Oscilent Corporation IF SAW Filter | 809-IF90.0M-A Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 809-IF90.0M-A 9.1 x 4.8 SMD Mobile Communication Jan. 01, 2007 TYPE : 90.00 MHz IF SAW Filter PART NUMBER : 809-IF90.0M-A OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units Center Frequency - 90.00 - MHz Insertion Loss at Fo - 9.5 11.0 dB Attenuation Fo +630 kHz - 3.5 5.0 dB Attenuation Fo -630 kHz - 3.5 5.0 dB Attenuation Fo +900 kHz 33 37 - dB Attenuation Fo -900 kHz 33 37 - dB Attenuation Fo +1.7 MHz 35 40 - dB Attenuation Fo -1.7 Mhz 35 40 - dB Source Impedance (Single Ended/Balanced)* - 50/1000 - ohm Load Impedance (Single Ended/Balanced)* - 50/1000 - ohm Substrate Material - Quartz - - Passband Ripple at Fo + 300 kHz - 0.5 1.0 dB Phase Linearity at Fo +/-630 kHz - 2.5 4.0 rms * With Matching Network (Ref. Testing Environment Circuit as shown below) Those impedances could be modified with different impedance values and/or structures, if necessary. ** Custom SAW IF Filters available. Contact Oscilent for assistance. PACKAGE OUTLINE (mm) TEST CIRCUIT Oscilent Corporation IF SAW Filter | 809-IF90.0M-A Page 2 of 2 TEST FIXTURE AND VALUES/SOURCE AND LOAD IMPEDANCE 50 ohm INPUT: L1: 330nH Q>40, C1: 51pF OUTPUT: L2: 242 nH Q>40, C2: 82pF FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 809-IF90.0M-A