05081 PP0640SA thru PP3500SC Only One Name Means ProTek’Tion™ THYRISTOR SURGE SUPPRESSOR APPLICATIONS ✔ T1/E1 Trunk & Line Card ✔ SLIC Line Card ✔ DBX Branch Exchange Switches ✔ FCC Part 68 Customer Premise Equipment ✔ Line Interface Modem ✔ xDSL Architecture Interface ✔ ISDN Architecture Interface IEC COMPATIBILITY (EN61000-4) DO-214AA ✔ 61000-4-2 (ESD): Air - 15kV, Contact - 8kV ✔ 61000-4-4 (EFT): 40A - 5/50ns ✔ 61000-4-5 (Surge): 8/20µs - 95A, L4(Line-Gnd), 48A, L4(Line-Line) & 83A, L2(Power) DEVICE SYMBOL (BIDIRECTIONAL) FEATURES ✔ Complies with: FCC Part 68, UL 1459, Bellcore 1089, ITU-K.20 & K.21 ✔ UL File Recognition # E208219 ✔ Peak Off-State Voltage from 25 to 300 Volts ✔ Surge Current Capability (See Table 1) ✔ ESD Protection > 40 kilovolts ✔ Low Capacitance for T1/E1 Trunk & Line Card Applications ✔ Bidirectional Configurations ✔ RoHS Compliant in Lead-Free Versions MECHANICAL CHARACTERISTICS ✔ Molded Plastic DO-214AA Package ✔ Weight 2.5 grams (Approximate) ✔ Available in Tin-Lead or Lead-Free Pure-Tin Plating(Annealed) ✔ Solder Reflow Temperature: Tin-Lead - Sn/Pb, 85/15: 240-245°C Pure-Tin - Sn, 100: 260-270°C ✔ Flammability Rating UL 94V-0 ✔ 12mm Tape and Reel Per EIA Standard 481 ✔ Marking: Logo & Marking Code TABLE 1 - SURGE RATINGS SERIES IPP 2 X 10µs AMPS IPP 8 X 20µs AMPS SA SB SC 150 300 500 150 300 400 IPP IPP IPP 10 X 160µs 10 X 560µs 10 X 1000µs AMPS AMPS AMPS 100 150 200 50 100 200 50 80 100 ITSM 60 Hz AMPS 20 32 60 di/dt dv/dt AMPS/µs V/µs (See Note 1) (See Note 1) 500 500 500 2000 2000 2000 Note 1: Critital Rate of Rise for On-State Current (di/dt) and Off-State Voltage (dv/dt). 05081.R9 5/05 1 www.protekdevices.com PP0640SA thru PP3500SC DEVICE CHARACTERISTICS MAXIMUM RATINGS @ 25°C Unless Otherwise Specified SYMBOL VALUE UNITS Surge Current - 50/60 Hz ITSM 60 AMPS Junction Temperature TJ -40 TO 150 °C Storage Temperature TSTG -55 TO 150 °C Thermal Resistance(Junction) - SA & SB Series RQJC 28 °C/WATT Thermal Resistance(Junction) - SC Series RQJC 26 °C/WATT Thermal Resistance(Ambient) - SA & SB Series RQJA 90 °C/WATT Thermal Resistance(Ambient) - SC Series RQJA 85 °C/WATT PARAMETER ELECTRICAL CHARACTERISTICS PER LINE @ 25°C Unless Otherwise Specified PART NUMBER DEVICE MARKING CODE SWITCHING VOLTAGE MINIMUM HOLDING CURRENT (See Fig. 7) VDRM VOLTS @100V/µs VS VOLTS di/dt = 1A/ms IH mA REPETITIVE PEAK OFF-STATE VOLTAGE SWITCHING CURRENT MAXIMUM OFF-STATE CURRENT (See Fig. 4) MAXIMUM ON-STATE VOLTAGE (See Fig. 5) IS mA @VDRM IDRM µA @IT VT VOLTS IT AMPS @2V, 1 MHz C pF ON-STATE CURRENT TYPICAL CAPACITANCE (See Note 1) PP0640SA PP0720SA PP0800SA PP1100SA PP1300SA PP1500SA PP1800SA PP2300SA PP2600SA PP3100SA PP3500SA GC GD GE GF GG GH GI GJ GK GL GM 58 65 75 90 120 140 160 190 220 275 300 77 88 98 130 160 180 220 260 300 350 400 150 150 150 150 150 150 150 150 150 150 150 800 800 800 800 800 800 800 800 800 800 800 5 5 5 5 5 5 5 5 5 5 5 4 4 4 4 4 4 4 4 4 4 4 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 60 60 60 60 40 40 40 30 30 30 30 PP0300SB PP0640SB PP0720SB PP0800SB PP1100SB PP1300SB PP1500SB PP1800SB PP2300SB PP2600SB PP3100SB PP3500SB GN GP GQ GR GS GT GU GV GW GX GY GZ 25 58 65 75 90 120 140 160 190 220 275 300 40 77 88 98 130 160 180 220 260 300 350 400 50 150 150 150 150 150 150 150 150 150 150 150 800 800 800 800 800 800 800 800 800 800 800 800 5 5 5 5 5 5 5 5 5 5 5 5 4 4 4 4 4 4 4 4 4 4 4 4 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 110 60 60 60 60 40 40 40 30 30 30 30 PP0640SC PP0720SC PP0800SC PP1100SC PP1300SC PP1500SC PP1800SC PP2300SC PP2600SC PP3100SC PP3500SC HC HD HE HF HG HH HI HJ HK HL HM 58 65 75 90 120 140 160 190 220 275 300 77 88 98 130 160 180 220 260 300 350 400 150 150 150 150 150 150 150 150 150 150 150 800 800 800 800 800 800 800 800 800 800 800 5 5 5 5 5 5 5 5 5 5 5 4 4 4 4 4 4 4 4 4 4 4 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 120 120 120 120 80 80 80 60 60 60 60 Note 1: Capacitance imbalance between positive and negative polarities is typically < 15pF. 05081.R9 5/05 2 www.protekdevices.com PP0640SA thru PP3500SC GRAPHS FIGURE 1 PULSE WAVE FORM IPP - Peak Pulse Current - % of IPP 100 FIGURE 2 V-I CHARACTERISTIC CURVE TEST WAVEFORM PARAMETERS tf = 10µs td = 1,000µs tf Peak Value IPP IPP ITSM IT IS IH VS td = t I /2 PP 50 IDRM VT VDRM e-t 0 0 1 2 3 Non-Repetitive On-State Current (ITSM) - Amps t - Time - µs FIGURE 3 ON-STATE CURRENT VS SURGE CURRENT DURATION 100 PPxxxxSA PPxxxxSC PPxxxxSB 10 1 1 05081.R9 5/05 10 100 Surge Current Duration - Full Cycles Supply Frequency - 60 Hz Sinusoidal 3 1,000 www.protekdevices.com PP0640SA thru PP3500SC GRAPHS FIGURE 4 TYPICAL PEAK OFF-STATE CURRENT VS JUNCTION TEMPERATURE 100 IT - On-State Current - A IDRM - Peak Off-State Current - µA 10 1 0.1 0.01 -40 0 40 80 tJ- Temperature - °C 10 1 0 120 FIGURE 6 TYPICAL NORMALIZED SWITCHING VOLTAGE VS JUNCTION TEMPERATURE 1.15 FIGURE 5 TYPICAL ON-STATE CURRENT VS ON-STATE VOLTAGE 1 2 3 4 VT - On-State Voltage - V 5 6 7 FIGURE 7 TYPICAL NORMALIZED HOLDING CURRENT VS JUNCTION TEMPERATURE 2.5 1.1 2 Normalized IH Normalized VS 1.05 1 0.95 1.5 1 0.9 0.5 0.85 0.8 -40 05081.R9 5/05 0 40 80 tJ- Temperature - °C 0 -40 120 4 0 40 80 tJ- Temperature - °C 120 www.protekdevices.com PP0640SA thru PP3500SC APPLICATION NOTE FIGURE 1: UL 1459 & FCC Part 68 - Metallic Protection Fuse RTip TIP The TSS (Thyristor Surge Suppressor) device is located across the tip-to-ring after a limiting resistor and fuse combination. RTIP and RRING resistors are optional depending upon the TSS device selection. Without the resistors, the PP3100SB/SC is recommended. However, with a resistance value of 7.5 Ohms for tip and ring, the PP3100SA is recommended. Digital signals may use a lower TSS device depending upon the total tip to ring voltage range. Selection of the TSS device, either PPxxxxSA or SB/SC is based upon the value of the tip and ring resistors. For the National Electric Code (NEC) article 800, it is recommended that at least one fuse be used in the tip or ring line for metallic surges. Fuses may be replaced with a suitable Positive Temperature Coefficient (PTC) automatic resettable current limiting device. To Protected Equipment RRing RING FIGURE 1 - Metallic Protection R Tip TIP FIGURE 2 - UL 1459 & FCC Part 68 - Longitudinal Protection There are two TSS devices, one located from tip-to-ground and one ring-to-ground. For standard analog signals, the PP3100SA is recommended with a typical resistor value for tip and ring of 15 Ohms. The PP3100SB/SC is recommended for resistor values of 7.5 Ohms each. The National Electric Code (NEC) article 800 requires two fuse elements when connecting to ground. Fuses or a suitable Positive Temperature Coefficient (PTC) automatic resettable current limiting device may be used. The purpose of this circuit is to limit AC power current from getting on the ground line causing any safety hazard. To Protected Equipment R Ring RING FIGURE 2 - Longitudinal Protection FIGURE 3 - UL 1459 & FCC Part 68 - Metallic & Longitudinal Protection Three equal TSS devices are used in this application for metallic (tipto-ring) and longitudinal (tip-to-ground and ring-to-ground) protection. For analog signals, the PP3100SB/SC is recommended. With a resistance value of 15 Ohms for the tip and ring resistors, the PP3100SA may be used. The National Electric Code (NEC) article 800 requires two fuse elements when connecting to ground. Fuses or a suitable Positive Temperature Coefficient (PTC) automatic resettable current limiting device may be used. This circuit is recommended for protection against the Bellcore requirement: First Level Lightning Surge Tests (Telecommunications Port), document # GR-1089-CORE. R Tip TIP To Protected Equipment R Ring RING FIGURE 3 - Metallic & Longitudinal Protection 05081.R9 5/05 5 www.protekdevices.com PP0640SA thru PP3500SC PACKAGE OUTLINE & DIMENSIONS PACKAGE OUTLINE DO-214AA (SMB) A B DIMENSIONS MILLIMETERS MIN MAX DIM A B C D E F G H C H G D E 1.96 3.30 4.06 2.00 0.76 5.21 0.10 0.15 2.21 3.94 4.57 2.50 1.52 5.59 0.20 0.31 INCHES MIN MAX 0.077 0.130 0.160 0.079 0.030 0.205 0.004 0.006 0.087 0.155 0.180 0.098 0.060 0.220 0.008 0.012 NOTES 1. Dimensions are exclusive of mold flash and metal burrs. F TAPE & REEL ORDERING NOMENCLATURE 1. Surface mount product is taped and reeled in accordance with EIA-481. 2. Suffix-T13 = 13 Inch Reel - 3,000 pieces per 12mm tape, i.e., PP0640SA-T13. 3. Suffix - LF = Lead-Free, Pure-Tin Plating, .e., PP0640SA-LF-T13. Outline & Dimensions: Rev 0 - 4/02, 06030 COPYRIGHT © ProTek Devices 2005 SPECIFICATIONS: ProTek reserves the right to change the electrical and or mechanical characteristics described herein without notice (except JEDEC). DESIGN CHANGES: ProTek reserves the right to discontinue product lines without notice, and that the final judgement concerning selection and specifications is the buyer’s and that in furnishing engineering and technical assistance, ProTek assumes no responsibility with respect to the selection or specifications of such products. 05081.R9 5/05 6 ProTek Devices 2929 South Fair Lane, Tempe, AZ 85282 Tel: 602-431-8101 Fax: 602-431-2288 E-Mail: [email protected] Web Site: www.protekdevices.com www.protekdevices.com