3.0x1.5mm SMD CHIP LED LAMP APL3015F3C Features Description z3.0mmx1.5mm SMT LED, 1.4mm THICKNESS. F3 Made with Gallium Arsenide Infrared Emitting zLOW POWER CONSUMPTION. diodes. zWIDE VIEWING ANGLE. zIDEAL FOR BACKLIGHT AND INDICATOR. z VARIOUS COLORS AND LENS TYPES AVAILABLE. z PACKAGE : 2000PCS / REEL. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.2(0.0079") unless otherwise noted. 3. Specifications are subject to change without notice. SPEC NO: DSAD1360 APPROVED: J.LU REV NO: V.1 CHECKED: Allen Liu DATE:MAR/31/2003 DRAWN: D.L.HUANG PAGE: 1 OF 4 Selection Guide P ar t N o . Dic e A P L3015F 3C Po (m W/s r ) @ 20 m A L en s Ty p e GaAs WATER CLEAR V i ew i n g An g l e Min . Ty p . 2θ1/ 2 0.4 1.2 70° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°°C It em P/N Sy m b o l Ty p . Max . Un it Co n d itio n Forward Voltage F3 VF 1.2 1.6 V I F =20mA Reverse Current F3 IR - 10 uA VR=5V Capacitance F3 C 90 - pF VF=0V; f=1MHz Peak Wavelength F3 λP 940 - nm I F =20mA Spectral Line Half-width F3 ∆λ1/2 50 - nm I F =20mA Absolute Maximum Ratings at TA=25°°C It em Sy m b o l F3 F3 Un its Power Dissipation PT 100 mW DC Forward Current IF 50 mA Peak Forward Current [1] i FS 1.2 A Reverse Voltage VR 5 V -40° C To +85°C Operating /Storage Temperature Note: 1. 1/100 Duty Cycle, 10us Pluse Width. SPEC NO: DSAD1360 APPROVED: J.LU REV NO: V.1 CHECKED: Allen Liu DATE:MAR/31/2003 DRAWN: D.L.HUANG PAGE: 2 OF 4 APL3015F3C SPEC NO: DSAD1360 APPROVED: J.LU REV NO: V.1 CHECKED: Allen Liu DATE:MAR/31/2003 DRAWN: D.L.HUANG PAGE: 3 OF 4 APL3015F3C SMT Reflow Soldering Instructions Number of reflow process shall be less than 2 times and cooling process to normal temperature is required between first and second soldering process. Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) SPEC NO: DSAD1360 APPROVED: J.LU REV NO: V.1 CHECKED: Allen Liu DATE:MAR/31/2003 DRAWN: D.L.HUANG PAGE: 4 OF 4