many industrial applications. 2 YEAR WARRANTY SPECIFICATIONS All specifications are typical at nominal input, full load at 25°C unless otherwise stated OUTPUT SPECIFICATIONS EMC CHARACTERISTICS (continued) Total regulation (Line and load) Main output Auxiliary outputs Rise time At turn-on Transient response Main output 25% step at 0.1A/µs ±2.0% ±5.0% 1.0s, max. 5.0% or 250mV max. dev., 1ms max. recovery to 1% Temperature coefficient Overvoltage protection ±0.02%/°C Radiated immunity Conducted immunity Surge Fast transients Radiated immunity Conducted immunity EN61000-4-3, EN61000-4-6, EN61000-4-5, EN61000-4-4, EN61000-4-3, EN61000-4-6, Hold-up time 230VAC, 50Hz 125%, ±10% Efficiency Short circuit protection Cyclic operation Yes, indefinite Isolation voltage Minimum output current Single and multiple Input/output Input/chassis Switching frequency Fixed Input voltage range (See Note 1) Universal input (See Note 6) Input frequency range 47Hz to 63Hz Input surge current (cold start) 120VAC 230VAC Safety ground leakage current 120VAC, 60Hz 230VAC, 50Hz Inrush current 230VAC Input current 120VAC, 230VAC, 120VAC, 230VAC, Input fuse 17A max. 32A max. 0.7mA 1.4mA 32A max. with PFC with PFC without PFC without PFC UL/IEC127 EMC CHARACTERISTICS Conducted emissions Radiated emissions ESD air ESD contact Surge Fast transients 85 to 264VAC 120 to 370VDC 1.05A 0.51A 1.40A 0.80A rms rms rms rms 250VAC S 3.15A level level level level level level 3 3 2 3 3 3 Perf. Perf. Perf. Perf. Perf. Perf. criteria criteria criteria criteria criteria criteria 2 2 1 1 2 2 GENERAL SPECIFICATIONS Main outputs INPUT SPECIFICATIONS (11,12) 75% typical 3000VAC 1500VAC 100kHz, ±5kHz Approvals and standards (See Notes 9 and 12) EN60950, UL1950, cUL equivalent of CSA C22.2 No. 950 Weight MTBF 78ms @ 60W 283g (10 oz) MIL-HDBK-217F 150,000 hours min. ENVIRONMENTAL SPECIFICATIONS Thermal performance (See Notes 1, 4 and 10) Operating temperature 0°C to +50°C Non-operating -40°C to +85°C 50°C to 70°C ambient, 1.65W/°C convection cooled Peak (0°C to +50°C, 60s) See table Relative humidity Non-condensing Altitude Operating Non-operating 5% to 95% RH 10,000m max. 30,000m max. Vibration (See Note 5) 5Hz to 500Hz 2.4G rms peak Shock per MIL-STD-810E (11,12) EN55022, FCC part 15 (Note 11) EN55022, FCC part 15 (Note 11) EN61000-4-2, level 3 Perf. EN61000-4-2, level 4 Perf. EN61000-4-5, level 3 Perf. EN61000-4-4, level 3 Perf. Level B Level A criteria 1 criteria 1 criteria 3 criteria 1 516.4 Part IV File Name: NLP65-3322.PDF Rev: 24 Feb 2000 NLP65-3322 Triple output LOW POWER AC/DC POWER SUPPLIES 60W AC/DC Universal Input Switch Mode Power Supplies 2 For the most current data and application support visit www.artesyn.com/powergroup/products.htm OUTPUT CURRENT OUTPUT RIPPLE VOLTAGE MAX (4) PEAK (2) FAN (3) (10) 9.1A 8.0A 50mV ±100mV 6.25V ± 0.5V +24V 1.5A 2.6A 2.0A 240mV ±1200mV --- +12V 0.7A 1.0A 1.0A 120mV ±600mV --- N 7 4 5 6 MODEL NUMBER 7.0A 1 3 OVP (6) +5V Notes 2 TOTAL REGULATION When the input voltage is less than 90VAC the operating temperature range is 0°C to +40°C. The ripple and regulation specifications may not be met. Peak output current lasting less than 60 seconds with duty cycle less than 5%. During peak loading, output voltage may exceed total regulation limits. Figure is peak-to-peak for convection power rating. Output noise measurements are made across a 20MHz bandwidth using a 6 inch twisted pair, terminated with a 10µF electrolytic capacitor and a 0.1µF ceramic capacitor. Maximum continuous output power must not exceed 60W. Three orthogonal axes, random vibration 10 minutes for each axes, 2.4G rms 5Hz to 500Hz. To maintain stated regulation then: I ≥ 0.2A I max. PIN Pin 1 Pin 2 Pin 3 Pin 1 INPUT CONNECTIONS J1 AC Line No Pin AC Neutral J2 Safety Ground OUTPUT PIN CONNECTIONS J3 TRIPLE Pin 1 +24V Pin 2 +5V Pin 3 +5V Pin 4 Return Pin 5 Return Pin 6 +12V 8 9 10 11 12 13 NLP65-3322 For optimum reliability, no part of the heatsink should exceed 120oC, and no semiconductor case temperature should exceed 130oC. CAUTION: Allow a minimum of 1 second after disconnecting line power when making thermal measurements. This product is only for inclusion by professional installers within other equipment and must not be operated as a stand alone product. Maximum continuous output power for this model must not exceed 70 Watts with 20CFM forced air cooling. For system EMI compliance the unit must be mounted within a metal chassis. All models require a minimum mounting stand-off of 0.25 inches (6.35mm) in the end use product. Contact factory for further details with respect to harmonic current correction. Input and output connectors Mating connectors AC (J1) connector type Molex 26-60-4030 type. AC (J1) mating connector type Molex 09-50-3031 or equivalent with Molex 08-50-0105 or equivalent crimp terminals. DC (J3) connector type Molex 26-60-4060 type. DC (J3) mating connector type Molex 09-50-3061 with Triurcon 6838 or equivalent crimp terminals. DERATING CURVE Output Power (Watts) 70W 20 CFM FORCED AIR COOLING 60W NATURAL CONVECTION COOLING 0°C 10°C 20°C 30°C 40°C 33W 27W 50°C 60°C 70°C www.artesyn.com File Name: NLP65-3322.PDF Rev: 24 Feb 2000 NLP65-3322 Triple output LOW POWER AC/DC POWER SUPPLIES 60W AC/DC Universal Input Switch Mode Power Supplies 3 For the most current data and application support visit www.artesyn.com/powergroup/products.htm 5.00 (127.00) 4.550 (115.57) 3 N 0.225 (5.715) 1 J1 L 1 J3 6 3.00 (76.20) 2.550 (64.770) T1 J2 C19 Mounting ALL DIMENSIONS IN INCHES (mm) Hole Diameter 0.156 (4.00) MAXIMUM COMPONENT HEIGHT 1.26 (32.00) TOLERANCE: .xxx .xx ± ± 0.005" 0.02" International Safety Standard Approvals VDE0805/EN60950/IEC950 File No. 10401-3336-1096 Licence No. 93678 cUL, UL1950 File No. E136005 Data Sheet © Artesyn Technologies® 2002 The information and specifications contained in this data sheet are believed to be correct at time of publication. However, Artesyn Technologies accepts no responsibility for consequences arising from printing errors or inaccuracies. Specifications are subject to change without notice. No rights under any patent accompany the sale of any such product(s) or information contained herein. www.artesyn.com File Name: NLP65-3322.PDF Rev: 24 Feb 2000