PASTERNACK PE44568

7/16 DIN Male Connector Clamp/Solder
Attachment For 7/8 inch Annular
TECHNICAL DATA SHEET
PE44568
7/16 DIN Male Connector Clamp/Solder Attachment For 7/8 inch Annular
Configuration
Connector
Connector Interface Type
Cable Attachment Method (Shield/Contact)
Body Style
7/16 DIN Male
7/8 inch Annular
Clamp/Solder
Straight
Electrical Specifications
Impedance, Ohms
50
Mechanical Specifications
Size
Length, in [mm]
Width/Dia., in [mm]
2.554 [64.87]
1.36 [34.54]
Weight, lbs [g]
0.485 [219.99]
Connector
Type
Contact Material and Plating Coupling Nut Material and Plating
Hex Size, in.
Torque, ft-lbs [Nm]
Body Material and Plating
Dielectric Type 7/16 DIN Male
Silver
Brass, Tri-Metal
1 1/4
18.417 [24.97]
Brass, Tri-Metal
PTFE
.
Compliance Certifications (visit www.Pasternack.com for current document)
RoHS Compliant
Yes
Plotted and Other Data
Notes:
Values at 25 °C, sea level
7/16 DIN Male Connector Clamp/Solder Attachment For 7/8 inch Annular from Pasternack Enterprises has same day shipment
for domestic and International orders. Our RF, microwave and fiber optic products maintain a 99% availability and are part of
the broadest selection in the industry.
Click the following link (or enter part number in “SEARCH” on website) to obtain additional part information including price,
inventory and certifications: 7/16 DIN Male Connector Clamp/Solder Attachment For 7/8 inch Annular PE44568
URL: http://www.pasternack.com/7-16-male-standard-7-8-inch-annular-connector-pe44568-p.aspx
PE44568 REV 01
1
© 2013 Pasternack Enterprises All Rights Reserved
PE44568 REV 01
4. HOLD CLAMP NUT STEADY & SCREW INTO BODY. INJECT GREASE
INTO HOLE OF CLAMP NUT. THEN TIGHTEN.
3. SLIDE O-RING OVER THREAD AND SEAT INTO PLACE. GREASE
O-RING.
2. INSTALL CLAMP NUT ONTO CABLE. FLAIR OUT INNER & OUTER
CONDUCTOR. DEBURR INNER & OUTER CONDUCTOR. SLIDE
GREASED SEALING GASKET INTO CENTER CONDUCTOR.
1. STRIP CABLE AS SHOWN.
ASSEMBLY PROCEDURES
FSCM NO. 53919
PE44568
DWG TITLE
CAD FILE
090808-A
SCALE N/A
SIZE A
XXXX
NOTES:
1. UNLESS OTHERWISE SPECIFIED ALL DIMENSIONS ARE NOMINAL.
2. ALL SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE AT ANY TIME.
3. DIMENSIONS ARE IN INCHES [mm].
4. FITS MIL-C-17 AND EQUIVALENT CABLES.
7/16 DIN Male Connector Clamp/Solder Attachment For 7/8 inch Annular
PE44568 CAD Drawing
2