Oscilent Corporation IF SAW Filter | 815-IF36.125M-A Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 815-IF36.125M-A 15.9 x 5.9 Thru Hole Digital A/V & Broadcasting May 22 2003 . TYPE : 36.125 MHz Bandpass Filter 8.0 MHz Bandwidth PART NUMBER : 815-IF36.125M-A . Horizontal : 2.0 MHz/Div Veritical : 10 dB/Div Horizontal : 1.4 MHz/Div Veritical : 1 dB/Div Veritical : 100 ns/Div . OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency Insertion Loss (Input Voltage : 8V) 3 dB Bandwidth Minimum Typical Maximum Units 36.06 36.125 36.19 MHz - 15.5 17.0 dB 8.0 8.02 - MHz - 9.44 9.50 MHz Lower Sidelobe (25.0 ~ 31.2 MHz) 35 36.4 - dB Upper Sidelobe (41.0 ~ 50.0 MHz) 32 34.4 - dB Passband Ripple - 0.52 0.8 dB Group Delay Variation - 55 80 nsec Absolute Delay (at Fo) - 1.33 - µsec Temperature Coefficient - -72 - ppm/K 30 dB Bandwidth * Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE http://www.oscilent.com/spec_pages/if_sawfilter/if_815_if36_125a.htm 12/28/2005 Oscilent Corporation IF SAW Filter | 815-IF36.125M-A Page 2 of 2 Source Impedance = 50 ohms Load Impedance = 2 Kohms / 3pF Part No.: 815-IF36.125M-A Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map http://www.oscilent.com/spec_pages/if_sawfilter/if_815_if36_125a.htm 12/28/2005