Oscilent Corporation IF SAW Filter | 805-SL482.0M-20 Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 805-SL482.0M-20 5.0 x 5.0 SMD Communication Jan. 01, 2007 . TYPE : IF SAW Filter PART NUMBER : 805-SL482.0M-20 .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Insertion Loss Condition Minimum Typical Maximum Units - - 482.0 - MHz @ Fo - 8.7 12.0 dB Fo ± 15.0 MHz 5 8 - Fo ± 140.0 MHz 40 45 - Bandwidth at -1.0 dB - 22.5 23.0 - Bandwidth at -3.0 dB - - 26.5 - Relative Attenuation dB MHz - - 37.5 39.0 Amplitude Ripple 472 ~ 492 MHz - 0.8 1.0 dBp-p Passband Phase Ripple 472 ~ 492 MHz - 7 10 DEG. @ Fo - 0.35 - µsec Source Impedance (Balanced)* - - 100 - ohm Load Impedance (Balanced)* - - 100 - ohm Temperature Coefficient - - -94 - ppm/ºC Operating Temperature - -0 - +50 ºC Storage Temperature - -35 - +85 ºC Bandwidth at -40.0 dB Absolute Delay * With Matching Network (Ref. Testing Environment Circuit as shown below) ** Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B In C In D Ground E Ground F Out G Out H Ground Oscilent Corporation IF SAW Filter | 805-SL482.0M-20 L1 = 18nH C1 = 27pF L2 = 12nH C2 = 36pF Page 2 of 2 Source/Load Impedance = 100 ohms FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 805-SL482.0M-20