REV BY APPD DATE DESCRIPTION REVISED PER ER7306 D 2. MATERIAL SPECIFICATIONS: COPPER ALLOY CWB CWB 04/11/08 NOTES: UNLESS OTHERWISE SPECIFIED 1. FOR GENERAL SERIES SPECIFICATIONS, SEE SD74-0000. 3. FINISH SPECIFICATIONS: .000030 MIN. GOLD PER ASTM B488 OVER .000080 MIN. NICKEL PER AMS QQ-N-290. 4. ELECTRICAL SPECIFICATIONS: CURRENT RATING: 10 AMPS 5. FOR USE WITH 16 AWG WIRE OR EQUIVALENT. 6. REFER TO CAP10-01 FOR CABLE ASSEMBLY PROCEDURE. .218 5.54 ACROSS FLATS .314 7.98 .144 3.66 ACCEPTS .275 6.99 .144 PIN .054±.003 1.37±.08 CATALOG P/N: 01432G .275 6.99 18 AWG OR EQUIVILENT PER ASME Y14.5M-1994 UNLESS OTHERWISE SPECIFIED: DIMENSIONS ARE IN INCHES [MM] TOLERANCES: DECIMAL: .XX [X.X] ± .01 [0.3] .XXX [X.XX] ± .005 [0.13] .XXXX [X.XXX] ± .XXXX ANGLES: ± 2° SCALE: 8:1 WinchesterElectronics Winchester Electronics Corporation 62 Barnes Industrial Road North Wallingford, Connecticut 06492 CUSTOMER DRAWING RECOMMENDED CABLE TRIM DIMENSIONS DRAWN PSM APPROVED XXX DATE APPROVED 03/08/07 DCam DATE APPROVED XX/XX/XX WPM DATE 05/16/07 DATE 05/16/07 POWER SNAP, RIGHT ANGLE SOLDER MOUNT 18 AWG, 10 AMP A SD01432G SHT 1 REV OF 1 D