NLP25 Series Single, dual and triple output LOW TO MEDIUM POWER AC/DC POWER SUPPLIES • • • • • • 20-25 W AC/DC Universal Input Switch Mode Power Supplies 1 4.00 x 2.07 x 0.91 inch package Overvoltage protection and short circuit protection 25 W with free air convection cooling EN55022, EN55011 conducted emissions level B UL, VDE, CSA and CCC safety approvals Available RoHS compliant The NLP25 series is a 25 W universal input ac-dc power supply on a 4.00 x 2.07 inch card with a profile of less than 1 inch. The availability of four single output and three multiple output models in an extremely small package size make the NLP25 ideal for use in space critical, low power communication applications requiring an off line power solution. The NLP25 provides 25 W of output power with free air convection cooling which can peak at 30 W for 60 seconds. Standard features include overvoltage and short circuit protection. The series, with full international safety approvals and the CE mark, meets conducted emissions EN55022 level B and complies to EN61000-4-2,-3,-4, -5 and -6 immunity standards. The NLP25 series is designed for use in off line, low power data networking and computer applications with limited space, such as hubs, routers, POS terminals, external disk storage and cable modems. The availability of 5 V outputs in single and multiple configurations provides a solution for a myriad of microprocessor applications. 2 YEAR WARRANTY SPECIFICATIONS All specifications are typical at nominal input, full load at 25 °C unless otherwise stated OUTPUT SPECIFICATIONS Total regulation (Line and load) Main output Auxiliary outputs Overshoot/undershoot At turn-on Transient response Main output 50% to 100% full load step Temperature coefficient Overvoltage protection EMC CHARACTERISTICS ±2.0% ±5.0% 2.0% ±5.0% max. dev., 1 ms recovery to 1.0% ±0.02%/°C Main output Short circuit protection See table Continuous with autorestart Minimum output current See table Radiated emissions Conducted emissions Electrostatic discharge Electrical fast transients/bursts Surge susceptibility RF field susceptibility RF conducted disturbance Universal input Input frequency range 90-264 Vac 127-375 Vdc 47-440 Hz Input current 90 Vac 230 Vac Safety ground leakage current 120 Vac, 60 Hz 230 Vac, 50 Hz 0.75 A rms max. 0.35 A rms max. 0.2 mA 0.4 mA Level A Level B Level 2 Level 3 EN61000-4-5 EN61000-4-3 EN61000-4-6 Level 3 Level 3 Level 3 GENERAL SPECIFICATIONS Hold-up time 110 Vac @ full load 5 ms typ. Efficiency 110 Vac @ full load 70% typ. Isolation voltage Input/output Input/chassis 3000 Vac 1500 Vac Switching frequency Fixed INPUT SPECIFICATIONS Input voltage range EN55022/11, FCC part 15 EN55022/11, FCC part 15 EN61000-4-2 EN61000-4-4 60 kHz, ±10 kHz Approvals and standards (See Notes 4, 8) EN60950, IEC950 VDE0805, UL1950, CCC60950 CSA C22.2 No. 950 Weight MTBF 115 g (4 oz) MIL-HDBK-217F 150,000 hours min. ENVIRONMENTAL SPECIFICATIONS Thermal performance (See Notes 7, 8) Operating ambient, FL 0 °C to +50 °C Non-operating -40 °C to +85 °C 0 °C to 50 °C, ambient, Full load convection cooled Peak See Note 1 Relative humidity Non-condensing Altitude Operating Non-operating Vibration (See Note 6) 5-500 Hz Shock MIL-STD-810E 5% to 95% RH 10,000 feet max. 30,000 feet max. 2.4 G rms peak 516.4 Part IV File Name: NLP25.PDF Rev (02): 08 Nov 2005 NLP25 Series Single, dual and triple output LOW TO MEDIUM POWER AC/DC POWER SUPPLIES 20-25 W AC/DC Universal Input Switch Mode Power Supplies 2 For the most current data and application support visit www.artesyn.com/powergroup/products.htm OUTPUT CURRENT OUTPUT OUTPUT POWER VOLTAGE 20.8 W +5 V (IA) 0.2 A 2A 2.5 A 50 mV +12 V (IB) 0.1 A 0.8 A 1.2 A 120 mV –12 V (IC) 0A 0.1 A 0.15 A 50 mV +5 V (IA) 0.2 A 2A 2.5 A 50 mV +12 V (IB) 0.1 A 0.8 A 1.2 A 120 mV ±5.0% –5 V (IC) 0A 0.1 A 0.15 A 50 mV ±5.0% 20.1 W 19.6 W (2) RIPPLE MIN (3) MAX PEAK (1) TOTAL (5) 5.6-6.9 V REGULATION MODEL (3) ±2.0% NUMBER (9,10,11) NLP25-7608J ±5.0% ±5.0% 5.6-6.9 V 0.2 A 2A 2.5 A 50 mV 0.1 A 0.8 A 1.2 A 120 mV 25 W +5 V 0A 5A 6A 50 mV 5.6-6.9 V ±2.0% NLP25-7605J 25 W +12 V 0A 2.08 A 2.5 A 120 mV 14-16.7 V ±2.0% NLP25-7612J 25 W +24 V 0A 1.04 A 1.25 A 150 mV 29-34.2 V ±2.0% NLP25-7624J 25 W +48 V 0A 0.52 A 0.6 A 150 mV 55-60 V ±2.0% NLP25-7617J J2 ±2.0% NLP25-7607J +5 V (IA) Peak output current lasting less than 60 seconds with duty cycle less than 5.0%. During peak loading, output voltage may exceed total regulation limits. 2 20 MHz bandwidth, peak to peak, measured differentially with a 12 inch twisted pair of number 16 AWG copper wire, terminated with a 47 µF capacitor of proper polarity and voltage rating. 3 Total regulation is defined as the static output regulation at 25 ºC, including initial tolerance, line voltage within stated limit, load current within stated limit, and output voltage adjusted to their factory settings. To achieve specified regulation on multiple output models, minimum loads are required on V(A) and V(B) as outlined in above table. 4 To maintain user-system safety approvals, the input power cable must be appropriately rated and approved. 5 Main output voltage is protected by a Zener diode. 6 Three orthogonal axes, random vibration 10 minutes for each axes, 2.4 G rms 5 Hz to 500 Hz. 7 CAUTION: Allow a minimum of 5 seconds after disconnecting line power when making thermal measurements. 8 This product is only for inclusion by professional installers within other equipment and must not be operated as a stand alone product. 9 All models of the NLP25 series are floating output except for the NLP257612J unit. The NLP25-7612J unit has its 0 Vdc output (return on J2 pins 2 and 4) directly connected to the incoming earth/ac ground. For the NLP7612J floating output please consult Artesyn Technologies. 10 The ‘J’ suffix indicates that these parts are Pb-free (RoHS 6/6) compliant. TSE RoHS 5/6 (non Pb-free) compliant versions may be available on special request, please contact your local sales representative for details. 11 NOTICE: Some models do not support all options. Please contact your local Artesyn representative or use the on-line model number search tool at http://www.artesyn.com/powergroup/products.htm to find a suitable alternative. 5.6-6.9 V ±2.0% +12 V (IB) Notes 1 OVP THRESHOLD NLP25-7629J ±5.0% OUTPUT PIN CONNECTIONS SINGLE DUAL TRIPLE Pin 1 V (A) No Connection V (C) Pin 2 Return Return Return Pin 3 V (A) V (A) V (A) Pin 4 Return Return Return Pin 5 V (A) V (B) V (B) INPUT PIN CONNECTIONS J1 Pin 1 AC Ground Pin 3 AC Line Pin 5 AC Neutral File Name: NLP25.PDF Rev (02): 08 Nov 2005 NLP25 Series Single, dual and triple output LOW TO MEDIUM POWER AC/DC POWER SUPPLIES 20-25 W AC/DC Universal Input Switch Mode Power Supplies 3 For the most current data and application support visit www.artesyn.com/powergroup/products.htm 4.00 ±0.02 (101.60 ±0.5) 3.730 ±0.02 (94.74 ±0.5) Maximum Component Height 0.91 (23.11) 2.07 ±0.02 (52.58 ±0.5) 1 J2 J1 1.80 ±0.02 (45.72 ±0.5) 5 3 1 If Metallic fastners are used, Max. stand-off dia. should be 0.212 (5.38) and the screw or washer should not protrude beyond the circle. ø0.125 ±0.01 (ø3.18 ±0.25) ALL DIMENSIONS IN INCHES (mm) Input and output connectors Mating connectors AC (J1) connector type Molex 22-23-2051 or equivalent. AC (J1) mating connector type Molex 22-01-2057 with Molex 08-52-0123 crimp terminals or equivalent. DC (J2) connector type Molex 22-23-2051 or equivalent. DC (J2) mating connector type Molex 22-01-2057 with Molex 08-52-0123 crimp terminals or equivalent. International Safety Standard Approvals VDE0805/EN60950/IEC950 File No. 10401-3336-0118 Licence No. 104743 UL1950 File No. E136005 CSA C22.2 No. 950 File No. LR41062 China Compulsory Certification 60950 Datasheet © Artesyn Technologies® 2005 The information and specifications contained in this datasheet are believed to be correct at time of publication. However, Artesyn Technologies accepts no responsibility for consequences arising from printing errors or inaccuracies. Specifications are subject to change without notice. No rights under any patent accompany the sale of any such product(s) or information contained herein. www.artesyn.com File Name: NLP25.PDF Rev (02): 08 Nov 2005