Three-Year Limited Warranty 34170B Measurement Specialties, Inc. warrants this product against defects in materials and workmanship for a period of three years from date of shipment. During the warranty period, Measurement Specialties will, at its option, either repair or replace products which prove to be defective. Mounting Adapter for Cubical Accelerometers and Rate Gyros Exclusions This warranty does not apply to defects or damage resulting from: •Improper installation or maintenance •Customer supplied software or interfacing •Unauthorized modification or misuse •Operation outside of the product specifications Limitations The warranty set forth above is exclusive and no other warranty, whether written or oral, is expressed or implied. Measurement Specialties specifically disclaims the implied warranties of merchantability and fitness for a particular purpose. Some jurisdictions do not allow limitations on how long an implied warranty lasts, so the above limitation or exclusion may not apply to you. However, any implied warranty of merchantability or fitness is limited to the three-year duration of this written warranty. Measurement Specialties, Inc. 2236 N. Cleveland-Massillon Rd. Akron, Ohio 44333-1255 USA (330) 659-3312 www.meas-spec.com precisionsensors.meas-spec.com Warranty Service To obtain service during the warranty period, products must be returned, transportation prepaid, to Measurement Specialties. 34170B Rev. 8/19/13 How to Use the 34170B Dimensions 0.178 4.52 0.118 3.00 0.946 24.03 0.710 18.03 0.414 10.52 0.354 8.99 0.414 REF 10.52 0.134 THRU 0.288 7.30 X 90° (4) Places 0.354 8.99 0.147 3.73 THRU (4) Places 0.118 REF 3.00 0.178 REF 4.52 0.118 3.00 1.182 30.02 0.118 REF 3.00 ►Place ► the mounting face of an accelerometer on the noncountersunk face of the mounting adapter and align its mounting holes with the two holes in the center of the adapter. ►Thread ► the two 3.0 x 0.5 x 6.0 mm long socket flat head screws included with the adapter through the mounting adapter into the mounting holes in the accelerometer and tighten [recommended torque 5 lbf-in (0.56 N.m)]. ►Use ► the 0.142 inch [3.8 mm] holes to attach the assembly to the system to be tested. These holes will accept M3, M3.5, or #6 machine screws. ►A ► light film of oil or silicone grease can be used to enhance contact between the accelerometer and the mount as well as between the mount and the system to be tested. ►A ► locking compound should be used on all threads to prevent screws loosening due to vibrations. 1.418 36.02 Recommended Tools* 2.0 mm hex wrench for 3.0 mm socket flat head mounting 0.118 3.00 *Included in SI accelerometer kits Dimensions in inches [mm] Tolerances ±0.005 [0.127] Third angle Specifications** Material Tolerances 6061 T6 Aluminum ± 0.005 [0.127] **Data subject to change without notice. Units in [mm]