Oscilent Corporation RF SAW Filter | 802-RF1950.0M-A Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 802-RF1950.0M-A 3.0 x 3.0 SMD WCDMA Jan. 01, 2007 . TYPE : WCDMA, RF-Tx SAW Filter PART NUMBER : 802-RF1950.0M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Insertion Loss Stop Band Attenuation: Condition Minimum Typical Maximum Units - - 1950.0 - MHz 1920.0~ 1980.0 MHz - 2.8 4.0 dB D.C.~1840.0 MHz 20 31 - 1840.0~ 1900.0 MHz 10 17 - 2000.0~ 2030.0 MHz 4.5 9 - 2030.0~2060.0 MHz 20 50 - dB 2060.0~ 5000 MHz 22 26 - 1920.0~ 1980.0 MHz - 1.4 2.4 dBp-p Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm Amplitude Ripple 1920.0~ 1980.0 MHz - 1.9 2.4 - Maximum DC Voltage - - - 5 V Maximum Input Power - - - 10 dBm Operating Temperature - -30 - +80 ºC VSWR * No Matching Network (Ref. Testing Environment Circcuit as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B Out C Ground D Ground E In F Ground Oscilent Corporation RF SAW Filter | 802-RF1950.0M-A Load/ Source Impedance = 50ohms FREQUENCY RESPONSE VSWR SMITH CHART Page 2 of 3 Oscilent Corporation RF SAW Filter | 802-RF1950.0M-A Page 3 of 3 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 802-RF1950.0M-A