Oscilent Corporation RF SAW Filter | 805-RF315.0M-B Page 1 of 2 RF SAW Filter Part Number Package Application Last Modified 805-RF315.0M-B 5.0 x 5.0 SMD Remote Control Jan. 01, 2007 . TYPE : RF SAW Filter PART NUMBER : 805-RF315.0M-B .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Minimum Insertion Loss IL MIN Stop Band Attenuation: Condition Minimum Typical Maximum Units - - 315.0 - MHz 314.80 ~ 315.20 MHz - 3.0 5.0 dB 10.0 ~ 270.0 MHz 45 50 - 270.0 ~ 309.0 MHz 35 40 - 309.0 ~ 314.0 MHz 15 20 - 316.0 ~ 335.0MHz 10 15 - dB 335.0 ~ 400.0 MHz 35 40 400.0 ~ 1000.0MHz 45 50 - Passband Relative to IL MIN 314.75 ~ 315.24 MHz - 1.5 3.0 Passband Relative to IL MIN 314.69 ~ 315.30 MHz- - 2.0 6.0 Source Impedence (single ended)* - - 50 - Load Impendance (single ended)* - - 50 - ohm Maximum Input Power - - - 0 dBm Operating Temperature - -40 - +85 ºC dB ohm * With Matching Network (Ref. Testing Environment Circuit as shown) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A In B Ground C Ground D Ground E Out F Ground G Ground H Ground Oscilent Corporation RF SAW Filter | 805-RF315.0M-B L1 = 82 nH C1 = 5.6pF L2 = 82 nH C2 = 5.6pF Page 2 of 2 Source/ Load Impedance = 50 ohms FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 805-RF315.0M-B