Oscilent Corporation RF SAW Filter | 802-RF1215.0M-A Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 802-RF1215.0M-A 3.0 x 3.0 SMD RF Band Pass Mar. 2, 2007 . TYPE : RF Band Pass SAW Filter PART NUMBER : 802-RF1215.0M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Condition Minimum Typical Maximum Units - - 1215.0 - MHz Maximum Insertion Loss 1210.0~ 1220.0 MHz - 2.7 4.0 dB Attenuation: 1135.0.~ 1175.0 MHz 40 48 - 1320.0~ 1360.0 MHz 40 55 - Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm Amplitude Ripple 1210.0~ 1220.0 MHz - 0.4 1.5 dBp-p VSWR 1210.0~ 1220.0 MHz - 1.3 2.0 - Maximum DC Voltage - - - 5 V Maximum Input Power - - - 15 dBm Operating Temperature - -40 - +65 ºC Center Frequency (Fo) dB * No Matching Network(Ref. Testing Enviroment Circut as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE Load/ Source Impedance = 50 ohms A Ground B Out C Ground D Ground E In F Ground Oscilent Corporation RF SAW Filter | 802-RF1215.0M-A Page 2 of 3 FREQUENCY RESPONSE VSWR SMITH CHART Part No.: 802-RF1215.0M-A Oscilent Corporation RF SAW Filter | 802-RF1215.0M-A Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map Page 3 of 3