PM20CSJ060 Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 Intellimod™ Module Three Phase IGBT Inverter Output 20 Amperes/600 Volts A 1. V UPC 2. UFO 3. UP 4. V UPI 5. V VPC 6. VFO 7. V P 8. V VPI 9. V WPC 10. WFO 11. WP 12. V WPI C D N V (14 TYP.) Q Q Q 1234 5678 9 11 10 12 R (2 TYP.) 13 15 17 14 16 18 H J G 19 S - DIA. (2 TYP.) 20 P 21 N 22 U 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. V NC V N1 UN VN WN FO P N U V W F 23 V W L M M M Description: Powerex Intellimod™ Intelligent Power Modules are isolated base modules designed for power switching applications operating at frequencies to 20kHz. Built-in control circuits provide optimum gate drive and protection for the IGBT and free-wheel diode power devices. M E B 2.0 X 0.5 MM TAB (5 TYP.) 0.6 X 0.4 MM TAB (18 TYP.) K T VUPC UP UFO VUPI Features: □ Complete Output Power Circuit GND GND IN SI FO OUT V CC VVPC VP VFO VVPI U GND GND IN SI FO OUT V CC VWPC WP WFO VWPI O UN S VN O WN GND GND GND IN SI FO OUT V CC UN S UN UN WN FO V N1 VN VN O VN WN FO V CC TC TB S WN GND V NC P □ Gate Drive Circuit □ Protection Logic – Short Circuit – Over Current – Over Temperature – Under Voltage N W V U P Outline Drawing and Circuit Diagram Dimensions Inches Millimeters Dimensions Inches Millimeters A 3.72±0.04 94.5±1.0 L 0.561 14.25 B 3.33±0.02 84.5±0.5 M 0.55±0.01 14.0±0.25 C 2.99 76.0 N 0.513 13.04 D 2.300±0.02 58.42±0.5 P 0.31±0.02 8.0±0.5 E 2.20±0.02 56.0±0.5 Q 0.300 7.62 F 1.73±0.04 44.0±1.0 R 0.20 Rad. Rad. 5.0 G 1.32±0.02 33.6±0.5 S 0.18 Dia. Dia. 4.5 H 1.01 25.7 T 0.14 3.5 J 0.75 19.0 U 0.13±0.02 3.2±0.5 K 0.71±0.04 18.0±1.0 V 0.100±0.01 2.54±0.25 Applications: □ Inverters □ UPS □ Motion/Servo Control □ Power Supplies Ordering Information: Example: Select the complete part number from the table below -i.e. PM20CSJ060 is a 600V, 20 Ampere Intellimod™ Intelligent Power Module. Type Current Rating Amperes VCES Volts (x 10) PM 20 60 469 Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 PM20CSJ060 Intellimod™ Module Three Phase IGBT Inverter Output 20 Amperes/600 Volts Absolute Maximum Ratings, Tj = 25°C unless otherwise specified Characteristics Symbol PM20CSJ060 Units Tj -20 to 150 °C Storage Temperature Tstg -40 to 125 °C Case Operating Temperature TC -20 to 100 °C Mounting Torque, M4 Mounting Screws — 13 in-lb Module Weight (Typical) — 60 Grams VCC(prot.) 400 Volts VRMS 2500 Volts VD 20 Volts Input Voltage Applied between (UP, VP, WP, UN, VN, WN) VCIN 20 Volts Fault Output Supply Voltage (Applied between FO and VC) VFO 20 Volts Fault Output Current IFO 20 mA VCES 600 Volts IC 20 Amperes Power Device Junction Temperature Supply Voltage Protected by OC and SC (VD = 13.5 - 16.5V, Inverter Part) Isolation Voltage, AC 1 minute, 60Hz Sinusoidal Control Sector Supply Voltage Applied between (VUP1-VUPC, VVP1-VVPC, VWP1-VWPC, VN1-VNC) IGBT Inverter Sector Collector-Emitter Voltage (VD = 15V, VCIN = 15V) Collector Current, ± Peak Collector Current, ± ICP 40 Amperes Supply Voltage (Applied between P - N) VCC 450 Volts VCC(surge) 500 Volts PC 56 Watts Supply Voltage, Surge (Applied between P - N) Collector Dissipation 470 Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 PM20CSJ060 Intellimod™ Module Three Phase IGBT Inverter Output 20 Amperes/600 Volts Electrical and Mechanical Characteristics, Tj = 25°C unless otherwise specified Characteristics Symbol Test Conditions Min. Typ. Max. Units Over Current Trip Level Inverter Part OC -20°C ≤ T ≤ 125°C 28 38 — Amperes Short Circuit Trip Level Inverter Part SC -20°C ≤ T ≤ 125°C — 57 — Amperes Control Sector Over Current Delay Time Over Temperature Protection Supply Circuit Under Voltage Protection toff(OC) VD = 15V — 10 — µS OT Trip Level 100 110 120 °C OTR Reset Level — 90 — °C UV Trip Level 11.5 12.0 12.5 Volts UVR Reset Level — 12.5 — Volts Supply Voltage VD Applied between VUP1-VUPC, 13.5 15 16.5 Volts Circuit Current ID — 18 25 mA VVP1-VVPC, VWP1-VWPC, VN1-VNC VD = 15V, VCIN = 15V, VN1-VNC VD = 15V, VCIN = 15V, VXP1-VXPC — 7 10 mA Input ON Threshold Voltage VCIN(on) Applied between 1.2 1.5 1.8 Volts Input OFF Threshold Voltage VCIN(off) UP, VP, WP, UN, VN, WN 1.7 2.0 2.3 Volts PWM Input Frequency fPWM 3-B Sinusoidal — 15 20 kHz Fault Output Current IFO(H) VD = 15V, VFO = 15V — — 0.01 mA IFO(L) VD = 15V, VFO = 15V — 10 15 mA tFO VD = 15V 1.0 1.8 — mS Minimum Fault Output Pulse Width 471 Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 PM20CSJ060 Intellimod™ Module Three Phase IGBT Inverter Output 20 Amperes/600 Volts Electrical and Mechanical Characteristics, Tj = 25°C unless otherwise specified Characteristics Symbol Test Conditions Min. Typ. Max. Units VCE = VCEX, Tj = 25°C — — 1.0 mA VCE = VCEX, Tj = 125°C — — 10 mA IGBT Inverter Sector Collector Cutoff Current Diode Forward Voltage Collector-Emitter Saturation Voltage ICEX VFM -IC = 20A, VD = 15V, VCIN = 15V — 2.5 3.5 Volts VCE(sat) VD = 15V, VCIN = 0V, IC = 20A — 1.8 2.5 Volts VD = 15V, VCIN = 0V, IC = 20A, — 1.9 2.6 Volts Tj = 125°C Inductive Load Switching Times 0.3 0.5 1.5 µS trr VD = 15V, VCIN = 0 ~ 15V — 0.12 0.3 µS tC(on) VCC = 300V, IC = 20A — 0.2 0.8 µS toff Tj = 125°C — 1.5 2.3 µS — 0.5 1.5 µS ton tC(off) Thermal Characteristics Characteristic Junction to Case Thermal Resistance Contact Thermal Resistance Symbol Condition Min. Typ. Max. Units Rth(j-c)Q Each IGBT — — 2.2 °C/Watt Rth(j-c)D Each FWDi — — 4.5 °C/Watt Rth(c-f) Case to Fin Per Module, — — 0.083 °C/Watt Thermal Grease Applied Recommended Conditions for Use Characteristic Supply Voltage Symbol Condition Value Units VCC Applied across P-N Terminals 0 ~ 400 Volts Applied between VUP1-VUPC, 15 ± 1.5 Volts VD VN1-VNC, VVP1-VVPC, VWP1-VWPC 472 Input ON Voltage VCIN(on) Applied between 0 ~ 0.8 Volts Input OFF Voltage VCIN(off) UP, VP, WP, UN, VN, WN 4.0 ~ VD Volts PWM Input Frequency fPWM Using Application Circuit 5 ~ 20 kHz Minimum Dead Time tDEAD Input Signal ≥ 2.0 µS Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 PM20CSJ060 Intellimod™ Module Three Phase IGBT Inverter Output 20 Amperes/600 Volts 1 Tj = 25oC IC = 20A Tj = 25oC Tj = 125oC COLLECTOR CURRENT, IC, (AMPERES) 2 0 2 1 0 0 5 10 15 20 15 13 VD = 17V 20 10 12 14 16 18 20 0 1 2 3 COLLECTOR CURRENT, IC, (AMPERES) SUPPLY VOLTAGE, VD, (VOLTS) COLLECTOR-EMITTER VOLTAGE, VCE(sat), (VOLTS) SWITCHING TIME VS. COLLECTOR CURRENT (TYPICAL) SWITCHING TIME VS. COLLECTOR CURRENT (TYPICAL) REVERSE RECOVERY CURRENT VS. COLLECTOR CURRENT (TYPICAL) 101 toff 100 ton 10-1 100 101 102 VCC = 300V VD = 15V Tj = 25oC Tj = 125oC 100 tc(off) tc(on) 10-1 100 102 REVERSE RECOVERY CURRENT, Irr, (AMPERES) SWITCHING TIMES, tc(on), tc(off), (µs) VCC = 300V VD = 15V Tj = 25oC Tj = 125oC 101 VCC = 300V VD = 15V Tj = 25oC Tj = 125oC 101 100 100 102 101 102 COLLECTOR CURRENT, IC, (AMPERES) COLLECTOR CURRENT, IC, (AMPERES) COLLECTOR CURRENT, IC, (AMPERES) DIODE FORWARD CHARACTERISTICS OVER CURRENT TRIP LEVEL VS. SUPPLY VOLTAGE (TYPICAL) OVER CURRENT TRIP LEVEL TEMPERATURE DEPENDENCY (TYPICAL) 102 120 110 101 100 Tj = 25oC OVER CURRENT TRIP LEVEL % (NORMALIZED) OVER CURRENT TRIP LEVEL % (NORMALIZED) VD = 15V Tj = 25oC Tj = 125oC 100 90 80 70 0 0 30 0 0 25 101 SWITCHING TIMES, ton, toff, (µs) 40 3 VD = 15V Tj = 25oC Tj = 125oC COLLECTOR-EMITTER SATURATION VOLTAGE VCE(sat), (VOLTS) SATURATION VOLTAGE VCE(sat), (VOLTS) 3 DIODE FORWARD CURRENT, IF, (AMPERES) OUTPUT CHARACTERISTICS (TYPICAL) COLLECTOR-EMITTER SATURATION VOLTAGE CHARACTERISTICS (TYPICAL) SATURATION VOLTAGE CHARACTERISTICS (TYPICAL) 1.0 1.5 2.0 2.5 DIODE FORWARD VOLTAGE, VF, (VOLTS) 3.0 VD = 15V 110 100 90 80 0 0 12 14 16 18 SUPPLY VOLTAGE, VD, (VOLTS) 20 -50 0 50 100 150 JUNCTION TEMPERATURE, Tj, (oC) 473 Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 PM20CSJ060 Intellimod™ Module Three Phase IGBT Inverter Output 20 Amperes/600 Volts UVt UVr 14 25 UV TRIP-RESET LEVEL, UVt, UVr, (VOLTS) FAULT OUTPUT PULSE WIDTH, tfo, (ms) VD = 15V 20 15 50 100 150 101 100 10-1 10-2 SINGLE PULSE STANDARD VALUE = Rth(j-c)D = 4.5oC/W 10-1 TIME, (s) 100 0 50 100 JUNCTION TEMPERATURE, Tj, ( C) TRANSIENT THERMAL IMPEDANCE CHARACTERISTICS (FWDi) 10-2 -50 o JUNCTION TEMPERATURE, Tj, ( C) TRANSIENT IMPEDANCE, Zth(j-c), (NORMALIZED VALUE) 12 0 0 o 10-3 10-3 13 11 10 0 474 TRANSIENT IMPEDANCE, Zth(j-c), (NORMALIZED VALUE) 15 30 -50 TRANSIENT THERMAL IMPEDANCE CHARACTERISTICS (IGBT) CONTROL SUPPLY VOLTAGE TRIP-RESET LEVEL TEMPERATURE DEPENDENCY (TYPICAL) FAULT OUTPUT PULSE WIDTH VS. TEMPERATURE (TYPICAL) 101 150 101 100 10-1 10-2 SINGLE PULSE STANDARD VALUE = Rth(j-c)Q = 2.2oC/W 10-3 10-3 10-2 10-1 TIME, (s) 100 101