N Male Connector Clamp/Solder Attachment For RG218 TECHNICAL DATA SHEET PE4433 N Male Connector Clamp/Solder Attachment For RG218 Configuration Connector Connector Interface Type Cable Attachment Method (Shield/Contact) Body Style N Male RG218 Clamp/Solder Straight Electrical Specifications Impedance, Ohms 50 Mechanical Specifications Size Length, in [mm] Width/Dia., in [mm] 2.26 [57.4] 1.31 [33] Weight, lbs [g] 0.33 [149.69] Connector Type Contact Material and Plating Coupling Nut Material and Plating Body Material and Plating Dielectric Type N Male Silver Brass, Nickel Brass, Nickel PTFE . Compliance Certifications (visit www.Pasternack.com for current document) RoHS Compliant Yes Plotted and Other Data Notes: Values at 25 °C, sea level N Male Connector Clamp/Solder Attachment For RG218 from Pasternack Enterprises has same day shipment for domestic and International orders. Our RF, microwave and fiber optic products maintain a 99% availability and are part of the broadest selection in the industry. Click the following link (or enter part number in “SEARCH” on website) to obtain additional part information including price, inventory and certifications: N Male Connector Clamp/Solder Attachment For RG218 PE4433 URL: http://www.pasternack.com/n-male-standard-rg218-connector-pe4433-p.aspx PE4433 REV 1 © 2013 Pasternack Enterprises All Rights Reserved 2. FORM BRAID OVER CLAMP NUT (3). TRIM BRAID BACK TO SHOULDER. CUT DIELECTRIC & CENTER CONDUCTOR TO DIMENSION SHOWN. DO NOT NICK CENTER CONDUCTOR. SLIDE WASHER (4) & BUSHING (5) OVER DIELECTRIC. SOLDER CONTACT TO CENTER CONDUCTOR. REMOVE EXCESS SOLDER. DO NOT OVER HEAT DIELECTRIC. INSERT CABLE ASSEMBLY INTO BODY & TIGHTEN. 1. SLIDE CLAMP NUT (1) & GASKET (2) OVER CABLE. STRIP CABLE AS SHOWN. DO NOT NICK BRAID WHILE CUTTING JACKET. COMB OUT BRAID. TAPER END OF BRAID TO PERMIT ASSEMBLY OF BRAID CLAMP (3). SLIDE BRAID CLAMP (3) OVER BRAID & SEAT AGAINST JACKET. ASSEMBLY PROCEDURES PE4433 REV REV. - CAD FILE 022807 SCALE N/A SIZE A 2233 NOTES: 1. UNLESS OTHERWISE SPECIFIED ALL DIMENSIONS ARE NOMINAL. 2. ALL SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE AT ANY TIME. 3. DIMENSIONS ARE IN INCHES [mm]. 4. FITS MIL-C-17 AND EQUIVALENT CABLES. FSCM NO. 53919 PE4433 DWG TITLE N Male Connector Clamp/Solder Attachment For RG218 PE4433 CAD Drawing 2