Oscilent Corporation IF SAW Filter | 807-IF183.6M-A Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 807-IF183.6M-A 7.0 x 5.0 SMD Mobile Communication May 22 2003 . TYPE : 183.6 MHz Bandpass Filter 1.23 MHz Bandwidth PART NUMBER : 807-IF183.6M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units Center Frequency - 183.6 - MHz Insertion Loss - 7.0 10.0 dB Attenuation at Fo -615 KHz - 3.8 5 dB Attenuation at Fo -615 K Hz - 3.9 5 dB Attenuation at Fo -900 KHz 33 38 - dB Attenuation at Fo +900 KHz 33 37 - dB Attenuation at Fo ± 1.25 MHz 35 42 - dB Attenuation at Fo ± 1.7 MHz 33 38 - dB Attenuation at Fo ± 2.05 MHz 35 45 - dB - 50 - ohm Input / Output Impedance - 0.5 1.2 dB Ultimate Rejection 35 40 - dB Substrate Material - Quartz - - Phase Linearity at Fo ± 0.3 MHz - 1.5 3.0 °rms -30 - +80 °C Passband Ripple at Fo ± 0.3 MHz Operating Temperature * Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE L1 = 82nH L2 = 68nH C1 = 43pF C2 = 43pF Source/Load Impedance = 50 ohms FREQUENCY RESPONSE http://www.oscilent.com/spec_pages/if_sawfilter/if_807_if183_6a.htm 12/28/2005 Oscilent Corporation IF SAW Filter | 807-IF183.6M-A Page 2 of 2 Part No.: 807-IF183.6M-A Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map http://www.oscilent.com/spec_pages/if_sawfilter/if_807_if183_6a.htm 12/28/2005